Having problems with your Projection Televisions ?

Sony KS-60R200A Bravia SXRD not switching on. the standby red led light blinking in intervals of 4. initially it would switch on after you switched it off and left it for a while, now it refused. Please assist what could be the problem. I have replaced the light but unfortunately with a fake could this be the reason???



Answers :

Repair Help & Product Troubleshooting for Projection Televisions
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

Sony KS-60R200A Bravia SXRD not switching on. the standby red led light blinking in intervals of 4. initially it would switch on after you switched it off and left it for a while, now it refused. Please assist what could be the problem. I have replaced the light but unfortunately with a fake could this be the reason???


... Sony KDSR50XBR1 50" Projection HDTV

Samsung 61 Service Model: HLP6163WX/XAA Model: HL-P6163W Samsung DLP with flickering and partial freeze frame upon start up persisting for about 10 minutes before picture (from any signal source) will resolve and then operate properly for as long as the set is left on. DLP bulb recently replaced and does not appear to be the symptoms of a bad color wheel. Could this be a light engine issue? DMD issue? light tunnel issue? ballast issue? Not sure how to trouble shoot... please help...


If using a cable or sat box try a DVD etc when set cold, a box can cause lockup issues via signal.Not a color wheel is correct, more likely a DMD which is rather pricy and almost as much as the entire light engine which comes with it. ... Samsung HLP6163W 61" Rear Projection HDTV-Ready Television

Replacing light fan on Mitsubishi WD-Y65 after getting error code 42. I had gotten the good old "TV will shut down in a few seconds. Please check if the air flow is blocked," message a few weeks back and the TV shut down. Called Mitsubishi and they sent out a replacement thermal sensor under the recall. A week later a tech showed up, replaced the part, and the TV would not fire back up. The tech left saying he needed to check some things back at the office and would get back with us. He could n


... Mitsubishi WD-Y65 65" HDTV

Kdf 50e2010 I changed my Tv lamp but still red indicator light blinking could you please tell me what is the reason?


... Projection Televisions

Please help,I have a panasonic lcd tv model-TX-32LXD1 8yrs old.I left it on standby with red light on,I switched the tv on by the power switch the red light went out but thier was no click like when i


Not knowing any more than what you've said, an 8 year old tv is bound to have problems. LCD televisions just don't last the same as CRTs used to. If you feel the need to repair, a past/known issue is a great start. Still, you might rethink repair and ... Flat Panel Televisions

Hello, I have a maxent mx50x3 when i turn it on there is a steady green light for power and the left and right boards also have stesdy green lights, I here all relays click and the screen primes,I think cause it lights up slightly but evenly..I hear a buzzing coming from the board on the left as you look at the inside from the rear and after a few minuets you can see flashing rainbow lines horizontaly across the screen...but no menu will pop up and no picture ..please help..


Hi,\015\012\015\012I am sorry to hear regarding the same. Unfortunately, this is an internal problem and TV needs to be repaired. It is highly suggestive of power supply board, however as you could see colored lines, it could indicate a f ... Maxent MX-50X3 50 in. HD-Ready Plasma Television

I have a Hitachi 43FWX20B. I can see the red is not lined up with the blue and green on the far left side of the screen. Only the red and only on the far left side of the screen. Blue and Green are OK. I tried the Magic Focus, I get a error code 5. I tried manual Focus of the red on the far left of the screen. I can ont move the red. Do I need to replace the Convergence Chips? Or could this be a bad resistor? If so, witch one. Please Help..............


Please do us a favor and rate this by cliking the thumps up icon located here >>>>>>Projection TV sets have ... Philips Magnavox 9P6034C 60" Rear Projection Television

I have anew Sony 40 inch EX 520 series Led warranty not valid in India since purchased in Bangkok. The power standby light goes of very often and the Tv goes dead. If I switch off the power supply for couple of minutes and switch it on again the stand by light comes back on and TV functions normally. The TV is also very sensitive to voltage fluctuations and on Inverter power supply. Please let me know what could be wrong and how to solve this problem. Thanks


... Flat Panel Televisions

Upon arriving from work today, I noticed that the "red power light indicator" was flashing periodically in intervals. I tried to turn the set "On" but the TV does not want to turn "ON". Could you please suggest any ideas to what could be the cause of this problem. Thank you.


Unplug set and plug back, the blinking power light is a error code, watch it carefully, a sequence of three blinks, pause and three blinks is the most common, it is SHORT PROTECTION. Five blinks and a pause and five blinks is short on 1 ... Panasonic PT-53TW53 53" Rear Projection HDTV-Ready Television

Alba lcd42880f1080p The stand by light on the TV is on and when I go to switch the TV on the light goes out but then comes back again on but there isn't any picture. Can you please tell me what the problem could be ?


... Alba Flat Panel Televisions

I have 50 inches plasma Hitachi TV (ALiS 1080HD). As the TV was on, the screen stopped showing (no picture) and no sound could be listened as well, without any reason. The power light started flashing (on and off) so I turned the TV off from the power supply (as the remote control was not responding). Few seconds later when I turned the power supply back on for a moment I heard a sound (making me believe that the problem was fixed) but once again the power light started flashing with the same en


... Flat Panel Televisions

I have a techwood tw4205 plasms tv, however the box turns on and the light goes green as does the light on the tv but no picture comes on what could this be please


I see so many here with no sound/nopicture issues:ISSUES: 1. IF sound main fuse/s are good.2. If no power or standby check main fuse, standby power supply and any signsof damage you can see---burnt parts etc.3. almost all thes ... Flat Panel Televisions

Mitsubishi WS-55809 tv has a 2-3 error code, what do I need to check. I previously had a 2-2 error code and replace the two pico fuses and the two convergences. When I put it back together it powered up and could see it was working on the screen and after about a minute or two, two lights lite up with the exception of the red and then set shut down and just has a clicking noise. Could you please tell me what to check next?


