Suggested Questions/Answers :
It is recommended you read all this kind of situations
My samsung 46 inch LCD also has the problem of no picture, but clear sound. I read all the posts about capacitor problems, and have gone so far as to take the back off and the power supply cover to look at the capacitors. But they all look flat...I don't see any of the bulging noted in other posts. When I first power up the TV, it looks like it is lighting up, but after maybe 1/2 second of buzzing, the dim light goes off completely. Looking at it from the back with the cover off, you can see the
Samsung has had a lot of capacitor issues with some models, even if the capacitors look good they can still be open and need to be tested with special equipment to get to the root of the problem. They had so man ...
Samsung LN-T4665F 46 in. LCD Television
Samsung PN50B450B1DXZA will not power up. When I try to power it on, it makes a clicking sound and then nothing for 10-15 seconds and another clicking sound. The Red LED on the front flashes when it clicks but nothing ever appears on the screen. I removed the back of the TV and inspected Capacitors but do not see any that look to be bulging. When I try to power it on with the back off, I see a green light quickly flash on a logic board just below the power supply board. Are these clues helpful
Samsung HP-R4262 42 in. Plasma Television
Screen is dark but the middle looks like a burnt spot. Looks like someone formed dust to look like a small explosion. When power is turned on all that comes on is infrared light.
To fix. Power on and off. Checked power source plugging in and out. Changed outlets. Looked in the back of the tv to see if any lights from components inside the tv
From your description the picture tube has gone, and usually it will crack where the filaments light up, once air gets in the vacuum seal is compromised causing particles to fly damaging the delicate phosphor where the picture is g ...
Memorex MVDT2002 20" TV
Hello, i have a samsung 42' plasma tv model #pn42c450b1d. the tv doesn't want to turn on. i plug it in and you hear a clicking noise se a red power light. also when you press the power button on the tv in the back u see a green light come on for a second on one of the circuit bords( the one under the power board) and simutanously you see a red light come on and and off at the same time on the circiut board with the av, hdmi, inputs. i looked and thier doesn't seem to be any bulging capaciters. a
Hi.As you know the TV is in protect mode because an internal fault has been detected. I think that you already tried leaving power cable disconnected for ten minutes. After connecting back restart the TV with no device attache ...
Flat Panel Televisions
Samsung TV Model LA40A650A1M back light intermittently strobeing and sometimes cuts out completely, powering TV off via remote and back on temporarily resolves issue, but returns at various times, have removed power supply board to check capacitors - look OK none appear to be leaking.
Power supply board details Hansol LCD, Rev 1.3, Manf date 11 July 08, Model SIP 408A BN44-001947A
I note in some posts for similar Samsung P/S boards it has been suggested replacing specific capacitors - any su
You can't see if a cap is good or bad jus looking at them they have to be measured>They loose their capacitance because they dry overtime.I do sugest that you replace you power supply module or replace all caps.Possibily you may have a broken ...
Samsung Flat Panel Televisions
Screen comes on for 20 to 30 seconds then goes black. the power light is blue (on). when i hold the power button on tv it comes on again then goes off after 20 to 30 seconds. i have tried all the differant inputs, except for the pc input and i get the same results. i opened up the back of the set to see if it could be a bad cap but everything looks good,no burnt smell, nothing melted or poped, could this be a bad input board? This tv is not used much (less than 1000 hrs) it is clean and looks ju
RCA 32la30rq 32 Tv Black 720p Lcd - - RCA
LG 42PQ30 plasma tv wont turn on anymore, when you plug the tv in it makes a click noise and when you hit the power button the blue light comes on then changes to red after couple seconds. Note the screen isnt coming on and no sound.
What do you have to fix/replace to have tv work again, I opened back of tv up, I dont see any of those compactors thats look bubbled or leaking. I see some have like hot glue on them some have white glue. What do you think is wrong with the tv, i want to tr
I see so many here with no sound/nopicture issues:ISSUES: 1. IF sound main fuse/s are good.2. If no power or standby check main fuse, standby power supply and any signsof damage you can see---burnt parts etc.3. almost all thes ...
