The best way to set up a TV such as yours without a calibration device is to get a high definition picture of someone's face on the screen and adjust the color, brightness and contrast until the face looks as life like as possible.
Have your tv professionally calibrated. Call geek squad. They have ifs certified calibrators. The end result is an incredible tv experience. 1-800-geek squad
Suggested Questions/Answers :
It is recommended you read all this kind of situations
I have a 60 Inc LCD led 120 hertz . sharp aquos . And I want to know what is the best settings for the picture? I tried adjusting it but it looks like a normal tv want to know the beat settings for picture on this tv? Please help me.
The best way to set up a TV such as yours without a calibration device is to get a high definition picture of someone's face on the screen and adjust the color, brightness and contrast until the face looks as life like as possible. ...
Sharp Flat Panel Televisions
I have the Sony KDS- 60A2020 60 inch TV. Recently, my picture has appeared more yellowish. Everyone on it looks like there dark yellowish or have fairly dark (bronze) sun tans. I changed my lamp yesterday but problem didn't change. I have adjusted all video picture settings but no changes have worked. Please help if possible. Thank you for your time.
I have a older 2006 SXRD rear projection TV. I had the same problem after the TV warmed up this yellow tint started in the corner and crawled its way down the TV. It turned out that Sony had a recall on the optic block of the TV. If you replaced the ...
Sony KDS-60A2020 60" HDTV
Was watching TV and trying to adjust the picture quality of my Model VS 6041 TV. The tv has an AT&T UVERSE set top box which has been working fine for 3 years. The TV Remote is looking for an antenna A or B rather then the set top box. Since I dont have a manual, I dont know what I did wrong. All I need is a manual
Mitsubishi Flat Panel Televisions
Sony trinitron kv-32s66, picture flashes, removed back, looking for G2 control (?) supposed to be a black box, I see red wire but no black box or G2 or knobs to adjust. Please help, and a picture or diagram would be great! Thanks!
The red wire on the top of the tube will be connected to l.o.t ..inthat lot u can find g2 below screw....& focus upper screw... ...
Sony KV-32S66 32" TV
I have a panasonic pt-wx42f tv everything works great but the picture kinda looks 3d does anyone know what the problem could be and would I be able to do it my self please help
That's a common problem known as a convergence failure. Sites such as www.TvRepairKits.com have parts to fix this. ...
HDMI Inputs don't work (and I've tested my components with another TV). When viewing on Component 1 input, the picture has blotchy color, like water colors. Adjusting color and brightness doesn't help. The tint control has no effect, and in fact, the tint slide looks funny on screen. The audio control no longer allows selection of the A/V external. The only setting it allows now is TV. Reset does not change the symptoms.
Hi,\015\012\015\012First lets re-initialize the AV Memories by following the steps below.\015\012\015\012Press the front panel "Guide" and "Format" key at the same time.\015\012\015\012Wait until the unit reboot and then try if the ...
Mitsubishi WD-57733 57" HDTV
I have a vizio vp422 that made a loud pop and now doesn't have any picture or sound. When you power it on the vizio display light turns from amber to white but that's it. U have to unplug it to turn it off. I have checked the fuses and they are good. The capacitors look good visually. There are a couple on the power supply board that have a black cover over the top, so I don't know about those. I changed the main board and made no difference. Someone please help!
Replace its power supply regulator board as card basis. ...
Vizio Standard (CRT) Televisions
The picture on the set is still crystal clear after looking much closer the set seems to have rolling horizontel lines and this gives every vertical line and edge a nothced appearance. The best way i know to describe it is the picture is clear but it is like looking through heat waves coming up off of hot blacktop.
Mitsubishi WS-65613 65" Rear Projection HDTV
My 42 - inch LG Plasma picture is too large for the display, the top and bottom of the picture is cut off slightly. I adjusted the aspect ratio using the picture menu. The 16:9 aspect ration does not help and the "just scan" setting is only slightly better. All other settings cut off move of the top and bottom of the picture. How do I "zoom out" so the picture can fit?
On the remote control there is a zoom button. Your picture is zoomed in x2. You need to set it to normal. ...
LG 42PC3D 42 in. Plasma Television
My picture is grate. but all of a sudden the picture starts jumping in
and out and after trying to regain the picture the set turn it self off
and i have to unplug and replug to get jumping picture back? but i
never loose power to the set please help
Hi,\015\012\015\012May I know the brand and model of your unit to assist you further regarding on the symptoms.\015\012\015\012Jdvillanueva ...
Flat Panel Televisions
Picture settings model # pt-47wx52cf, just would like to know what the best picture setting are in piture settings. find it quit yellow,like every ones face looks like they have yellow johndiss!
Settings are not likely to resolve a "yellow" looking screen.Go to an unused video input or turn color all the way off----the screen should be gray or black and white looking.What this really suggests to me is a total or partial loss ...
Panasonic Projection Televisions
I have problems with my picture. It looks zoomed in and is very poor. The picture looks like it changes colors and has shadows throughout the picture. Whats wrong with it. Is it a DMD board, DMD chip or is it the main input board. Please help..
Before I can suggest anything its best if you can get me an image of the screen with the tv on so that I can see for myself. ...
Samsung HL-S5679W 56" HDTV
I have onida xaria lcd 22. After 14 months a new option automatically comes that was factory setting and hotel setting . I pressed factory setting but after this my source button (tv to pc or hdmi ) is not working. One more thing i am unable to change channel, sound type or picture mode.
