Having problems with your Combination Televisions ?

The TV is black but the fuse is good. I was told that it might be the horizontal output transistor. Where is it on that model?



Answers :

If the fuse is intact in all probability the power supply unit is OK. If your Horizontal Output Transistor fails you will hear a high pitch whistling sound . Any way its the black three legged device mounted on an aluminum heat sink near a transformer from which a Red wire goes to the top of the picture tube.

Repair Help & Product Troubleshooting for Combination Televisions
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

The TV is black but the fuse is good. I was told that it might be the horizontal output transistor. Where is it on that model?


If the fuse is intact in all probability the power supply unit is OK. If your Horizontal Output Transistor fails you will hear a high pitch whistling sound . Any way its the black three legged device mounted on an aluminum heat sink near a transforme ... Toshiba MD20Q42 20" TV/DVD Combo

I have a Zenith console TV bought in 1996 model # SY2722RK. While watching the last time it just went blank like someone had truned it off ( no picture and no sound ). I have done some work trying to figure out what it might be. The fuses are good and the power HOT section is working. The on/off relay is working correctly, but there seems to be no power getting to the flyback transformer or the rest of the tv's circuits. I did notice that the power transistor in the area of the flyback tran


... Zenith SY2722RK TV

Horizontal transistor Lools like my Horizontal Output Transistor is blown - which one is it that I can replace it - model : SV29276


The 4498 that is top left in picture, but is the transformer there burnt or just real dirty? ... Standard (CRT) Televisions

Black screen and have sound vx42lhdtv10a(vizio 42 2008)power supply is ok(12v,24v,5v) main board have 4v and all fuses is good . my question is? how can i test my inverter board output voltage?how can


... Vizio Flat Panel Televisions

Iam having problem with a konka tv model kp2905qyt. there is no EHT but 130 volt is present on collector of horizontal output transistor, pleasse help


This problem has been answered a few while ago. Check the horizotal oscillator frequency. ... Konka Standard (CRT) Televisions

Dead set ; fuse , ic regulator , horizontal output transistor , r2m diode replaced already. Still dead set.


Hi,\012\012You need to confirm where is the trouble before replacing any parts.\012\012Test the B+ on the H-out transistor.\012\012No-check the B+ on 160v electrolytic cap.\012\012If No B+ here then the trouble is in the regul ... Flat Panel Televisions

Hi guys am Suteka from Leeukop I have a Sansui TV model no:SV2918 The output voltage is 143V it keeps blowing the Horizontal transistor, How can I reduce this voltages I checked dry joints as well as swollen capacitors and some diodes all seems to be just fine. I will greatly appreciate if you may help me


... Standard (CRT) Televisions

Toshiba Model # 42H81 Power Light comes on No picture. No high voltage. Found shorted Horizontal Output Transitor. Replaced transistor. Still no picture.


What is DC voltage on "C" of transistor at turn on?SD TECH ... Toshiba 42H81 42" Rear Projection Television

Am I testing this horizontal output transistor correctly?


Check the resistance between collector and emitter. It should never be Zero Ohms. ... Symphonic Standard (CRT) Televisions

I have jvc av32150 the horizontal transistor is defective replaced it but after 2 minutes black out again


Check and replace its LOT {Line Output Trasformer}. It is faulty. ... JVC AV-32150 32" TV

TNPA4221 - Television won't turn on, fuses and transistors good


If TV is completely dead you have either a bad power or a bad main board.Talking form experience I'd go with the power board first.The alternative is to make sure the power board outputs the normal standby power to the main board and ... Panasonic TH-42PX75U 42 in. Plasma Television

Helo sir, i have a L.G T.V. Model No kf-20p32..is blowing the horizontal output..i change the flyback tranformer ,bt is still blowing the horizontal output


Check all the capacitors connected to horizontal output transistor. Especially one connected with its collector to ground. a high voltage [1.5Kv]. capacitor. Replace them. Check for any short inside the winding of the yoke. It is difficult to de ... Standard (CRT) Televisions

