Having problems with your Flat Panel Televisions ?

What's your problem?hi my samsung (i think its a series 6 the 1 with the red tint seround) lcd tv is getting 3 hoizontal lines across it, at 1st they came on for just a while then went to good picture, now i have them all the time ?



Answers :

Repair Help & Product Troubleshooting for Flat Panel Televisions
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

What's your problem?hi my samsung (i think its a series 6 the 1 with the red tint seround) lcd tv is getting 3 hoizontal lines across it, at 1st they came on for just a while then went to good picture, now i have them all the time ?


... Samsung UN46B8000 46 in. HDTV LCD TV

I have a 55hds69 2 weeks ago turned on black screen good sound,played around turning it off and on,picture came back. doing it again ,blue light blinks 9 times and stays on steady good sond no picture need hlp


... Hitachi 55HDS69 55 in. Plasma Television

I have a Samsung HLM5065W. The picture went out but there was still sound. No Lights on or flashing on the front. I unpluged the set let it sit for awhile then plugged it back in. Everything came on and the set looked great for about 30 to 40 seconds. Then the picture just went out again. I did this 3 time with the same results. Any Ideas?


Try searching for a possible "factory reset" for this brand. It will be a secret set of buttons on the remote to enter the default reset menu. I hope that gets you something to try. BTW you should have the original remote or a universal remote with a ... Mitsubishi WD-52525 52" Rear Projection HDTV

Heard a pop then like shattering glass at the same time picture went out but still has audio. Lamp Bulb is still good. What could it be?


... Samsung HLP5085W 50" Rear Projection HDTV-Ready Television

Lights went out breaker was thrower switched breaker to on several times when I came in tv would not come on electricity is good to it so is their a fuse and where is it on tv or is there a nother pla


Pull the TV plug out of the electrical outlet. In fact, pull all plugs from all nearby receptacles. Try the circuit breaker. If it still trips, pull more plugs from the receptacles untill the circuit breaker no longer trips. Reverse the process t ... Flat Panel Televisions

We have an RCA model RLED4010A TV obtained new in January. It has been working well, and is compatible with our Bell system. Today it unexpectedly turned off. I unplugged from the source, waited, then plugged back in. The red light on the front bottom right corner came on, but appeared to be only half on. When I used the remote and turned the unit on, the blue light came on, but no picture or sound appeared, then the blue light went out. I repeated the unplugging process a couple of times


... Flat Panel Televisions

I have a Mitsubishi wd-52525 HDTV... Picture went out and red indicator light came on. I shut off the tv and turned it back on and it made a crazy sound.. I shut it off and replaced the lamp. After installing the lamp I tried turning the tv back on and the green indicator light came on a blinked approximately 6-7 times and shut off and would repeat along with a crackling sound from the speakers. The green light is not continuous and you can not shut it off with out unplugging it from the wall. I


You must test the power supply inside. See if the fan is working, and thermostat is ok. test it.God bless you ... Mitsubishi WD-52525 52" Rear Projection HDTV

I have A Panasonic 50 inch plasma model # TCP50S30 I replaced the SU SD SC and SS boards. The TV came on with A picture but it had wide streaks on the lower half of the picture the TV went off and the red light blinks seven times. I would appreciate any help with this problem.


Check the connections. if the ribbon cables are seated correctly, this will cause picture issues. ... Panasonic TCP50S30 50 50 Plasma TV

Our Sony picture came on one day & after a few minutes the screen went black, the sound was still there & the stand by light was blinking away. After waiting awhile we can still turn the t.v on, the picture will apear, but after about 3-4 minutes the screen goes black with the sound still going as well as the blinking of the stand by light. It this something that easily be fix, or time to get rid of the tube & on to the flat screen. I really hate to see it go cuz we really - really love this t.


Often it is cold solder in c-board. have you tried to re-solder it..in few years of using your t.v it is normally electronics parts heats-up..then it will loose it contact from the base board or the PCB.if you have a basic electronics knowledge ... Sony FD Trinitron WEGA KV-32FS120 32" TV

Replaced convergence fuse , resoldered flyback terminals..originally when tv went out it would not come back on..the power green light would blink a couple times then nothing..but finally TV came on..and showed convergence problem...after replacing suggested convergence fuse by tvrepair.com tried powering on the tv and the green power light blinks a couple times and shuts tv down...u can here a click ..but no picture. any suggestions?


Persistence pays off! What you found is very common and yes these sets are not real well made--good for you! ... Projection Televisions

Colour settings Tv screen flashed, went blank, came back in setup mode- retuned tv but now on all the picture modes i get a blue or green tint throughout the screen, the only setting that i get a desent pic on is in intelligent sensor mode but even this takes up to 20 secs to righten itself each time i change channel?


Good day!!!!That problem is usually cause of faulty capacitors on the power supply board..Just follow this instruction to fix your TV..1. Open the back cover of your TV.2. Look at the power supply board..Its normally c ... LG 37LC7D 37 in. LCD HDTV

I have a Zenith console TV bought in 1996 model # SY2722RK. While watching the last time it just went blank like someone had truned it off ( no picture and no sound ). I have done some work trying to figure out what it might be. The fuses are good and the power HOT section is working. The on/off relay is working correctly, but there seems to be no power getting to the flyback transformer or the rest of the tv's circuits. I did notice that the power transistor in the area of the flyback tran


... Zenith SY2722RK TV

RCA R52WM24 was watching tv the screen went very dim almost black then back on then off, this time lost picture sound and tv turned off. tried turning back on, power light came on for few seconds or


