Having problems with your Flat Panel Televisions ?

Replace caps on power supply (15) caps. Voltages are all there but no picture. Any suggestion



Answers :

You did not mention if you had sound; if you do, then the inverter for the backlight or the backlight CCFL has failed. The inverter is often on a separate board since these are often outsourced.

Repair Help & Product Troubleshooting for Flat Panel Televisions
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

Replace caps on power supply (15) caps. Voltages are all there but no picture. Any suggestion


You did not mention if you had sound; if you do, then the inverter for the backlight or the backlight CCFL has failed. The inverter is often on a separate board since these are often outsourced. ... ViewSonic N3752w 37 in. LCD TV

I have a Power Supply Unit in Westinghouse SK-26H240S TV. TV had no power prior to disassembly. This TV has the Delta DPS-210EP-2 power supply. I appear to have proper voltage on high side, but i am not getting 24v; 12v; 5v, and 5VSB on secondary side output. The Bridge Rectifier is putting out 53V DC. The filter caps have been replaced on PSU.


... Westinghouse LTV-27w7 7 in. LCD HDTV

Samsung lnt4665fx xaa video prolbem apperas main board has been zapped visible burn marks on hdmi port 2 blue light under samsung still comes on and red light flashes and relay clicks but no audio or video replaced caps in power supply did not help should the main board be replaced? should the main board be replace any suggestions would be helpfull thanks


... Projection Televisions

Rca L32WD12YX9 power supply, f1 is out, i would replace it with a cap but idk what voltage?


Ls this part itself a filter cap or a fuse? If a cap it will have value, voltage rating and plus/minus marked right on it.Dead set or what? ... RCA L37WD12 37 in. LCD HDTV

Tv won't turn on. replaced bad caps and after some testing it turned out that the power supply board wasn't giving the supposed voltages.


This problem is not easily to be solved.Tries to changes all the capacitors components even if u think is good around the bad capacitors surrounding area.After that,if u still have the same problems.This problem could be any high voltage components p ... Insignia NS-LTDVD19-09 LCD TV

I got a Sony Bravia KDL-40WL135. Blank screen. There's two LED lights: red standby and green power light. When I turn on the TV, green led comes on, then after about 30 seconds red led blinks once, then green resumes. The green led stays solid. I think that's a SONY error code, I tried to look it up but can't find anything useful. I have replaced the power supply, AU board, backlight inverter, logical board, and the second power supply board. Any suggestions? I haven't checked the t-con bo


Http://www.smpcshop.com/KDL-40WL135-KDL-46WL135-p-8895.html\015\012\015\012\015\012\015\012Above is a link for a service manual.\015\012 ... Flat Panel Televisions

Samsung TV Model LA40A650A1M back light intermittently strobeing and sometimes cuts out completely, powering TV off via remote and back on temporarily resolves issue, but returns at various times, have removed power supply board to check capacitors - look OK none appear to be leaking. Power supply board details Hansol LCD, Rev 1.3, Manf date 11 July 08, Model SIP 408A BN44-001947A I note in some posts for similar Samsung P/S boards it has been suggested replacing specific capacitors - any su


You can't see if a cap is good or bad jus looking at them they have to be measured>They loose their capacitance because they dry overtime.I do sugest that you replace you power supply module or replace all caps.Possibily you may have a broken ... Samsung Flat Panel Televisions

I have a TH50PX60U with the red light flashing 10 times. I went through the diagnostic flow chart to where it said replace the PA and DG boards. I replaced both and still have the 10 flashing lights. SInce that flow chart didn't seem to work I started checking the feeds from the power supply. I noticed on the PA10 that as soon as I plugged in the AC, the voltage read 15V. Then the voltage started dropping fast and went down to zero. Is this normal or should the voltage remain at a cons


... Panasonic TH-50PX60U 50 in. Plasma HDTV

I have a Sanyo DLP 50747. When I turn it on It clicks off in about 10 seconds. I read online to try replacing the sub-power board(part# SJ-B10N2010A) and if that does not work then replace the power supply board (part #LJ41-05246A) both of which I purchased from Shopjimmy.com. I replaced both and it still does the same thing. Can anyone give me any other suggestions?


Sanyo plasmas have LEDs on the boards that can be used to identify the source of the problem. Are LEDs on any of the boards lit> If yes then which ones? ... Sanyo DP50747 50 in. Plasma TV

Sansui SV-3715LCD, I switch off the unit at the wall socket, when I plugged it in the next day there was no power, not even the LED indicator light on the front of the LCD activates. I checked the plug power and it has AC supply voltage right up onto the internal Switch-mode power supply board. Any suggestions


Continue to check--every set has a standby power supply that powers the remote circuit to turn set on and it runs 7/24 if set is plugged in.Never a good idea to turn set of by taking the AC away--it can cause micro problems(micro processor). ... Flat Panel Televisions

I have an element TV with a MLT070A power supply board. I'm not an electrical guy, but a technician came out and showed me the bulged caps and said that was what's wrong with the TV. He said he couldn't get replacement parts (I think the whole circuit board)but maybe the bulged cap components could be replaced by someone. I don't want to junk this TV and wonder what I should/could do. They're going to send me a $350.00 check for the extended warranty I paid 650 for the TV and 150 for the Cir


Hello,power supply board is dead, if you know basic electronics' and soldering you can handle it ? Most of the times, the power supply board just have dead leakages gases capacitors.These capacitors always bulges up on it top,or puff up o ... Flat Panel Televisions

Samsung LN40B540P8FXZA. There is a Black screen when the power is turned on. I replaced 2 circuit boards but still no luck. Should I replace the capacitors in the power supply? The ribbons between the boards? I was given this broken TV and was told if I could fix it I could keep it....any suggestions?


