Having problems with your Flat Panel Televisions ?

I have a Sony bravia KDL32 L5000. pressing power button will turn green light on, but no picture no sound. Cannot turn tv off by power button. Have to unplug tv to turn off. Can hear click when you plug in tv and when you turn on with power button.



Answers :

Hello,

You need to check the output voltages of the power supply to see which one goes off. It may be due to short circuits some where, if otherwise
the power supply board is dead,do you know basic electronics' and soldering? Most of the times, the power supply board just have dead leakages gases capacitors.These capacitors always bulges up on it top,or puff up on it top.Replaced these gases leakages capacitors will get your TV power stable,and work again.Or tries websites like Shopjimmy.com,Ebay.com to buy a whole refurbish power supply board for the replacement.

Hoping that this will help to solve the problem.....

Repair Help & Product Troubleshooting for Flat Panel Televisions
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

I have a Sony bravia KDL32 L5000. pressing power button will turn green light on, but no picture no sound. Cannot turn tv off by power button. Have to unplug tv to turn off. Can hear click when you plug in tv and when you turn on with power button.


Hello,You need to check the output voltages of the power supply to see which one goes off. It may be due to short circuits some where, if otherwisethe power supply board is dead,do you know basic electronics' and soldering? Most of ... Sony Flat Panel Televisions

I have just re-installed my pdp5071 after it being in storage for a few years.. the unit will not power up . at plug-in several clicks at upper left rear of unit ( click - stand by red light on-off, pause then click blue power light on, click blue power light out, pause click, click ) unit then is dead .. i have tried the unplug reset operation several hundered times same result. i have tried the mechanical power button a few hunderd times - randomely at plug-in i get a single click and red stan


There are two power buttons on this TV. One on the lower left front and one on the right side. make sure they are both on. During storage it may have deactivated both of them. ... Pioneer PDP-5071HD 50 in. Plasma HDTV

Hi I have a TH50PZ80U that is flashing two red lights when I plug it in. If i press the power button for 5 seconeds it will flash 10 times. When applying power the AC relays click, after pressing the power button the fans turn on and the optical audio port is red. It will stay 'on' for 3 seconds and then the relays will click on turn off. No red optical light. If I test the P25 connector pin 1 voltage it will go to 15 Volts for about a seconed and then 0. This is only achieved by plugg


I'm 100% confident that a D-board replacement will fix this issue. I've worked on 8 of these and a D-board replacement fixed the issue you are having now. I had all the same problems with them but it is all related to the D-board (from previous exper ... Flat Panel Televisions

When I turn my TV on it will turn off by itself in about a minute and the red power light on the front of the TV will blink. The remote control nor the power button on the front of the TV will turn it back on. I have to unplug the TV for a few seconds and plug it back in to make it come on. It usually takes two or more of these unplug and plug back in sessions to get it to stay on. Some times it takes up to fifteen before it will stay on. Please help.


This is what 's happening: you give the command to start the tv so the power source is initiated and starts to deliver power to the rest of the components of the tv; one of these components has aged and it requires much more current than normal to st ... Toshiba TN55V71 55" Rear Projection Television

I have a sharp aquos lc-c5277un. Both the power and OPC lights together blink twice. I tried unplugging it, holding down the volume up and channel down buttons while plugging it in. That left me with a solid power light on. I pushed the power button to turn it off and it turned off. Pushed it again to turn it on. It turned on and worked. 10 minutes or so later I heard a pop sound and the lights started blinking as before. This loop has played out three times. Is this the power board or


... Flat Panel Televisions

My LG Plasma 50PJ550 won't turn on. I have unplugged it and Plugged it back in. I have sprayed it out with air. I press the power button and the red light goes away, I hear a click then the red li


Visit the site named 'Electro-help' for\012more details. Click this link. View it in \012"Timeslide" or "Flipcard" option, which can ... Flat Panel Televisions

