Having problems with your Standard (CRT) Televisions ?

Tv fades from right to left on any channel or input(Xbox). After a while the tv picture lasts longer. The tv has to be on for about 10 minutes for picture to appear. Thinkin the backlight inverter but


\015 Tv fades from right to left on any channel or input(Xbox). After a while the tv picture lasts longer. The tv has to be on for about 10 minutes for picture to appear. Thinkin the backlight inverter but not fully sure. Any help would be appreciated. Thank you. \015

Answers :

You have defective capacitors on your power supply. You can tell which ones by the swelling top. Replace caps with the same value and your good to go. Should be about 10 dollars in parts.

Repair Help & Product Troubleshooting for Standard (CRT) Televisions
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

Tv fades from right to left on any channel or input(Xbox). After a while the tv picture lasts longer. The tv has to be on for about 10 minutes for picture to appear. Thinkin the backlight inverter but


You have defective capacitors on your power supply. You can tell which ones by the swelling top. Replace caps with the same value and your good to go. Should be about 10 dollars in parts. ... Standard (CRT) Televisions

When I turn on the set, the right half of the screen is distorted. It flickers, different colors move from center to far right of screen, double images that appear as negitives and sometimes that half of the screen is very dark. Sometimes it will clear up for a second or two then go back to the problem. When the problem first started, it only lasted for approx 10-15 minutes then the picture was great. Now it takes 1-2 hours for it to clear up. Once it clears, I get a great picture. The lef


Hi,Symptom shows problem with lcd panel (screen) however, t-con board that is part of lcd panel could be defective and cause of these symptoms.T-Con board is located at top center of cld panel at rear and would be covered with metal shiel ... Samsung LN46A550 LCD TV

My Sony KDL-40XBR7 has developed two problems. 1) Sometimes when changing channels the screen turns green. I can solve this by turning off the set then back on, but what's causing the problem? 2) In the past few days whenever I turn the TV on there are horizontal bands from top to bottom. They are faint and the picture can still be seen. Additionally the picture is ghosted; a second ghost image appears larger and below the original. This lasts for a few minutes then goes away. Of course, the TV


... Flat Panel Televisions

Have a Proview pa-19jk7. When you turn on the TV, the logo screen appears, then the whole screen goes blank. If I try it in a dark room, I can see the picture with a flashlight, and sound is good. I have taken it apart, and dont see any blown caps. I just dont know if its, the power supply, inverter, backlight. Are there any clues from the logo screen appearing first? Thanks!


In this the the backlighting is done this way - the power source delivers an low DC voltage of around 24 volts to the inverter board , the inverter board ups that to about 500 volts DC and delivers them to the CCLF tubes (basically some thin neon tub ... Proview PA-19JK7 19 in. LCD Television

My n3260w tv has a backlight problem. When switched on it flickers for about 25 minutes then rights itself. the left hand side of the screen is darker than the other side but the brightness comes back eventually. This problem started about a month age and is taking longer for the picture to normalise. Please can anyone advise Richard


... ViewSonic NextVision N3260W 32 in. HD-Ready LCD Television

I have Vizio XVT3D474SV I bought a year ago, in the last week while watching TV, the screen start to flash, display becaome white with 3 black lines and after a while it becomes black (the all time the sound stay as normal). while looking inside I see the backlight flashing till the screen becomes dark (than I do not see any light inside). After turning off and ON the TV several times I get back normal pictures but the same phenomenon comes back in few minutes. I checked all 8 micro fuses I have


When the picture is dark, show a torch light on the screen from a safe distance. If you can see the picture, the backlight is the problem. Anyhow, it is better to show it to a qualified service technician. ... Vizio XVT3D474SV 47 in. 3D LCD TV

I am having problems with my Sony Bravia LCD tv model KDL-32L4010. When first turned on the picture looks good for about 30 seconds, then develops white vertical lines. After about 3 minutes, the lines fade slightly and the picture becomes more washed out. There is about 1/2 inch of good picture at the top. After, about 12 minutes the picture is no longer washed out but seem to have low definition. After about 20 minutes the picture begins to jitter vertically creating a double image. The menu


... Flat Panel Televisions

I replaced the inverter panel on my 40" proscan tv but still have no picture and no backlight


... Proscan 40LD45Q Full HD 40 LCD TV

I have a RCA l32hd35d version A I can turn it on and it comes on and the backlight goes back out. The rest of the tv works and it has a picture if you look at it close. Just no back light. I have replaced the inverter and the problem is still the same. The blon pin on the inverter has 3 volts on it even after the backlight goes out The 24 volts is still there too you can keep turning it on and off and the backlight will stay on. any help will be great...


