Having problems with your Standard (CRT) Televisions ?

I want to connect my computer to sony wega triniton kvxr29m80 from the hdmi or vga port to the tv's component or 3rc ports. is it possible..i have tried the hdmi to component cable and it does not work. how.should i go about?



Answers :

An HDMI to component video cable will not work. These are meant for projectors that work with computers and have only component in jacks.

You will need is a VGA to Composite video converter, VGA to component video converter or HDMI to component video converter. These translate the computer output to the input the TV will understand. Here are some VGA to component video converters: http://www.ramelectronics.net/audio-video/video-converters/vga-rgb-hv-to-component-video/c10000-c11200-c11215-p1.html . (The exception is if your computer has a TV-out port. In this case, you need an adapter that looks like an S-video plug that will then have composite or component video jacks.) If you want to use the TV speakers, you will also need a 3.5 mm to 2 RCA audio adapter (either M and F/F for an RCA cable to the TV or F to M/M for a 3.5 mm audio patch cable) or cable (3.5 mm M and M/M RCA).


I hope this helps.

Cindy Wells
(A computer gives RGB output on the VGA cable; the TV reads PbPrY on the component video. Thus you need for the converter rather than a simple adapter. Similar communication differences apply on the HDMI signal.)

Repair Help & Product Troubleshooting for Standard (CRT) Televisions
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

I want to connect my computer to sony wega triniton kvxr29m80 from the hdmi or vga port to the tv's component or 3rc ports. is it possible..i have tried the hdmi to component cable and it does not work. how.should i go about?


An HDMI to component video cable will not work. These are meant for projectors that work with computers and have only component in jacks. You will need is a VGA to Composite video converter, VGA to component video converter or HDMI to compone ... Sony Standard (CRT) Televisions

Today, while watching tv on the Dish, tv suddenly started powercycling. I unplugged it, waited, and then tried a DVD -- worked fine. Tried Dish again, power cycled again -- on off on off, 1/2 second of picture, no sound, struggles until I unplug her. It's an LG 47LD520 5 months old. Dish network through HDMI, DVD through red / white / yellow. Tried Dish though component cable, still power cycles. Tried all HDMI ports, too, same thing. Brought in my old tv and hooked to Dish thou


If you are using a powerstrip may not be supplying enough power to run the LG HDTV and your HD receiver. If you are using a powerstrip make sure the receiver is plugged directly into the wall. Otherwise this may be a grounding issue please reply if t ... LG 47LD520 47 in. HD-Ready LCD TV

Im trying to hook up my first gen 60g ps3 to my sharp lcd monitor, pn-455. im using hdmi for my ps3 - dvi for the monitor. all i get is a black screen. i've tried doing a hard reset and still nothing. if i use the component cables for the monitor it works but the picture is not 1080i. if i hook up the monitor to my laptop with the same hdmi-dvi it works with my laptop. why doesnt it work with the ps3?


... Sharp PN-455 45 in. LCD Television

Some kind of weird hdmi surge took out my cable box hdmi output, the hdmi through my onkyo receiver and Mitsubishi wd-65c9 tv. Everything else associated with the components works fine. I tried all the normal stuff including unplugging and initializing the tv. No go. leads me to DM board? After initialization the tv will recognize a connection on hdmi-2 and 3, but will not work. The hdmi-1 port nothing. That is the one the surge came through (the one hooked to the receiver). Would like t


... Mitsubishi WD-65C9 65" DLP HDTV

I have a Samsung PN50B650S1FXZA and the HDMI inputs do not work.The component video and RF coax inputs work. Tried different HDMI cables and different devices Blu Ray player and Cable Box.


... Samsung FPT5084 50 in. Plasma HDTV

I have an LG LCD TV...model #52LD550-UB.AUSMLFR. Was working fine last night, turned on this morning to a massive white screen. It still has sound, just on a white screen. I turned on the surround system and have picture on that using the AV1 component, but nothing when using the HDMI1 component. Tried changing the cable, thinking it was the HDMI cable that went bad, with no change. This TV is only one month old. Help!


... Flat Panel Televisions

Got an lg 50pc56 tv one day used it hdmi worked the next day it didn't in both ports tried new cable and still nothing and tried component using a scart lead which then works so i know it is down to the tv some how


... Flat Panel Televisions

None of my component inputs are working i have hdmi hooked in for cable, a computer hooked in to the computer jack, and they all work fine. i tried my xbox 360 in every available input with the component cables and get no picture or sound i have used multiple sets of cables


Did you switch the Xbox HD switch to the off position? ... Sharp LC-C4654U 46 in. LCD TV

Sylvania LC260SC8 LCD TV has no picture. It displays white & black vertical lines on the middle to left had side of the TV. Audio still works fine. I swapped out HDMI cables, tried using the component inputs, hooked the co-ax to the TV instead of the cable box, tried 2 different video inputs all with the same issue - no picture, only audio works. Is there something that can be done to fix the TV? I love this TV. It's only 3 years old. Thanks for the help.


... Sylvania LC320SS8 32 in. LCD Television

Sanyo LCD Television Model # DP32649 TV will operate great for (1) or (2) weeks, then make a single poping noise and the screen will go blank for a second or two, and then back on and work great for another (20) minutes and then do the same thing over and over again, then as quickly as it began it will stop for another (1) or ( or (2) weeks, then it will start the same thing again! Brighthouse cable has replaced all of components, DVR, HDMI cables,as well as trying using RCA leads ins


I have seen similar problems but not this specific one. I would say that 90% of the time the problems are caused by a dry joint (that is a soldered joint that is not connecting properly) on the power board. Dry joints almost always occur where there ... Sanyo Flat Panel Televisions

Trying to hook up my ps3 to a panasonic cinemavision PT-47WX42 with an hdmi cable through the back component connections. I am getting sound but no picture. Any ideas for help?