I have a lg 32lc5dc that powered off by itself and now when i unplug it or turn it on with the remote the remote no longer works and i have a snowy screen. It will not power off when i plug it back in it just comes right back on, every once in a while it will stay powered off when i plug it back in and the remote will turn it on but then the remote will not do anything else. i have changed the batteries and used the reset button on the back of the tv i dont know what else to do


Hello,It's the problem of overheating in the power supply board of the TV.on the power supply board of the TV there are few capacitors and IC.any of this ic is got short or may be weak.so due to this when you start the TV the current passes fro ... LG 32LC5DC 32 in. LCD HDTV

My Panasonic 1080p TC-5-ps14 TV will not on when I turned power on. What I did was unplugged the power cable. Pushed on the power button for two minutes. Then plugged the power cable back anh turned on the TV. TV still won't turn on. What is the problem? Please, help!


... Panasonic TC50PS14 Plasma TV

Hello i have an element 37'' tv and i have to unplug the tv several times just for it to turn on. There is a steady red standby light on but when you try to hit the power button it doesnt respond via remote or on the tv panel itself. The only way it will turn on is from a constant plug and unplug of the power cord. Please help?


There's a good chance you have failing electrolytic capacitors either in the power section or the inverter section or both.Any caps in these sections that look bulged at the top, or bulged/leaking at the bottom need to be replaced.If you ... Element Flat Panel Televisions

I have a JVC AV-56P575. The problem is while watching the TV I left the room for several minutes and when I returned it was off. I tried the power button and it would not turn on. I unplugged it then plugged it back in and pushed the power button. It came on briefly then shut off again. Now it will not power up at all. I have noticed recently that it took longer to power up than usual before this issue. Any suggestions?


Tv DM power supply board might have dying parts like capacitors are bulging or puffing up on it tops.U have tools like a soldering iron,a desoldering pump or a roll desoldering braids and can u also do basic soldering too?Yes.Tries websites like Tvre ... JVC AV-56P575 56" Rear Projection HDTV-Ready Television

My TZ50V61 powers down usually shortly after turning on.When this happen the red light in the power button flashes on and off.I then unplug and plug back in and it will work ok. I have to do this more than once sometimes. I also tap and push power button several times.Seems like it stays on then or is it that it has warmed up and is not powering down.What do you suggest????


... Toshiba TZ55V61 55" Rear Projection Television

My Samsung Plasma 42 in. TV turns itself off after a couple of minutes of being on and then makes a clicking sound like its trying to turn on again but it doesn't turn back on. It just makes this clicking sound. If I unplug it, sometimes it will function normally again and sometimes the same problem occurs. We thought it might be the power strip so we plugged it into a different outlet. At first, this seemed to work. Then, the cable box and the sound system started turning off spontaneously


Try checking the standby mode. . . ... Flat Panel Televisions

50pfp5332d got this tv not working. found no power when conected and decided to remove back cover. found blown PCB fuse and replaced it,turn the tv on and the picture came on for 10 seconds and when out but tv was still on since the logic board led was on,also noticed led on PCB started blinking. pull power cord off and then plug back in turn power button on and got picture for 10 second PCB relay clicked picture died and led on PCB started blinking again. what do you think?bad PCB or ba


Hello\015\012The power regulator PCB has some fault it it. It does not outs proper regulated voltages needed to the other PCBs in your TV. Normally Plasma TV power regulator PCBs are very difficult to repair, and PCB as whole should be replac ... Philips 50PFP5332D 50 in. Plasma Television

Whenever i plug my sony bravia KLV-32U300A, it click twice and doesn't turn on,power sign goes completely off. I have to unplug from the power source, wait 5 mins and try again, it rarely turns on, but does so if you try it after 4/5 hrs. Once the tv on it works fine. how can i rectify this problem? is it from the power board problem or the main system board problem? Pls help me thank you.


Hi,\012\012This is an indication of out-of-regulation in the power supply section. The very\012common caused of this fault is the leaky\012electrolytic capacitor ... Sony Bravia KLV-32U300A 32 in. HD-Ready LCD TV

I have a Gateway p46m103 flat screen television that will only turn on after plugging and unplugging the power cord many times. It would eventually turn on each time I tried this. Now, however, the green power light comes on, and I can hear it is on, but the screen is all black. I even tried pressing the Input button on the front of the television, to see if I had accidentally changed it, and even the icon on the screen will not show, to see if I am seeing the cable box, or the dvd player, etc.