... Flat Panel Televisions

I have Hitachi 65f710 projection tv, that has no power, I found a thermal fuse open in the power supply, I replaced that; the Tv came on but has no hi voltage, the tv has b+ but not at HOT hight voltage transistor. what else you think can be done. Right now I have no picture Thanks


Try replacing the H-out transistor, if yours is convergence IC type, replace it. hope this help, please rate and vote. ... Hitachi 57F500 57" Rear Projection HDTV-Ready Television

I just replaced both the lamp & ballast on my LG 52SX4S (5 yrs old). The front indicator light scrolls for couple minutes, then top 2 lights turn red with second light blinking. Then the top light stays red for minute and it repeats the process. Someone suggested the power supply board should be replaced, what do you suggest>


I have had the same model HDTV and had the same issue. It was the power supply and I got it replaced at a TV repair shop for 300.00. ... LG 52SX4D 52" HDTV

Dp46480 46480 was hit by lightning. lost power, and replaced the power supply. it turns on now but the screen goes black after about 15 seconds. any suggestions or help on what i should try to replace next?


... Sanyo Flat Panel Televisions

Phillips 32PFL3403D/F7 does not power up, no indicator light. I replaced all the caps except the filter 390 ufd 250v on the power supply. No caps were bubbled. Im getting 170vdc across the filter, 2.5vdc standby and 5vdv. NO 12 or 24 volt.


... Philips Flat Panel Televisions

Replaced upper y buffer, replaced caps. on y board, and x board new power supply board now clicks and blue flashing light 5-3


... Samsung HPT5054 50 in. HD-Ready Plasma Television

I have a Panasonic plasma tv tc-p42u2 tht won't power on at all I replace the power supply board with a new one and still not powering at all no lights.. Ac voltage going in is good ... Tv went out after a storm an wont power up at all plz someone help don't what to do ..


... Flat Panel Televisions

I have a magnavox 37mf231d/37 tv will not power on replaced power supply board and still have no power any suggestions .


... Flat Panel Televisions

55HDS52 no picture no sound. no startup voltage on vsago and vcego connector on connector CN68 power supply and logic board was replaced and still no voltage. what create the 3.15 voltage on pin 2 and 3 for cn68 connector.


... Hitachi Flat Panel Televisions

I saw the fix for the blinking power light . I replaced all 8 caps on the power supply board and 2 on the input board. Now the power stays on but no image. The monitor reconises a signal from the computer but no display. What frequancy does the computer need to be set at.


Almost all monitors will accept a 60Hz signal at almost any resolution, however I suggest 1024 X 768 at 60Hz...then you can try higher frequencies such as 75 Hz or more after you have established that the unit is functional. ... Gateway FPD2185W 21 in. LCD Television

I have a Phillips 32PFL5322D/37 tv that is about 2 1/2 years old. Recently the TV stopped working. All I see is 8 red blinking lights when I try to power-up. After reading multiple threads and suggestions I replaced the Power Supply Unit but still no change in the 8 red blinking lights. I have a power aux board coming in the mail and I plan to install. I am out of ideas here. Any other possibilities? It seems everyone is having the same problem with this TV. There must be a reason.


... Philips 37PF7320A 37 in. HD-Ready LCD Television

I have a Insignia NS-L32Q-10A that will not power on. Now power on light or standby. I have replaced the power supply already. All caps look good and fuses check OK. What next???


Ok, when you plug in the set, does the power light come on? Assuming you ordered a power supply in good working order, you may very well have a faulty main board. The power supply produces standby power that the main board uses to power the standby/p ... Insignia NS-L32Q-10A 32 in. HD-Ready LCD TV

Tried replacing power supply still no power any suggestions


The set needs to be professionally diagnosed !!! Are you sure the power supply board you bought was working? If the power supply board is a good part, the you're looking at a main board issue. ... LG 42LC2D 42 in. LCD HDTV

I have a Vizio XVT553SV that powers up but nothing on the screen. The Vizio logo flashes org to white for 1.5 minutes then the V comes on the screen for 1.5 minutes. It will repeat this over and over. I tried the factory reset and it didn't work. I have the back off and no capacitors etc look bad. I could check voltages but the are a lot of wires coming from the power supply and I do not have a schematic. Any suggestions ? Thanks


That problem sir is usually cause of faulty inverter board...Try to replaced inverter board to fix your TV.. ... Vizio XVT553SV 55 in. LCD TV

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || fullblownbass.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1223 seconds