The sattelite box have issues,tries unplug,replug the box back like about an hour later for it to reboot and resetting and upgrading it softwares.This tv problems switching modes to digital and to analog again back and forth should be solved.Still happening the box have problems,call ur sattelite provider change the reciever box.
Suggested Questions/Answers :
It is recommended you read all this kind of situations
Kdl-32s2010 .... after 1 hour, screen goes blank. I can get to the menu and switch to digital then back to analog and it works fine for another hour. it is hooked up through a regular cable to a sattelite box.
The sattelite box have issues,tries unplug,replug the box back like about an hour later for it to reboot and resetting and upgrading it softwares.This tv problems switching modes to digital and to analog again back and forth should be solved.Still ha ...
Sony BRAVIA KDL-32S2010 32 in. LCD Television
Replaced lamp on my samsung 7178 dlp. Worked for about a month. Shuts off regularly now, and lights indicate the lamp cover is loose. Reseated and tightened. Worked fine for another month, now it shuts off 3 or 4 times in a 3 hour period. Lights indicate loose rear panel, but could there be anything else that causes this. Picture is fine for contrast and brightness and the new lamp is only a couple of months old.
Samsung HL-R7178W 71" HDTV
Mitsubibishi wd series 73"..Mitsubishi ws series 73" dlp. Works fine but after several hours of viewing screen scrambles then goes blue and sound goes off. I can switch to another input and watch ama
A couple of suggestions, if only on cable and using a box disconnect the set and box from power and after several minutes repower and see if a reboot helps.The two models listed here both should also have a soft reset done with the original r ...
Mitsubishi WD-52525 52" Rear Projection HDTV
Hi, my Phillips was hooked up and working fine directly to the DISH receiver using the HDMI 1. I moved and had to put the DISH receiver in another room and ran a coax cable to where the TV is now using the ANT in spot. I select TV as the source and choose channel 60 and no signal. I hooked up another TV and it works OK. Any ideas?
Hey, I'm Seth. I work as a sub contractor for dish network. I am picking up that your problems are on TV 2? If so, you will need to go into the menu on the TV itself and look for, "channel scan" or "auto memory". Run a scan. If there are no channe ...
Philips 42PFL5332D 42 in. LCD Television
My Samsung SP-P4231 plasma television works fine for several hours and then the picture gets all wiggly and impossible to watch. If we shut the tv off and wait an hour or two and turn it on again, it works fine. Any suggestions?
The tv main Tuner signal board have intermittent problems,sorry this problems it could be anythings wrong in the board as parts wise are dying in the tv Tuner signal board just not completely,that why it take times to show up,that the board where the ...
Samsung SPP4231 42 in. EDTV-Ready Plasma Television
We purchased a Vizio LED Razor model #VM230XVT on 1/4/11 and it worked fine till this past weeked. Now when we turn the power on, all we get is the Vizio screen on the TV and will not connect to the channels. I've tried everything to get past the "Vizio screen" including unplugging the power fow awhile and still no luck. I brought in another tv and hooked it up to the same source and everything worked fine on the other tv. I took our new tv to another source and the same thing occurs, just the l
Vizio Flat Panel Televisions
I am trying to hook-up a PS2 to the DWT1304. I have the video (yellow) and audio (white/red) plugged into the front. I have tried to access the game system on channel 2, 3 and 4 with nothing but fuzz/static on the screen. The PS2 has been hooked up to this TV previously and worked. I have tested the PS2 connection on another TV and it works fine. I just don't know what else to try with the DWT1304 TV
Have you tried the AV Channel ...
Durabrand DWT1304 13" TV
I have a Samsung DLP HLR5667 and it blew a lamp 4 months ago, I replaced the lamp and it worked fine for about 2 months and started shutting off after only running for about 90 seconds. I reset the lamp hours and it worked fine for another 2 months. Now it is shutting off after 90 seconds of running, first the picture then the audio. All three lights then begin to blink. Troubleshooting I have performed is
1. I have cleaned the interior of the television.
2. Jumpered the lamp door switch.
You need to replace your color wheel. This is a very sensitive part and you need to take care when replacing. If you feel comfortable I can walk you through it. If not, I would take it to a authorized service center. ...
Samsung Projection Televisions
I have a RCA L32HD31YX12 TV. The TV works fine for a half hour and then the screen flickers and goes black. The sound continues. If I turn the set off for a half hour, it works again for another half
You have answered your own question, someone needs to open it and find a loose plug or broken solder connection--if it reacts to being tapped on that is the issue- a physical problem inside. ...
RCA Standard (CRT) Televisions
My MKJ40653802 remote won't work even after putting in new batteries.The TV is hooked up to sky and that remote works fine + the Tv works on the buttons but not on the remote.Any suggestions
This only takes about a minute and will restart 1 in 3 "Dead" Original Remote Controls. \012\012\012\012\012\012 \012\012\012\012\012\012Step 1- Pull the batteries out ...
LG Flat Panel Televisions
My infared receiver is not working. I checked my remote control on another sony tv we have and the remote works fine. Any suggestions on correcting the infrared?
Sony KDL32LL150 315 in HDTV TV
I just switched over from cable to an HD antenna. Everything was working fine for about an hour, but now my SHARP LC-42D62U is stuck on channel 21.2 and none of the buttons on the TV work (including the power button). I unplugged it overnight hoping that the television would correct itself, but the problem persists. Any suggestions on a fix?