... Gateway PLSM46TV 46 in. Television

About once a week, after I turn off my Toshiba 23HLV87 it turns itself back on. I keep pressing the power off button many times and it keeps powering back on. The only way to solve the problem is to unplug and plug it back in. Is there a quick fix to this problem. I am really disappointed with this tv. I've only had it for 3 years.


... Toshiba 23HLV87 23 in. LCD Television

The red light stays on but the power button or remote will not turn on tv. I unplugged for over night amd plugged it about 12 hours later and the red light on bottom stays on but the tv will not tun on via remote or the manual power button. note it was a lighting storm yesterday dont know if that plays a factor


... AOC L32W861 32 in. LCD TV

Cant get the power to turn on,worked fine last night, it got unplugged, this morning plugged in, won't turn on and the power button just flashse


Flashing is either an error code or the set trying to boot up--some of the Mitsubishi sets if power removed will blink for a minute and then stop--then the set can be turned on.a model number? ... Mitsubishi Projection Televisions

Hi, My name is Anali and I recently purchased a Westinghouse TV from Target. I had it plugged into the wall and working one evening. The next day when I went to turn it on again the red button would turn on but the screen would not. I unplugged it for the day, moved it to a different wall socket, and it worked. Next day I turned I tried to turn it back on again, to it doing the red light when I hit power, but a black screen.


Hi Anali. That sounds like the powersupply is bad. The tv has a one year manufactuers warranty. Take it back to Target and exchange for another one. Hope this helps. ... Flat Panel Televisions

My samsung plasma tv shut off and wont power back on. when i unplug and plug back in it will click 5-6 times like its trying to turn on while the red led flashes then it stops until you unplug and re


... Samsung PN51D530A3FXZA - 51inch 0pdp Hdtv & 1080p

Viore PD42VH80, had the power go out and come back on quickly, 3 times. since then, there is just a clicking sound from the tv when it is plugged in, will not turn on though.


... Flat Panel Televisions

Hello, i have a samsung 42' plasma tv model #pn42c450b1d. the tv doesn't want to turn on. i plug it in and you hear a clicking noise se a red power light. also when you press the power button on the tv in the back u see a green light come on for a second on one of the circuit bords( the one under the power board) and simutanously you see a red light come on and and off at the same time on the circiut board with the av, hdmi, inputs. i looked and thier doesn't seem to be any bulging capaciters. a


Hi.As you know the TV is in protect mode because an internal fault has been detected. I think that you already tried leaving power cable disconnected for ten minutes. After connecting back restart the TV with no device attache ... Flat Panel Televisions

My panasonic flat panel tv with model no. TH-L32c20x has a power problem.. i push the manual button on tv side,the red light is on..then second is the remote power,the green light come and blinking 20 times,then turn to red light blinking slowly, the power not goes in, i unplug and plug again,try the same way its not working..


... Panasonic Flat Panel Televisions

X322BV-HD*WXC100 Problem: TV will not power up. Red indicator light is evident and turns blue when you use the power button on the remote or the power button on the TV. However nothing else happens. The screen does not light up nor can you turn it back off with the remote or TV button. I tried on several occasions to remove the power cord and plug it back in again with no success. The red indicator light comes back on and turns blue when I use the power button on the remote or the power button


... Flat Panel Televisions

X322BV-HD*WXC100 Problem: TV will not power up. Red indicator light is evident and turns blue when you use the power button on the remote or the power button on the TV. However nothing else happens. The screen does not light up nor can you turn it back off with the remote or TV button. I tried on several occasions to remove the power cord and plug it back in again with no success. The red indicator light comes back on and turns blue when I use the power button on the remote or the power button


Warranty is usually 1 year parts and labor. Contact mfc for warranty service. likely main board. ... Flat Panel Televisions

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || fullblownbass.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1685 seconds