... Mitsubishi WS-55809 55" Rear Projection Television

Hi, I've been using my Samsung HLR 5087 DLP TV since 2004. Right now, if I turn on the power, the buttons light up as usual and the smiley face shows up on the small circle display. But the problem is the screen won't turn on at all.. Is it just the Lamp replacement that could be the problem?? Im debating if i should try and fix the tv or not.... PLEASE HELP....


... Samsung HL-R5087W 50" HDTV-Ready Television

I am looking for the user manual for the Jolly 4 universal remote control. Could you please assist me? Kind regards Tim


... Flat Panel Televisions

My Sony FWD 50PX2 stopped. No power indication , No Green or Red Light, only Tik tik hicupping sound heard fromn inside like relay sound continuably. What could be the problem Please help


... Sony FWD-50PX2 50 in. Plasma Television

Good afternoon, Sirs! I bought an LCD TV Sony KLV-32S200A four years ago. Yesterday the TV didn't turn on. The standby light blinks 5 times and pauses for 2-3 seconds, then blinks 5 times again. Could you please let me know what the problem is and whether it is possible to solve the problem without fixing. Thanks for your help in advance!!!


Hello\015\012Blinking of standby light is Sony TVs are fault indication. Five blinks denotes \015\012AKB circuit (AKB), the timer/standby indicator blinks for about\015\01230 seconds then goes to the self-diagnosis function. ... Sony KLV32S200 Television

I purchased a LG 60PK750 in june 2010 and it was all good since two or three weeks ago, when I noticed a kind of burn in image of a vertical line in the left of the screen. It won't go away even with the white-out or snow screen for hours and I do not know what to do now. I could not believe that a product of over 2000$ that I bought in less than a year is already scrap! Can you help me please? P.S. (Excuse my english since I speak french).


... LG 60PK750 60 in HDTVReady Plasma TV

My tv just stopped working. When i felt the power supply box it was very hot. I unplugged the tv and after half an hour turned it back on when the power supply cooled down. The tv worked again but only for about half an hour and turned off again. The standby lights are on but i cannot get the tv to go on. What could this ba...maybe the power supply? Please help. Thank you


Hello,It's the problem of overheating in the power supply board of the Television.on the power supply board of the Television there are few capacitors and IC.any of this IC is got short or may be weak.so due to this when you start the Tel ... Flat Panel Televisions

LG plasma screen TV working fine last night. This morning to all intents and purposes the TV is dead. The power light is on but no picture or sound. Tried switching everything off at mains, no change. Please advise what this could be


If you want to fix the problem it needs trouble shooting and of course a digital multi meter. first you need to open the back cover, and then before you trouble just look the components first at the power supply, control board or at Y and Z sustain b ... LG Flat Panel Televisions

When you turn the television on, the screen is blank except for the letters/words: VGA NO SIGNAL We called our cable company and all their suggestions did not work. Could you please assist? Thank you


Are you trying to watch tv or use it for the computer? The input or source selection is on VGA at the moment which is the 15 pin input at the rear and it is expecting your computer to be attached. If you are using it with your computer you need to se ... Akai LCT2715 27 in. LCD Television

When i turn on samsung model HL-5675s sounds like it wants to turn on but doesnt. i opend the back. and they light turns on for like 3 seconds. the fan turns on. but thats all . not sure what it could be? and befor that it got a white dot on the left side of the screen. also turnd off by its self that last week and when i turnd it back on it did but sounded like it struggeld to turn on.


... Samsung DLP HL-P4663W 46" Rear Projection HDTV-Ready Television

I have a Vizio VT420M tv and ordered a mainboard. The back light comes up, but I still have no on screen disply when I hit the menu button. I have searched for firmware for this model and can't find it anywhere. I have even contacted Vizio technical support and they are no help. Could you please contact me with possible solution. Thank you


Did you check the T-CON board to see if it has switched 12vdc feeding it? You will need service manual to get the test points reading.\012Basic LCD monitor and TV troubleshooting guide:\012 ... Flat Panel Televisions

Hello everyone.. I have a samsung le37a456c2d and i am trying to connect my PC to the TV USING HDMI to HDMI direct connection,i have got the graphics card to recognise the tv(ati radeon hd 5450) however the tv does not recognise the pc connection and there is no pc mode source to select??what could be happening here..please help.one of the reasons i specified the video card was so that i can watch hd quality through PC on my TV.


... Samsung Flat Panel Televisions

Had this TV for a couple of years now. We bought it new. It has started switching itself on and off standby. When you press any button on the remote control the screen goes black then comes back on again a couple of seconds later Cannot turn volume up or down for this reason Cannot access the in-built programme information We could switch to HDMI and watch things on the playstation last night, but now it has stopped allowing us to do this too. Changed batteries on remote Please


With no make or model, it is a little difficult to try and decide what the problem might be but, I would disconnect the touch button panel on the TV, if it has one. That could be the fault. ... Flat Panel Televisions

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || fullblownbass.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0977 seconds