Sanyo 24 in flat screen model DS24425 Screen slowly goes fussy and slowly goes black , a slight tap on the rear left side brings the picture back to good screen,for a few minutes or a couple of hours no set pattern of time. When one turns the set on again some times come on clear other times very dul or black, slight tap and good screen. Sounds /act like a bad solder connection but which one do you have a wiring diagram or know where to get one? Thank you


Hello\015\012Your flat panel TVs picture tube base board has soldering loose contact with it. Just unplug your TV from AC mains socket, and open it. Pull out the picture tube base card from the picture tube neck. Pull it out straight, no sha ... Toshiba 55ZV650U 55 in. LCD HDTV

I have an Olevia 227-S11 LCD. I am not getting any output 12vdc nor 24vdc. The output caps look good. Fuse good. What else can I check


... Flat Panel Televisions

Sir I havea problem with my Sanyo Tv model St-21SF1K, when I turn the power it only blinks the led light. when I check the secondary supply the voltage is there and the horizontal out is good.


... Sanyo Flat Panel Televisions

Toshiba TV Model 32C11OU. No power. Outlet is good. Replaced Fuse on Power Supply Board but to no avail. What next?


... Toshiba 32C110U 32 in. LCD TV

I have a 52in rca big screen i as told it had a convertion problem and i might could replace a fuse now i 4got what they said about the fuse like what kinda fuse like the size


... RCA HD52W58 52" TV

My LG TV model 42PC5D has a black stripe with red blue and green lines in it. I was told that its cold solder joints but when I put pressure on the boards the problem does not go away, does anyone kno


Hello, have you checked the fuses on the y sustain board and the x sustain board to see if they are blown? If one is blown you will need to replace the whole board because if you replace the fuse chances are it will blow the control board. Hope this ... Standard (CRT) Televisions

Helo sir, i have a L.G T.V. Model No kf-20p32... the output voltage is normal. But it keep on blowing the horizontal output


ARE YOU USING A 2SD OR 2SC, CK 1MIC CAP if shorts imediatley bad flyback ... Standard (CRT) Televisions

Hi I have a Samsung LCD tv model ln26a330j1dxza the problem is that when I turn it on the screen looks black or freeze but if I move the tv in different direction the image goes back to normal but when I try to move it back the image goes black or freeze I already open the tv and the capacitors looks good so I have no clue what is the problem


... Flat Panel Televisions

I have a lg 47 lcd tv. model num. 47LD500. only about a year old when this happened. Was working fine and just shut off by it self. will not do anything at all. no sounds lights nothing. Have checked power cord and all ovious things. Remover back cover and checked fuse and all capacitors look ok. Is there any downloadable test spect. and instructions for the power board. I have a good meeter and pretty good knollage of electronics. any help would be great. Thanks


Check power supply ... LG Flat Panel Televisions

I have a vizio vp422 that made a loud pop and now doesn't have any picture or sound. When you power it on the vizio display light turns from amber to white but that's it. U have to unplug it to turn it off. I have checked the fuses and they are good. The capacitors look good visually. There are a couple on the power supply board that have a black cover over the top, so I don't know about those. I changed the main board and made no difference. Someone please help!


Replace its power supply regulator board as card basis. ... Vizio Standard (CRT) Televisions

Dear sirs I am looking for the ballast part # and where I might be able to get a new or rebuilt one for model# hd44lpw62 dlp RCA tv.Also how might I test the input and output so I can be sure of bad ballast?


Im having trouble crossing over the part you are looking for,Encompass Parts Distribution\015\012this company is only showing Lamp PN# and Color Wheel Assy PN# 1-800-638-3328\015\012PTS this company rebuilts boards 1-800-844-7871\01 ... Flat Panel Televisions

I have a Hyundai PTV421 LCD TV. Fell asleep watching a movie and woke up to a black screen. Found blown fuse T4AH250VP on left side board. What could the problem be. There are 2 fuses here....1 good 1 blown.


... Hyundai Flat Panel Televisions

Power will not tour on Samsung T220HD model. I replaced a bulging capacitor on the power supply board and still will not turn on. I also tested the fuse with an ohmmeter and the fuse was good. any ideas what to try next?


... Samsung T220HD 22 in. LCD TV

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || fullblownbass.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1143 seconds