LG 42PQ30 42 in. Plasma TV
I have a lg 47 lcd tv. model num. 47LD500. only about a year old when this happened. Was working fine and just shut off by it self. will not do anything at all. no sounds lights nothing. Have checked power cord and all ovious things. Remover back cover and checked fuse and all capacitors look ok. Is there any downloadable test spect. and instructions for the power board. I have a good meeter and pretty good knollage of electronics. any help would be great. Thanks
Check power supply ...
LG Flat Panel Televisions
I have a Mitsubishi WS-55515 that was unplugged, when It's plugged back in there is power but no picture and green light flashes then the power goes off. For reading other posts I believe it is th
If set has been unplugged plug it in and try to turn on===when power light goes off in seconds: on the front of the set press and hold both the menu and input buttons for five seconds and release both.power light will blink a two dig ...
I have on element flx 2210 22inch lcd tv and when i power the tv to on the little blue light lites up for say 5 to 10 seconds then goes out and changes to amber without coming on and when looking down inside where the on off switch is you see a white flash as its turning back to amber can you tell me what needs to be replaced or how to repair this thank you for your help
As others have stated your problem is most likely caused by bad capacitors on the power supply board. This power supply board is the 200-000-xxxxtltx and is the same board used in the Polaroid TLA-01911 TVs. Here is a repair guide that shows what cap ...
Element Electronics FLX-2210 22 in. LCD HDTV
I have a Maxent MX-58HPT51 model P58H10NJA. I bought it in 2007, have been using it for years. I recently moved houses and brought the tv with me. When I plugged it into power at my new house, the LED did not light up and the TV will not turn on. I know the outlet is hot, tried different plugs. I currently have the back cover off and none of the boards or transformers look like they're fried. I'm stumped, please help.
Try resoldering the parts at the power supply section and check also connectors make sure that there are no loose connectors.press down fuses make sure it have contact on the board If you have a multimeter measure the continuity of the power cord rep ...
Flat Panel Televisions
I have a Hitachi 50 inch plasma, turns itself off by itself after I trun it on. I've heard it could be the power board, a common problem, but on removing the back cover and looking at the capacito
Hitachi P50H401 50 in. Plasma HDTV
I took the back cover off and looked all caps did not see any with noticable problem any idea which one could be bad
They may not be your problem--look for any even slightly puffed up on top. ...
Sanyo 42 in. LCD TV
I have a Sony KV-35S26 manufactured Aug '97. The picture comes ON only occasionally. When it fails to come ON, the standby light blinks continuously. Sometimes, the picture comes ON initially then goes out after several minutes. The picture looks fine when its working. Audio works fine. I removed the back cover and inspected the soldering, wires and connectors but found nothing obvious wrong. Just before the picture goes out, the image being displayed collapses vertically then I see a ser
After 4 or 5 yrs EHT ( transformer that supplies voltage to CRT TUBE - TV TUBE ) becomes weak - then few TVs ( not all TVs ) behaves exactly as you have described.............. .......so solution is EHT ( also called as ...
Sony KV-35S26 35" TV
I found what looks like a card reader and an headphone input on the back of my t.v. (Toshiba REGZA 26HL47)by the power-cord and it was covered up by the manufacture... i was wondering if i up-grade the firmware would i be able to use them, and if not then why were they even put there?
Miner modification design adjustment for a mass products productions fixes.99% of the LCD or plasma tvs out in sale for the consumers in the markets are never have to be upgraded or reinstall main frame firmware software at all,if u don't mess around ...
Toshiba REGZA 26HL47 TV
I have a zenith rear projection tv model r56w36. It won't turn on. When I remove the back panel and turn it on, I see a bright flash coming from the middle bulb on the right side of it where it looks like a wire is connected and then I hear a click from the power board. All the conductors appear to be fine. No bulging or anything but it won't stay on. Please help
Alba 32 inch hd ready built in freeview tv,touched the remote power button by mistake,and now it will not come out of standby.
Tried the on off routine,and looked at the back of tv,inside,due to out of warranty,and didn't see any faults...can you help.