The tv needs to be rebooted then when you scan for channels you will need to manually erase 21.2 from the tuner, and call your cable company to report that this is happening.Call 877-332-7867 to have a case file created and to be walked t ...
Sharp Aquos LC-42D62U 42 in. LCD HDTV
LG 47'' LED. Model No. 47LE5310. Tv was working fine in the morning, was on for a couple of hours. went to turn it on later in the afternoon, but something is not right. there is power going to the tv. the power indicator light is on, but there is no picture or sound, just a black screen. tried using another power point, checked all cables and everything seems fine. Tv is about on month old. Any help will be greatly appreciated.
Just look to the picturebored sounding IC ...
Flat Panel Televisions
I have a GE guide+ gemstar model 31GT740 i cant get cable reception the cable is fine as i hooked them to another tv and it worked fine i did auto channel and it scanned all channels when it was done it said no channels found please help thanks
Your have problem with the system IC's which store the channel and all the control in the TV or it can be remedy by soldering the pin of the IC's if the problem persist well your have to replace that system. ...
GE 31GT740 31" TV
Hi-rn Thank you for being here- We were watching our Sharp Flat Screened TV, beautiful nice picture. We noticed when we hooked the cable up for Direct TV in our new home, the input connection point was bent and slightly loose. We attached the cable and everything seemed fine. Tried to move it back to the wall and the picture became distored w/ snow and it's saying 'analog' on the screen. Is there another way to connect it to the cable other than that particular connection point until we ca
With Direct TV, you should use the video input (composite video- yellow/picture, red/right stereo, white/left stereo)ORcomponent video- (green/video, blue/video,red/video white/left channel stereo, red/right channel stereo)t ...
Sharp Flat Panel Televisions
Our humax pvr-9300t keeps cutting out every few minutes & turning itself back on. We did have a power cut last night for a couple of hours but it was working fine this morning. Would be grateful if you had any suggestions, many thanks.
Recently I moved my tv by truck to another home and it was very cold out( winter in massachusetts) the tv had some condensation then plugged it in and it was working fine for 4 hours or so...while changing channels I beleive a friend of mine hit the off button and now the tv tries to go on as the orang timer light blinks and it starts to go on but then shuts right down just about when the picture is about to come on...also friend did have it near a baseboeard heater vent and now I have it moved
I have no sound ...
Samsung PCL5415R TV
My tv shut off while I was watching it and will not turn back on, it appears the power supply isn't getting to the tv. The red light that is usually on when teh TV is off is not even on now. It isn't my Directv because we hooked another TV up and that part works fine.
AOC L32W861 32 in. LCD TV
Can you help me with a new 32 inch Philips flat screen TV that I cannot get my DVD to indicate a picture, yet I do get audio. The model is 32PFL3505D/F7.
I have downloaded the latest software release version, ZPBF2QA_078_0_3202, and still same results.
The DVD player is an LG Brand, model DV172K. I have tested that on another flat screen TV and it works fine, yet with the Philips TV I just get audio and no video, and have tried several ways to hook up the wires. Still all same results.
Philips Flat Panel Televisions
I have a 42 inch Sanyo LCD dp42840. I have had it for about 8 months and it was working fine until a few days ago it keeps on turning off by itself. Sometimes it wont turn on at all, then I'll try a couple of hours later then it works fine for a minutes sometimes hours. The T.V has not been moved or gotten wet, just out of no were can u help
Sanyo DP42848 LCD TV
RCA Scenium DLP tv. Can use for about an hour then screen starts flickering. Shut it off for a bit then works again for about an hour. Happened before so I replaced the bulb. Worked fine for about a w
Bulbs are going bad ...
I have an 11 year old Toshiba DVD player. The last 2 times I rented a disk I had problems. Everything seems to be fine through the previews. When the movie starts to play, the screen goes green. The audio is fine. The video is there, but everything is green. I try the DVD in another player and it worked fine. I tried it in my laptop and it worked fine. Has anyone had a sinillar problem as this? Is there a solution to this issue? Please let me know
This is usually an issue with the component cables running to the TV. Remove the cables and retry with different component cables. If this doesn't fix the issue, its a problem with the DVD player itself.As far as DVD players go, you've do ...
Flat Panel Televisions
Dvd connection we have our direct tv cables hooked up correctly we believe, because we get the signal just fine. When hooking up the A/V cables from the DVD player to the other ports available however, it doesnt pick up the signal after we change the Source on the TV. So basically, everytime we want to watch a dvd, I have to unhook the direct tv a/v cables and hook up the dvd av cables in the same ports. It works just fine then. But we would love to not have to go thru that process everytime.
Check the connection wire for any internal conductor break. Check it with a multimeter. ...
Sceptre X400BV-FHD 40 in. LCD TV
I have a Vizio VF550XVT1A. First problem was a flickering screen that ended with the TV turning off. I replaced both invertor boards and the TV seemed to work fine for a few weeks. Now the TV works fine for approx. 30 minutes then the screen goes black but the sound keeps working. This cycle repeats itself after the TV has been left to sit for a few hours.
Good day sir Alfred!!!!If your screen turns to back after a minutes but the sounds is normal..That problem is very common to all flat panel specially to LCD TV..OK,I need to know first if your TV having a back-light when the picture w ...
Vizio Flat Panel Televisions