Please help :me i am feeling worst to be onida customer and his customer is also worst. When i talk to repair executive he smiled and no i will not give the process how to enter security. Plz plz help me guys w
Standard (CRT) Televisions
I just purchased a Sanyo Hdtv Lcd and the picture quality if off the picture seems to come out greyish or pale....i'm not getting a true color. Is there some adjustments that I should know about? I tried the color and tint adjustments and it's still greyish looking.
Check hookup connections. If you are using the component input (3 wire video green ,blue and red). Be sure both ends are in the correct colors. if switched or not all 3 connected color will be off. Composite video uses only 1 wire ,yellow. See own ...
Flat Panel Televisions
My sony KP-51WS500 needs reset. I hit a button on the remote and my picture went off. I started pushing buttons like an idiot trying to get the stations back and in the process it messed my picture up. I have tried everything. I can't get it ti set back to factory settings. Can someone please help?
It is possible that you messed up the convergance of the projector lamps on this TV. Try the convergance setup to see if this helps. ...
Sony KP-51WS500 51" Rear Projection Television
Wd65513 mitsubishi tv 65513 i have this tv the picture is good and clear but after 15 to 20 minute of operating the picture would goes off I adjust the volume control I can see the volume control indicator moving up or down I can see other function indicating the set is not dead but no picture.If I turn the set off and then on the video will show normal for the next 20 minute then gfoes off again I need your help with this problem
Mitsubishi WD-62525 62" Rear Projection HDTV
I have a panasonic 21 system/triple stereo/text TX-51GF85H tv. The problem is i can't adjust the brightness, colour etc.... The picture is fine only its showing too much colour and when watching a movie its too dark. I just want to tone it down. It opens at the menu but will not stop on what i want to adjust. It continues over and over through the whole setting/ thing on auto without stopping. Ive tried it on the preset buttons on the tv but just does the same thing. The remote is missing and t
Hello Ruth,\015\012\015\012I don't think there is any problem with your TV or your remote control. I think you have the picture menu option set to P-AUTO. If you press the RECALL button on the Panasonic remote you wil ...
Panasonic Projection Televisions
I WANT TO KNOW WHATS GOING ON WITH MY TELEVISION. WHEN I TURNED IT ON NO PICTURES WILL SHOW ON SCREEN BUT THE SOUND COMES ON THOUGH. I TRIED TURNING IT ON AND OFF BUT NOTHING HAPPENS. I EVEN UNPLUGGED IT TO SEE IF IT WILL HELP BUT STILL THE SAME. THE POWER BUTTON ON TV KEEPS BLINKING NO MATTER WHAT. I JUST WANT TO KNOW WHAT I SHOULD DO?
You may need to replace the bulb ...
JVC HD-56G787 Television
Universal remote i want to know if i can use a universal remote for my sanyo Ht30744. i want to go the tv menu & ect.. I contacted the company and they said i should order the original remote. As you know its hard times right now and im not going to pay almost 50 for a remote. Please help thanks.
Visit the site named 'Electro-help' for\012more details. Click this link. View it in Timeslide or Flipcard\012option, which can be se ...
Sanyo HT30744 TV
On my sony tv model KV-32FS100, the picture keeps going on and off every two or three minutes. The sound stays on though. Just want to know is it worth fixing or cheaper to buy a new TV?
This is an intermittent fault, due to some loose solder terminals. Check it. ...
Sony FD Trinitron WEGA KV-32FS120 32" TV
I have Sony's 43 inch Projection TV, its model no is KP-ES43 ME1. Problem with it is that it has lost Blue color from its pictures. Anything that is of Blue color turns into different shades of Green color. But one important thing which i would like to share is that when we turns on PIP (Pictue-in-Picture) mode, images on the right side of the TV screen looks absolutely fine but Pictures on the Left side of the screen still have the same problem. I want to know what is the real problem and its
Sony Projection Televisions
My vizio p50hdm made a popping sound from the rear. Afterwards, the picture disappeared and tv screen was black (as if the power was off). Then within a minute the picture reappeared but looked real dull with a weird contrast. I disconnected power cord, turned off/on the tv, and the picture remains dull. Tv has been this way for almost a month. In order to repair, I have to pay an estimate of $600, including parts and labor. Please HELP!
The z-sustain board is bad. One of the the heat sinks on the board is cool to the touch. These had LG circuit boards and the number on the sticker, on the board, was a good LG part number. The part numbers were 6871QZH044A.Do a search on ...
V, Inc. Vizio P50HD Plasma Television
The picture bottom centre has gone out of shape. For example some one standing to the side in the picture looks pregnant. The picture is out of shape please help ;(
Tv have a problems,known as a convergence problems it is dead.Tv have R,G,B colors lines mis alignments,have colors shahows pictures or 3D pictures look alike?Yes,the tv convergence board it is dead.Convergence board must be replaced 2 STK convergenc ...
Toshiba 50A61 50" Rear Projection Television
I have a Curtis Mathes Tronics TV model CM 19022s and my volume is set to very loud. I do not know how to fix this. I was flipping through the channels last night and it the tv switched to ant stereo in french. The setting was originally set for English. The volume scroll line will appear on the screen going up and down, but the volume never changes. It is stuck on loud. Please help.
Flat Panel Televisions
My Samsung DLP HLT5075S tv wont turn on. It trys to start up makes all the usual sounds but no picture. It tries to start 3 times then it stops and the 3 led lights on the Rt side just blink. I took the lamp out and looked at it and it looks fine. I dont know if you can tell by looking at the bulb if its bad or not. Don't want to spend $100 on a new bulb without being sure its bad. Is there anyway to check the bulb?
Samsung DLP HL-P5663W 56" TV