Flat Panel Televisions
A slight topple, then ON power, just heard clicking sound. Remove back cover, can see spark in middle portion of TUBE. The copper coiling section. How to fix my problem.. Thank you very much.
In the power supply section, see the capacitors? The "barrells" usually black, grey, or blue. Look at the top of them, if they are bulging up, they are bad. Replace all of them in that section. (6)?? ...
Toshiba Flat Panel Televisions
My LG Golden Eye Model No CT29K35VE 72Cm TV fell when my son pulled the door cabinet open. The cover near the speakers cracked. The picture is fine but I have no sound. I opened the back. I did not see any loose wires. A friend of mine has a meter reading gizmo and a soldering iron. What do I need to look for? Unfortunately I have lost the TV Manual. Any help would be appreciated. William Thompson
LG Combination Televisions
I have a zenith projection tv model r56w36. It won't stay on. When I remove the back panel and turn it on, I see a bright flash coming from the middle bulb on the right side of it where It looks
Better be very careful here, if a pop or flash near one of the three crts or picture tubes there is serious voltage there.the tubes each have a sealed wire delivering at least ten thousand volts to each tube===I have heard this before. likely ...
Zenith R56W36 56" Rear Projection Television
Philips 42model num:pf5331/10, plasma tv, wide screen flat tv, the red light keeps blinking, one long then two short blinks, took back off the tv, pluged in power leed, power goes to power board, then clicks twice and will not start, yes i think its the power board, looked at all capacitors they look good, i have had the tv since 2006 if you can help me, my email is [email protected] thanks terry edwards
Hi raftxxxPlease everyone that comes across my info take a few seconds of your time to rate my solution which you can select at the bottom of my answer Was this solution helpful? YES or NO :)... As i have taken time to answer your questio ...
Philips 42PF5421 42 in. LCD Television
I have Hitachi Ultravision model 46UX25K I was watching in the morning then I shut it down properly by remote control, after few hours I try to turn it on, nothing , no picture just dark screen, I can hear light noise from the back of the TV going on and off within seconds but that's all, when I push the power TV button on my remote control I see the power light goes on and off but no picture. Upon removing the back there is a red LED on a circuit board in the back that also goes on and off when
got this tv not working.
found no power when conected and decided to remove back cover.
found blown PCB fuse and replaced it,turn the tv on and the picture came on for 10 seconds and when out but tv was still on since the logic board led was on,also noticed led on PCB started blinking.
pull power cord off and then plug back in turn power button on and got picture for 10 second PCB relay clicked picture died and led on PCB started blinking again.
what do you think?bad PCB or ba
Hello\015\012The power regulator PCB has some fault it it. It does not outs proper regulated voltages needed to the other PCBs in your TV. Normally Plasma TV power regulator PCBs are very difficult to repair, and PCB as whole should be replac ...
Philips 50PFP5332D 50 in. Plasma Television
My Vizio plasma vp422 made a loud pop and went off. Now it won't come back on. U can turn on and the vizio display turns from orange to white but nothing else. Also u can see the little green light in the back is burning. I have removed the back and don't see any visible damage such as blown capacitors. Also I checked the 4 little white fuses and their is continuity running through them. I don't really know where to start looking next. Would it be one of the boards? Is there any way of checking
You need to get a service manual (good luck) or begin by testing all the marked voltages out of the power supply board at TURN ON.do any come up and instantly go to zero or very low? That is a clue where you would have to follow up. ...
Vizio Standard (CRT) Televisions
Mag tv I have a mag tv 32 ' model 3200 that was working perfect then comcast ran some line test and it hasn't turned on since...The light changes from red to blue for the power the screen comes on shows mag then a pop in the speakers and goes right off with a line going through the middle across the screen. I know when a tv cuts off it is going into protection mode. I took the back off and did a look around in the back nothing looks to be burnt, no connectors was loose. Some dust clean
Take a look at photos to see if similar but different in physical size with a plus mark on one side and a minus mark on other side ...
Flat Panel Televisions