If you have 24vdc feeding the inverter board, the next signal you need to find is the BL_ON SIGNAL which will turn on the inverter board, it should be 3.3vdc or 5vdc on that pin (pin 12 on CN1 of the inverter board), see picture here:\015\012 ... RCA L32HD35D 31.5 in. LCD HDTV

I have a Vizio VW32LHDTV10A that produces sound but no picture. I have checked the main power board for 24v to both backlight inverters and 24v is present. I then hooked up both backlight inverters and turned the TV on and the blue LED on the Slave inverter comes on, but goes off after only a few seconds. What further tests could I perform to check which part is defective or what component is the most likely cause?


When you reconnect the inverter boards, when the LED goes off on the inverter board, do you still see 24vdc? You shuld also ty hooking up test lamps to the 24vdc to see if it will stay on.\012Right now I have a feeling the problems are in the b ... Flat Panel Televisions

Our tv is about 3 years old. We are a Time Warner cable customer. About 2 months ago we started to notice that the picture took a ong time to appear after turning on the set. The sound played for about 5 minutes before a picture appeared. Now the sound and picture are both gone--not sure if tv,s are repaired or thrown away these days as everything is designed to require quick replacement.


I'm sure this is fairly easy to repair. It sounds likely to be a power supply problem, possibly due to bad capacitors. Your original symptoms of no picture were likely to be the backlight controller not having sufficient power to operate correctly. I ... LG 32LC7D Television

I have a DP46848 LCD HD TV, over a year old. The picture appears to be made up of several individual panels, maybe 12 or 16. Anyway, after it has been on for 5 or 10 minutes, parts of the picture get darker. No gone, can still see it, but very dark. Seems to be the bottem 2/3 or 3/4 of the screen and only the left 2/3 most of the time. This comes and goes for maybe 1 or 2 minutes, then it is OK from then on. It will occasionally do this again later, again for a minute or 2, but normally just the


Hi crwalke,\015\012\015\012This symptom indicated of bad filter electrolytic capacitor in the output of the power supply feeding the LCD controller board and the inverter boards.\015\012\015\012This capacitor i ... Sanyo 42 in. LCD TV

Black and white static on the picture; 2 minutes later, the normal picture appears. Cycle repeats.


Sound like what happened when my lamp went out of my projection tv. ... Hitachi 53UDX10B 53" Rear Projection Television

My Hitachi 60VF820 will works fine but after awhile the picture goes out ( black screen with voice ok). Some times it takes 30 minutes of watching and sometimes last 6 or 7 hours. I do a hard reset and after 30 sec. plug it back on and the picture will last all day. And there are times I have to wait 15 to 20 mins. to restore. What can be the problem?


Its a DLP, when was the lamp replaced last---I am not saying it is the lamp but want to know when last replaced and if with a Hitachi lamp. ... Hitachi UltraVision 60VF820 TV

SONY KP-48V85 Rear Projection TV has double/shadow on picture after TV is on for about 2 minutes. The picture is ok when you first turn the TV on, but then the double image appears after a few minutes and does not go away.


