Having problems with your Flat Panel Televisions ?

Had a power surge on this tv model klv32s400a, no standby led completly dead. Have opened and checked the power supply as far as I can, supply is present on primary side of transformer but not getting to secondary side I need circiut diagram or perhaps you can tell me what else I could check. PS nothing looks burnt or short cicuit that I can find so far. Regards Anthony

Answers :

Repair Help & Product Troubleshooting for Flat Panel Televisions
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

Had a power surge on this tv model klv32s400a, no standby led completly dead. Have opened and checked the power supply as far as I can, supply is present on primary side of transformer but not getting to secondary side I need circiut diagram or perhaps you can tell me what else I could check. PS nothing looks burnt or short cicuit that I can find so far. Regards Anthony

... Sony KLV32S400A 32 in. LCD TV

40 inch ktv model ltw40eh1b. When plugged in the light the blue light will come on but when I hit the power button I hear a multi note tone and nothing else will happen. I can unplug it and can go through the process but same result. I have heard that it may be the media board and also have heard that it may be the power supply. Tthe thing is I cannot find a wiring diagram or also where I may be able to purchase these items. Any help would be greatly appreciated. Thanks

... Flat Panel Televisions

Sony kdf60xbr950 Having the same problem with no picture. Green lights blinks first then the red lamp light. My first thought is the lamp. Then I had talked to a tech and he tried to tell me that its the balist or the power supply and likley not the bulb? Has anybody else been throught this and what was the outcome. This is the original bulb with only about 1000-1500 hours on it ? was working fine one day and the next this ?

The problem here with the lamp is it has an average 2,000 hour life--only way for a "tech" to know if it is the problem is to replace it.The ballast is the power supply for the lamp---lamp goes bad a lot more often than the ballast= sounds li ... Sony Grand WEGA KDF-60XS955 60" Rear Projection HDTV

I have a Power Supply Unit in Westinghouse SK-26H240S TV. TV had no power prior to disassembly. This TV has the Delta DPS-210EP-2 power supply. I appear to have proper voltage on high side, but i am not getting 24v; 12v; 5v, and 5VSB on secondary side output. The Bridge Rectifier is putting out 53V DC. The filter caps have been replaced on PSU.

... Westinghouse LTV-27w7 7 in. LCD HDTV

Hi In reference to Nec Model PX-42VM2A Power Supply Part Number PKG-1719 Transistor Q4 Defective Part Number on Transistor appears to be B1229 do you have a exact cross reference that will work for this part.My research indicates it may be 2SB1229 the case is TO 92 lead configuration B C E.I am finding it is very difficult finding this part.If possible would appreciate a diagram or a partial diagram of the power supply. Please Help.Thank You James Birdsall

James, \015\012\015\012Unfortunately, NEC does not make service manuals available to the general public in most cases. The B1229 is most likely the 2SB1229 as you suspect. Perhpas more important is to try and determine why the transisto ... NEC PlasmaSync PX-42VP2A 42 in. Television

Toshiba 40rv525rz shut off while playing xbox. When it shut off i could see a small white line on screen then went black. Tryed to unplug it for 5 minutes and would not turn back on. All it was doing was flashing the lit toshiba emblem up and nothing else! Talked to a couple of people and they told me it sounds like a power supply problem! So opened up the tv and saw that the power supply had a burnt resistor and there was also sut on the backlight inverter so i ordered a new power supply and in

... Toshiba 40RV525R 40 in. HDTV

Hi I have an LG 32lx28ZE television, excellent up till last weekend when it just died, power in is ok, but will not power up, think its the power supply board, is there anything else I should do before I get a new power supply?

Hi,Your power supply board is dead, do you know basic electronics' and soldering? Most of the times, the power supply board just have dead leakages gases capacitors.These capacitors always bulges up on it top,or puff up on it top.Replaced ... LG Flat Panel Televisions

Led24a45rq hi, i have this rca led24a45rq that won't power on redb led light constant on, i have 12v coming from power supply to the main signal board could it still be power supply problem or main signal board tell me what you think it could be. or could it also be the back light inverter

... RCA LED24A45RQ 24 Class LED HDTV - 1080p, 1920 x 1080, 16:9, 800:1 Dyn

Hi, Can anyone recognise or diagnose this problem we are having with our Samsung LA32A450 LCD TV? It wont power up, no power on lights. Switch on side of TV wont turn on. Remote wont power it up. This may be the key ..... My wife tells me that my 3yo was playing with the remote & the buttons on the side of the TV Would there be any strange combination of buttons pressed that could have rendered it useless? Could close proximity remote activation have caused anything?

Hi g_coopster,\015\012Samsung LA32A450 LCD TV wont power up or no power on lights that indicated that no power line.\015\012First of all, check the power line, cable AC cord is it installed properly, change ac cord if necessary. If you ... Samsung LA32A450 32 in. HD-Ready LCD TV

SIr i have a DFX 5959 Onida DVD player it's power circuit diagram was burnt i wnt to repair that circuit so please give circuit diagram for that power supply diagram of DVX 5959 onida am expecting this shortly

... Flat Panel Televisions

Dynex 47 My Dynex TV stopped powering on. I was told it could be the power supply board cause the indicator light was not on red or turning green when you tried to turn the TV on. I installed a new power supply board, and i'm still not getting any picture or light indicator. What else could the problem be?