The deflection board has failed. You would require the ITC222A deflection board which is the second board listed on the following page which has a warranty and comes with installation instructions ... RCA R52WM24 52" HDTV Projection Television

In my tv is 10 years old and by the 2007 we replaced with new board(Only the CRT is the old one). Last day I was switched on my tv only sound only came and no picture. I can able to see the menu setting in TV live volume increase and decrease, Chanel nos etc. When I remove the external cable connection the display comes like blue screen(looks like the CRT is ok). When I inserted the cable the blue screen goes off and became black color during that time the audio of the tv is good. Pls help to s


Hello\015\012Your TV is fitted with Toshiba kit I understands from your description. There is a sub-brightness contorl on board [a small preset resistor, which can be adjusted with a small screwdriver] fitted near to the LOT and towards its le ... Flat Panel Televisions

Mitsubishi 72 inch TV quit working. We turned it on, the picture came on, it made a loud pop and the screen went black. We disconnected it from the power or a couple of minutes. When we turned it back on it makes a scratching sound, you can hear something that sound like a motor slowing down. It does that about 4 times and the red light lights up.


... Projection Televisions

I have a Vizio 37" HDTV that recently started losing the picture. The sound has been on continually but the picture now flashes steadily but mostly remains black. It went out one day, came back afte


It sounds like a backlight issue. It could be as simple as a few bad caacitors. If you already replaced the set and you just want $$$ toss it on your local Craigslist as a parts/repair set. There's always TV shop owner and parts scavangers that will ... Vizio VW37L 37 in. LCD HDTV

Sanyo 24 in flat screen model DS24425 Screen slowly goes fussy and slowly goes black , a slight tap on the rear left side brings the picture back to good screen,for a few minutes or a couple of hours no set pattern of time. When one turns the set on again some times come on clear other times very dul or black, slight tap and good screen. Sounds /act like a bad solder connection but which one do you have a wiring diagram or know where to get one? Thank you


Hello\015\012Your flat panel TVs picture tube base board has soldering loose contact with it. Just unplug your TV from AC mains socket, and open it. Pull out the picture tube base card from the picture tube neck. Pull it out straight, no sha ... Toshiba 55ZV650U 55 in. LCD HDTV

I have a vizio sv470xvt1a while watching tv the screen went black, then picture came back on, a few minutes later it went black again.. No popping noise when it went black. screen is still black...has power just no picture or sound. Help


Check and replace the back-light inverter baord. ... Vizio SV470XVT 47 in. LCD TV

My wt-46809 Still has a good picture. It receives its signal from an HD converter box from Time Warner Cable. The other inputs on the tv however don't seem to work. I can't use my DVD or hook up any game systems through the various inputs. In addition, while the HD channels (1000 and up) work, channels 1-999 don't project a picture (only audio). I've never added any HD retrofit to the set, so I'm not sure if true HD is being projected or if the picture is just very good digitally clear SD.


\012TV needs servicing PLEASE TRY THE BELOW FIRST THEN DO A FULL SYSTEM RESET\012\012\012CERTIFIED TV EXPERT HERE, follow this information I provided 3 long solutions to this issue/s Solution 1 Before we start taking things apart, lets try your ... Mitsubishi WT-46809 46" Rear Projection Television

Tv was fine breaker flipped I went out and turned breaker on several times I came in and unplugged tv and other things on outlet when turned breaker on electricity came on to plug pluged tv in and it


See if there is a reset on the tv. may be a shorted wire. ... Flat Panel Televisions

Magnavox 32MD350B/F7 On/Off keeps cycling. When pluging in the ac power the green light flashs then goes to red stand-by and back to a steady green light and then the whole cycle is repeated again no picture or sound. Cannot turn unit off at this time. After many times unplugging the power in and out, I may get it to turn on with a good picture and sound.


... SNK Magnavox 32MD357B_37 32 in. LCD HDTV/DVD Combo

I have a panasonic pt-53wx54 picture went black with a view vertical color lines then they went and it's now just black. sound is good no picture.. what do i need to do? thanks so much


I have a panasonic projection tv and i cant get the tubs to trun on .. i have don everthing that ever one said...horizontal drive signal to the yoke transformers were is that at couse i have a new horizontal chip and it still dont work...but i get ... Panasonic PT-53WX54 53" Rear Projection HDTV

KDF46e3000 image/audio went dead 3 minutes, came back for an hour or so, went permanently dead regardless of video source. Red light continuously flashes. Lamp relatively new (4 mo) German make, still looks new, filament good, red wire good, lamp and door reset, no go.


... Sony KDF46E3000 46" Television

The picture flashed green to black several times and the image went askew. Then everything went black and stayed that way. Sound remained on. After a few minutes, I tried to turn the unit back on and it did the white up and down lights ending with the two top lights on (now red). I have changed bulbs twice before when this happened and that fixed it. This time it didn't. One new thing that happens now (I know this is weird) is that when I turn it on the set chirps in the vicinity of the bu


Hi lc99527,\015\012\015\012This is an indication of faulty ballast board and or its power supply(gone to out-of-regulation) and once sense by the feedback circuitry it will automatically shuts off the power supply. First check for bad solder jo ... LG 62SX4D 62" Television

Error 33 How do I resolve error 33? I had to take the screen off and disconnect a few things to move it up some stairs. After putting it back together and reconnecting everything all that happened was the power light came on for a second then flashed 3 times and then nothing else. I ran the diagnostic test and it flashed 3 times with a pause then 3 times, 33. That is code 33, Air Filter is Open. I just need to find the Air Filter. Please just a picture or small diagram would be great. I've s


... Mitsubishi VS-50111 50" Rear Projection Television

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || fullblownbass.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1828 seconds