Having problems with your Standard (CRT) Televisions ?

I have a 29inch Sony Trinitron Color TV model # KV-XG29M50 which is around 4 years old...The screen went black all of a sudden and the power indicator on the TV flashes red 5 times every 3 seconds



Answers :

Repair Help & Product Troubleshooting for Standard (CRT) Televisions
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

I have a 29inch Sony Trinitron Color TV model # KV-XG29M50 which is around 4 years old...The screen went black all of a sudden and the power indicator on the TV flashes red 5 times every 3 seconds


... Sony FD Trinitron WEGA KV-29LS35 29" TV

Okay, so my Panasonic PT-43LC14 went black in mid show last night. The bulb is approximately 18 months old. The LED indicators upon Power On are; Power LED blinks green for approximately 70 seconds; Then the Power LED switches to Red Blink, and the LAMP indicator blinks once every 5 seconds. Service manual indicates this means lamp or ballast issue. I've inspected the lamp, and it doesn't appear to be burned out. I've disassembled the TV and check the ballast for visual issues and see none.


Check the bulb again and look at the root of where the main stem comes out inside and be sure you don't see any bubble like appearence around the stem at the bottom there. If you do see this then the bulb is bad. Otherwise try this: Hold volume do ... Panasonic PT-43LC14 43" Rear Projection HDTV

Try to turn on the TV, the indicator in Green turn off and red Standby indicator is flashing 8 times between each two second break. TV is not on but the red standby indicator keep the flashing until I switch off the power.


Hi guency,\015\012\015\012This is an indication of out-of-regulation in the power supply section. The very\015\012common caused of this fault is the dried-up/leaky ... Sony KLV-46V300A 46 in. HDTV-Ready LCD TV

Hi there, my sony grand wega kdf60wf655 had stopped working and was flashing 5 red lights. I tested the voltage from the power board to the lamp ballast board and got a 272v dc. Just replaced the lamp ballast board and now get blinking lamp indicator. Tried a new spare lamp that i had in reserve and still flashing red lamp indicator every 1 second. Any ideas? thanksp i


... Sony Grand WEGA KDF-55XS955 55" Rear Projection HDTV

I have sony Bravia KLV -32V300A suddenly shut-off while I am watching power indicator went off and standby red light blinking 5 times then after 2 seconds off then red light blinks again 5 times and so on.no sound either


\012AKB circuit (automatic kine bias), the timer/standby indicator blinks\012for about 30 seconds then goes to the self-diagnosis function.\012Something is wrong with the video. Check video out, Q705, 732, 761\012and other components on the C boar ... Sony Flat Panel Televisions

My Sharp Aquos TV went off whilst we were watching it and won't come back on. The red power light flashes twice per second and the green OCD light flashes three times every second. Is there a re


Tries tv unplug replug the tv back about an hour later,might resetting the tv back factory setting and should work again.Still have the problems,the main board it is shorted and dead require changing.The main board that board were the incoming broa ... Sharp Aquos Flat Panel Televisions

The Timer indicator on the front of the TV is continuously blinking green. I have made several attempts to fix this by pressing the System Reset button and held it for up to 30 seconds at a time. Each time I release the System Reset button, a few seconds later the Timer indicator starts flashing again. I have also totally disconnected the TV from power for up to 15 minutes but as soon as I connect it back to power the Timer light starts flashing again. I cannot locate my owners manual for


Hi,Let me know model number of your Mitsubishi tv to provide you helpful info about problem and manual pdf file.Thanks. ... Flat Panel Televisions

I have a Sony KDS-55A2020 DLP TV. The lamp recently was replaced due to picture cycling off every 30 seconds. Two weeks later I have no sound or picture. When I turn on the power button the green light flashes 50 times then the red light flashes. Please advise.


You still have problems with the power supply ... Sony KDS-55A2020 55" Television

Flashing light The green power flashes several time then the power light flashes green, Temp indicator light flashes red and lamp indicator flashes red in order over and over.


... Hitachi 50V720 Television

Mitsubishi WD-65738 won't power on red light flashes4 times and then yellow flashes 8 times. I have held power button in front for 10 seconds,green light flashes for a second then it goes back to the red/yellow flash,please advise


... Mitsubishi 3D DLP 73 Home Cinema TV WD-73640

Our 23 month old Philips 37PFL5404H/05 television has suddenly stopped working - screen black - only red LED flashing 3 times every 10 secs. Have tried unplugging etc. but no joy - is this a major rep


Visit the site named 'Electro-help' for more\012details. Click this link. View it in \012"Timeslide" or "Flipcard" option, which can be ... Flat Panel Televisions

The standby indicator on my TV flashes red several times after every three seconds.