... Sony KP-48V80 48" Rear Projection Television

Vizio VT470M no picture, no sound, no backlight. Power supply board looks good all voltages appear correct (24V, 5V, and 3.7V) and no "bulged" capacitors . When I unplug unit for two hours, the screen comes on normally backlight comes back up and picture is normal, but changing the channel causes it to go dead again. Bringing up menu with remote is really sluggish and when attempting factory reset, it goes black. Vizio light on the front of the TV comes on and off when pressing power button,


Im having similar problem and with my limited knowledge of lcd tvs and the voltages ALL being good except the pwr on or sw on voltage from the main board to the power supply which tells it to switch everything on Im guessing that something is going w ... Vizio VT470M 47 in. TV

I have a Samsung HP-5064 plasma TV. Over the last month, it occasionally would have sound but no picture when you turned it on but the picture popped on after 2-3 minute. I now have no sound or picture. I unplugged power for a while and than plugged it back in but still no picture or sound. What are my possible problems? Doug


This is typical with many sets as there is a high possibility that the components over a period of heating and cooling , tend to bring on a problem of dry soldering. So my advice is to check the set for some loose joints that have pla ... Flat Panel Televisions

I have an insignia ns ltdvd26 lcd tv. The problem i am having is the picture. When i turn the tv on... the picture is normal...then display freezes and slowly the picture will fade to black. If i leave the set on....occassionally the picture will come back on for a few seconds then fade to black again. The backlight still appears to be on when the screen fades out.


Good day!If your problem is pictures fade on and off...There are some points to consider like \015\012\015\012loose connectors on the power supply,main boards and inverter board ----reconnect a ... Insignia NSLTDVD26 LCD TV

I have a 22 inch AOC Envision LCD TV. When I first turn it on, only the top half of the screen displays picture while the bottom half is a gray/black color. If I wait about ten minutes or if I tap on the back of the TV, the picture is completely restored and I can watch everything just fine. However, it is pretty annoying to wait for the picture to come back. Since the picture does come back after a while and looks fine, I don't think I have a broken backlight or anything like that. Also, becaus


There is some loose solder terminals at the vertical scan output section at printed circuit board. If you are handy in electronic circuit boards, loacate the vertical output section, resolder all the suspected solder terminals there. This must sure ... Standard (CRT) Televisions

When I turn on my WS65611 rear projector TV the picture comes on perfect but after a minute it starts going static then the picture will come back on then it goes stactic. This continues for as long as the TV is on. When I get the menu to appear on the screen, the picture will stay perfect,, however the menu screen is in front of the picture.


A few things you could and should try, try something on a different input if you are using the coax connection just to know if problem exists that way, could be a bad tuner but that can be got around, also if on all inputs the set does have a hard r ... Mitsubishi WS-65611 65" Rear Projection Television

Tv stays on for 15-20 minutes and then picture blacks out, Can't turn back on. Unplug and plaug in again but still only last 15 - 20 minutes. new lamp, no difference.


... Hitachi 62VS69 62" HDTV

About my changhong flat tv, no picture appear after a minutes.


... Flat Panel Televisions

I have a Phillips 42PF9966/37 Ambiant Plasma TV. This TV is about 8 years old. When you first turn the TV on the picture is fine and you have sound. After anywhere between 5 and 15 minutes of being on you will start to get green and red dots appearing accross the picture where images used to be. This continues until the entire screen is basically green and then it starts to turn black. At this point you really can't see any images on the picture. Sometimes you can turn it off for a cou


... Philips 42pf9966 42-inch Hd-ready Flat Panel Plasma Tv

I have an older Mitsubishi TV, model VS-50605, that has been giving me problems. I am not able to consistently get a picture and/or sound through cable. All my other inputs work properly. I can play my Xbox on it and my DVD player works fine. Every now and then I get sound but no picture. On the rare occassion I get a picture through cable, it only lasts about 15 minutes at the most and then it cuts off. I've tried switching between ANT-A and ANT-B but had no luck resolving the issue. Any sugges


U have a pay boxes from those Telicoms,cables or satalites compannies?Yes,tries unplug,replug those boxes back about an hour later for it softwares to updates it softwares,should solved this problems or if not trade it in for a new box. ... Mitsubishi VS-50605 50" Rear Projection Television

I have a Thomson 30LCDB03B When I start it after a day of rest, the picture appears. After 10 minutes the picture disappears. When you restart a white flash occurs a split second and then I have no picture, sound works perfectly. Thank's.


Sounds like a back light problem could be an invertor or screen ... Thomson 30LCDB03B 30 in. HDTV

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || fullblownbass.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1736 seconds