This is exactly why I tell people that when your set isn't working, you have to have it properly diagnosed. Chances are you have a defective main board. The power indication is an indication that you have standby power. However, the power indicator i ... Flat Panel Televisions

Television Tv stuck in standby front led blinking only.Once the front led is blinking will not stop blinking by switching off with remote or side contol on tv. The only way is by removal of mains plug. Power supply used is Vestel 17ips10-3. Will change power board if this fault is caused by faulty board. Can anybody in the know confirm that the fault as explained is likely to be caused by a fault in power supply board.

... Flat Panel Televisions

My thomson ctv 25inch .my problem is power off.not working of power supply .my ctv model no is 25dk91xd.you help me.you give me this cir kit diagram with fault finding .you help me.

... Standard (CRT) Televisions

INSIGNIA 26" LCD TV - MODEL# NS-LCD26F. The Power Supply in this is Ad151m24-3n1. I purchased this not working and found that somebody else had been working on the capacitors, so I'm not sure of the original values of the capacitors. Could somebody please list the orignial electrolytical values for this power supply?

... Insignia LCDTV26 26 in. Television

Samsung CS 29 K44 ME , tv power supply not working , in that circuit board the STR and the ZENOR DIODE were burst due to high voltate power supply, please given the same model STR and the ZENOR DIODE no with full circuit diagram

... Samsung CW29M64NS 29" TV

What is the value of ZD1, ZD2, and ZD3? i know they are 22v or 27v but what else do i need to know to order from digi-key? i have the service manuel with the schematic on page 29 of the power supply. also what about the regular diodes? 27" Akai model number: lct2715 power supply: HY342-5991-09C already ordered the caps. Have all the values if some one needs them. also the ZD3 is missing? any idea why it would be missing?

... Akai LCT2715 27 in. LCD Television


OK, that IC is SG6841SZ.\015\012\015\012DELL 1704FPTi REV. A02 ... Flat Panel Televisions

I have a Sharp Aquos # LC-45GD4U. When I connect to the outlet red light starts blinking and pauses. I already changed the power supply and there is still no change. In the power supply i measured pludg p 7901 pin 7 , and it measured 6 volts no where else is there voltage. Can anyone offer a solution to my problem

If you have that 6 or 5 volts, that is your stand by, so power supply should be ok. I would think the main board,, check out these guys http://www.shopjimmy.com/ , you can call up and talk with a tech also there. I wouldnt think that the invertor wou ... Sharp Aquos LC-45GD4U 45 in. LCD HDTV

Hi I have a power problem, with my Sony RDR-HX717 DVD Recorder. I have no power at all in the display or anywhere else in my recorder. I suspect it could be the fuse, on the power supply board, which is a Newton Power NPS-51AP. The fuse is a T4AH-250V. My question is - what is the best way to replace this fuse, as it is in a closed fuse socket, which is not easy to open? Thx for any help. Fritz Diedrichsen

... Flat Panel Televisions

No power I have a LG 50PG20 Plasma. It does not have any power. I changed 5 capacitors that were bulging on the power supply board 10v and 50v. I tried to power it on with no results. I looked at all the capacitors on the other boards and they seem to be fine. Is there anything else I can look for that can solve this issue. Thanks

When the caps got real bad they may have taken another part on the power board---also see if any of the foil traces on the bottom of the board were damaged by the caps---some will actually leak a material that can eat the board foil off.Short ... LG Flat Panel Televisions

I have a Sanyo TV #DP46848 that has no power. I have replaced the power supply with no results. Do you know what else I can try?

This is a common problem with Sanyo televisions. This is a faulty main board and it gets even worse. Sanyo does not use a standard main board in their models. You will need to look at the main board (this is where your HDMI cables plug in) at the bot ... Sanyo DP46848 LCD TV

Pdp 6010fd replaced power supply. Both red and blue led stay on and do no respond to on/off commands from right side panel. The power led reacts to maim power on -off cycling. I have service manual on order. Whew. Not such a good deal after all.

... Pioneer PDP-6010FD 60 in. Plasma HDTV

Vizio vp322 No power, no amber light. Replaced power supply board still no power, What else can be affecting this tv?

Hi the first thing I would ask is are you sure that power supply that you bought is good? If you are sure your power supply I would check the power filter that connects the power cord to the power supply to make sure there is voltage getting to you ... Vizio VP322 32 in. Plasma TV

I have the Samsung 46 in LCD TV LN46A650. I noticed the other day the left side of my screen was darker than the right side and there was also a pink hue to the left side. This only occurres when I turn the unit on. the only way to fix it is to unplug the power supply from the TV

If u unplug the tv power supply source and replug it back in the tv problems it go away?Yes.The power supply board is the source of the problems,it have dying capacitors parts.U have all the tools and understanding basic electronic also can do basic ... Samsung LN46A650 46 in. LCD HDTV

Soyo PWR0502204001 Power Supply Backlight Inverter Wire diagram

... Soyo Flat Panel Televisions

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || fullblownbass.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1091 seconds