... Panasonic PT-47WX42 47" Rear Projection Television

I have a LG 32LH30 TV. When I power on the TV I get a picture in the top half of the screen and vertical lines in the bottom half. Also I get a thin white dashed line across the middle of the screen. After about 10 minutes I get full screen picture. However the top third of the screen is lighter than the bottom two thirds. I still have the thin white line across the middle of the screen. I am using HDMI cables from my cable box. I also tried Audio/Video and Component cables. I took the back


... LG 32LH30 32 in. LCD HDTV

I bought a Phillips DVD and am trying to connect it to the tx32lxd70. I have sound and no picture. The DVD has no HDMI so I am using component video jacks and audio cables. Everything is plugged in properly.....


Hi,Component video will work if you turn On Progressive Scan function in dvd player. Usually P-Scan function can be turn On through Menu or some dvd players has push button on front panel.If your dvd player does not have push button for P ... Panasonic TX-32LXD70 32 in. HD-Ready LCD TV

I have bought a Panasonic Viera vt25. I am unable to get my philips home theater system to work. I have tried using HDMI and Component Inputs still no audio.


... Panasonic TCP50VT25 50 in HDTVReady Plasma TV

Trying to connect my Hitachi 53sdx89a with the hdmi cable with component to my set box and get no picture


Best try regular component cables as this model does not have or support HDMI ... Hitachi Projection Televisions

My tv shows pink hues where there should be white and people's faces have odd glow to them. I can correct this mostly by adjusting the color temps. I've tried both HDMI and component cables


... Vizio L37 Television

Trying to get High Def - Seiki SE551GS 55"led hdtv,1080p,120hz,3-hdmi,pc,1-component,1-composit


... Seiki SE551GS 55"led hdtv,1080p,120hz,3-hdmi,pc,1-component,1-composit

I have a technisat hdfv desk top box. I have been trying to connect in via the hdmi connection. I keep getting the message mode not supported. It works fine via the scart connection. I have tried changing the hdmi cable but still get the same message. I know the hdmi connection on the tv is ok as I can run a blue ray from it. Took it back to the dealer they tried and got same message. They thought it could be a fault with hdmi on the box. The unit was exchanged. Tried again but still get the sam


You might want to see if a firmware upgrade exists for this issue in the Samsung set you have. ... Samsung Flat Panel Televisions

I have a VSX-920-K Pioneer receiver, a DV-220KV-K Pioneer DVD player, and a Sony CRT TV with no HDMI input but only a video component input. I connected the dvd player to the receiver using an HDMI cable (for audio) and a video component cable (for video) as shown in the receiver's manual. I connected the TV to the receiver using a video component cable. I have set the HDMI Control option of the receiver to "OFF" to enable the selection of the HDMI input in the Input Setup Menu of the receiver b


... Pioneer Flat Panel Televisions

Ijust purchased an LG G2X with HDMI output i have a NS-CD47HD-09 LCD with 1080p its only about 2 years old...I went to plug in the HDMI to HDMI1 in the back and plugged in the micro end to my phone under HDMI settings it could not automatically read the resolution that is supported(which works on every other tv tested) so i manually chose the 1080p icon...(tv monitor does not support):/ hmmmm thats what i paid for. so i tried 720p same 576,480p same thing on all HDMI ports please help!! i tried


... Insignia Flat Panel Televisions

This RCA L26HD31 TV has always worked fine in other respects... but when I try to connect my pc's hdmi cable to it for use as a monitor, I just get "unusable signal". When this TV was made, hdmi outputs on laptops was not the norm - it was vga. Can this TV use an hdmi signal from a dell laptop? Yes, I'm using the correct input for the TV and have tried hdmi1 & 2 ports. - Thx


Make sure you have set the laptop's display properties to as low a resolution as possible (also make sure the screen refresh rate is 60 hertz) and turned it off before connecting it to the television. Turn the television on first and set to the corre ... RCA L26HD31 26 in. LCD HDTV

I have a kde-50xs955 sony plasma tv and now hdmi port stopped working. tried with new hdmi cables but no luck. cut power to reboot still not working. tried different devices and wont show it is even connected to hdmi


HI:\015\012You need to replace the analog board assembly, this is the board that you plug connections into, seems the HDMI port has malfunctioned, there may also be a problem with the main board assembly that the analog board connects to. ... Flat Panel Televisions

The HDMI components on my Panasonic Cinema vision do not work. All I get is the sound. The standard input components work just fine tho. How can I get the HDMI components to work properly?


... Panasonic Projection Televisions

I have connected hdmi cable to bush 32 inches tv to my dell 1525 laptop it says no signal i have tried in all the three hdmi sockets but couldnt get the solution and i have tried my friends laptop its


... Flat Panel Televisions

All HDMI ports stopped working. Component, Av etc all work fine. TV is a year old . Wife was watching and it just stopped. VCR worked, CATV worked after hooking to component ports. Is there a reset fro the HDMI?


Talk nicely and it will come your way. ... LG 47LH40 47 in. LCD HDTV

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || fullblownbass.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0828 seconds