This is a protection circuit that prevents the tv from coming on (to stop damage of the components) ....you need to check your voltages off the power supply and make sure they all read well (EX: 24v12v5v etc). Also look for po ... Flat Panel Televisions

Hello. First, thanks in advance for any assistance you can offer! I have a Hyundai flat-screen t.v., Model # HQL260WR (manufactured in January 2005). For the most part it works perfectly, but every once in a while when I turn it on (maybe 1 out of 10 times), the screen will come on for 1 second, then the t.v. will shut itself down. When this happens, even the little red power indicator light (that shows that the set is plugged in & ready) cuts off. Once this happens, I have to unplug the se


Hi.It is not a lose wire. If problem was a lose wire or a bad solder joint it would have been sensible to vibration and the TV would have turned off when touched.It is not a software problem either. The software cannot turn of ... Hyundai Electronics Flat Panel Televisions

When you turn of the TV the POWER indicator flashes green for several minutes. The TV never comes on. After the several minutes of the POWER indicator flashing green, it stops, I hear a click and the light goes out. Within a few seconds, the LAMP indicator light starts flashing red continuously. I unplugged the TV and waited one hour to remove the lamp. I could not tell if the lamp was blown. I can see the filament, the glass is clear, but there is a 2 cm or less spot in the right upper c


Sounds like the lamp door is not secured in place. Try removing the lamp door and put in back in until it clicks. ... Panasonic PT-52LCX66 Projection Television

Hi I have a TH50PZ80U that is flashing two red lights when I plug it in. If i press the power button for 5 seconeds it will flash 10 times. When applying power the AC relays click, after pressing the power button the fans turn on and the optical audio port is red. It will stay 'on' for 3 seconds and then the relays will click on turn off. No red optical light. If I test the P25 connector pin 1 voltage it will go to 15 Volts for about a seconed and then 0. This is only achieved by plugg


I'm 100% confident that a D-board replacement will fix this issue. I've worked on 8 of these and a D-board replacement fixed the issue you are having now. I had all the same problems with them but it is all related to the D-board (from previous exper ... Flat Panel Televisions

Power button flashes Orange every 5 seconds. I have to press the Power button 2,3 times in order for TV to start.


I'd be looking at voltage ratings for the three fans and the the blower fan located under the projector itself. Check the air filters there are two but hard to get to the one under the projector lense. Id say toss and replace they have alot of issues ... Panasonic PT-50LC13 50" Rear Projection HDTV

I have a samsung HP-T5054 plasma tv the tv powers up and the samsung tone is audable but i get no picture on the screen the screen is not broken the power light flashes 5 times then is steadily lit on the digital board in the back of the set led 2000 and 2001 stay lit led 2003 light for 2 seconds then goes out but led 2002 flashes every second I had a shop test my Y main and buffers with a set that they have and those parts test out I am a electronis tech with 12 years in the A/V repair field


... Samsung Flat Panel Televisions

We have a Hitachi P50S601, Ser # V7L019070, plasma TV. Turned it on and the power indicator light goes from blue to a blinking red light (Stand By Mode). The TV is connected to DIRECTV and if you are fast enough with turning the system on, you will get a picture for about 2 - 3 seconds, then the screen goes black. The power indicator light will go from blue to blinking red. Thank you for the assist.


It have short in some board have to checked by some professional. ... Hitachi Flat Panel Televisions

Sony R60 XBR1 Powers on but after 1 -2 seconds powers off and the green light flashes red 4 times, pauses and continues to flash 4 times. Thanks


Hi,4 times red light blink in Sony KDS-R60XBR1 indicates problem with exhaust fan in tv and possible causes are as follows: Fan power is not supplied. (ASU board) Fan connector is not attached securely. Fan caught wir ... Sony KDS-R60XBR2 Television

Thank you i have an lg 32ld550 and its tuning off suddenly, i replace the power cord and nothing, i verified the configuration about the sleep timer and nothing, i proved with a power regulator and nothing, continues turning off automatic. for the first time take a time to doit but after its turn off the first time continues doing it every 10 or 20 seconds. i want to know if i have to replace the power board how i can do it myself. its a little expensive carry out to a technician


... LG 32LD550 32 in. LCD HDTV

Panasonic tcp42c1 red light comes on for 30 seconds with the screen dark but not off, red light goes off with power and this happens every time it is turned on


... Panasonic TCP42C1 Plasma TV

KLD60EX700 Sony Bravia my screen is black and the green and yellow lights are flashing at the same time. Any ideas on how to fix this? I've replace the power board and the main board because it was flashing red (3 flashes) witch turns out it was the main board not the power supply.


... Flat Panel Televisions

I have a Sony KF 50 WE 610 projection screen TV. It has worked perfectly since I bought it six or seven years ago. This morning I turned it on and the sound came on for a second, but then the sound went off and nothing else happened for about one minute. At the one minute mark it turned off by itself and the red indicator light blinked 5 times in a row... paused... blinked 5 times in a row... paused... and then blinked 5 times in a row again. When I powered it up again, the indicator light blink


Hello\015\012Five consicutive blinks at a time and the stops and again blinks five; is its self diagonosis procedure. All modern Sony sets has this function included in its circuits. If the system control IC inside it detect any fatal fault ... Sony Grand WEGA KF50WE610 50" Rear Projection HDTV-Ready Television

I have Philips 42pfl7409/98, When I connect power, white light goes on about 3 seconds change to red light, than 3 seconds goes off,about 3 seconds red light flash 4 times,what is wrong? Please help me!


... Flat Panel Televisions

I own a DYNEX DXLCD37-09. I am having trouble turning it on. The red "STAND BY" indicator is on and when I press the power button the green "POWER ON" indicator flashes a few times and then instantaneously turns off. My question being, is the problem the power supply board or the inverter board?


It can be related to a power supply fault , problem in the SMPS unit. Also a poor connection due to dry soldering of the drivers cannot be ruled out and so if you tap the TV while it is powering and if the power comes up it can be a poor connection. ... Dynex DX-LCD37 TV

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || fullblownbass.com || Terms of Use || Contact || Privacy Policy
Load time: 0.2063 seconds