Having problems with your Flat Panel Televisions ?

When I turned on TV after about 1 week of not using it, it took a long time to start up. Then, I noticed a flickering in the picture. I checked all the Picture settings and noticed that I must turn Backlight all the way off or on lowest setting 1 to stop the flickering. The higher the Backlight setting, the faster the flickering becomes. However, the picture is too dark on Backlight Off or 1 and increasing Brightness to 100 does not solve the problem.

Answers :

Repair Help & Product Troubleshooting for Flat Panel Televisions
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

When I turned on TV after about 1 week of not using it, it took a long time to start up. Then, I noticed a flickering in the picture. I checked all the Picture settings and noticed that I must turn Backlight all the way off or on lowest setting 1 to stop the flickering. The higher the Backlight setting, the faster the flickering becomes. However, the picture is too dark on Backlight Off or 1 and increasing Brightness to 100 does not solve the problem.

... Samsung LA40A330 40 in. LCD TV

I have an ELCHS321. My backlight started to flicker. The inverter board is JLS-05-32EI. I have the back open and noticed that the LED on the inverter board was blue and flickering as well. As the set warms up the LED turns white but still flickers. The LED goes solid white and the flickering stops. Is this caused by the inverter board or or the backlight. Is there anyway to load the inverter board output to isolate th problem.

I would suspect and check first the voltages going there to see if low when cold and come up and if they are moving up and down when it flickers----points to problem in power supply ... Element ELC-HS321 32 in. LCD TV

I have purchased an HX46800 after using an XBR40 full HD for 3 years. The picture on the new set doesn't seem as sharp as the older LCD set except when the source is 1080. It is very unforgiving for even 576 picture source and the picture becomes less than sharp, especailly on long shots - sometimes looking almost blurry. The older set seemed to accomodate most HD sources with a sharper picture. Is this common or do I have a dud? tks Mike Goss

... Sony Bravia KDL40HX800 40 in. LCD 3D HDTV

Uneven backlight Sansui SLED4680 led tv. Backlight much brighter on the right side of the screen. I've tried to adjust with different brightness, contrast and backlight settings but the picture is always much brighter on the right side. Is the a solution to this problem or is the set defective? Bought floor display model today from ShopKo in Billings Montana. Thanks: Del

... Sansui Flat Panel Televisions

Toshiba 42H83 42 in. Rear Projection HDTV had the hyper module capacitor problem that Toshiba put notice out about. Changed those then plugged set in picture came in the three lamps noticably showed green,red, blue at the bottom of screen noticed grey static area because TV was not connected to cable or other device. Suddenly TV turns self off, now when plugged in to outlet power light blinks three times set turns off with speakers acknowlegement(sounded like speaker). I apparently have power d

If you bought a hypermodule rebuild kit from www.TvRepairKits.com go back to their site and ask for help. If you just bought parts off the web and winged the repair its hard to ... Flat Panel Televisions

I have a JVC HD-ILA HD-61Z575. The color engine was replaced under warranty a few years ago. Recently, I started noticing some color artifacts in the picture... basically in a dark picture, you can notice red, green, or yellow stars randomly on the screen. If I turn the TV off and back on, they usually go away and don't come back until the set has been off for a while. I tried cleaning out the bulb area and that didn't affect the issue. I've also yet to have to replace the bulb in the tv,

I only have bad news for you. This tv uses an engine assembly. It is impossible to replace the color wheel only. The entire assembly is quite expensive and wouldn't be worth replacing for a tv of that age. (By expensive, I mean roughly $400-$600, bef ... JVC HD-56FB97 HDTV

I have a Samsung LN40A550P3FXZA that is giving me problems. When I first started noticing problems I would turn the TV on and I would hear the power-up sound, the backlight would come on and then the red LED would flash a few times then the backlight would go off and it would repeat (power-up sound---backlight on---LED flash---backlight off). It would do this several times. Sometimes I would be able to get picture if I hit the source button on the side of the TV when the backlight first came

Try Samsung parts. They will almost always have the parts. As for the price. Its either 175$ for the board or a new tv. You have no other option ... Samsung LN40A550 LCD TV

I have an insignia ns ltdvd26 lcd tv. The problem i am having is the picture. When i turn the tv on... the picture is normal...then display freezes and slowly the picture will fade to black. If i leave the set on....occassionally the picture will come back on for a few seconds then fade to black again. The backlight still appears to be on when the screen fades out.

Good day!If your problem is pictures fade on and off...There are some points to consider like \015\012\015\012loose connectors on the power supply,main boards and inverter board ----reconnect a ... Insignia NSLTDVD26 LCD TV

Our tv is about 3 years old. We are a Time Warner cable customer. About 2 months ago we started to notice that the picture took a ong time to appear after turning on the set. The sound played for about 5 minutes before a picture appeared. Now the sound and picture are both gone--not sure if tv,s are repaired or thrown away these days as everything is designed to require quick replacement.

I'm sure this is fairly easy to repair. It sounds likely to be a power supply problem, possibly due to bad capacitors. Your original symptoms of no picture were likely to be the backlight controller not having sufficient power to operate correctly. I ... LG 32LC7D Television


Check and replace all the electrolytic capacitors at its main power regulator board and check. If it do not help you, replace the power board as card basis. It is a power regulator board problem. ... Flat Panel Televisions

The TV makes a click noise then the picture becomes I get parallel lines based on the colour of the picture at the time. The controls of the TV remote and when connected the Free view are frozen. Some time the picture rotas to the right at various speeds in Black and White. The TV is HD Ready and only 3 years old. I have an old analogue connected to the same Ariel but in a different room and that works fine with Terrestrial but with the problem TV I lost all channels and tried to re set them on

This is a classic switchmode power supply, has sensed a severe potential problem, and is shutting down to avoid a fire, explosion, or both. This set had developed a problem, that is so severe that the set must be shut down, This set should be removed ... Flat Panel Televisions

I have a Vizio VF550M problem. I was watching a show and the picture faded to black. The audio was still playing but no picture. I turned the TV off and on again but I still have no picture. It used to flicker a couple of times but now it doesn't. I can see the backlight come on when I power it up. Any ideas what could be causing it? Thanks in advance

... Vizio VF550M 55 in. LCD HDTV

Our LG tv has started making a vibrating whistling sound when you first cut it on, you can hear it get faster and faster then slowly goes away.. Also over the past few months I've notices the picture

The picture getting darker means the lamp has aged and u need to replace it another thing u need ti replace the mirrors in the light tunnel of the light engine they have faded secondly the noise means the colour wheel has aged you need to replace it ... Projection Televisions

42pfl3704d/f7 The TV has a white line that goes vertically on the left side of the screen. The picture also flickers. It will flicker more if I shake the tv. When I am going through the menu the previous words will fade out. What I mean is if I switch from one menu to the next the word will take a few seconds to fade out so it looks like there is two sets of words overlapping each other.

... Philips Flat Panel Televisions

I changed the almost every setting in aging menu of Aiwa A2119 TV. Channels were reduced to 99 from original 209 channels and picture quality has become very very poor and dark. Please communicate to me the factory aging menu settings of the TV. Thanking you people in advance.

... Standard (CRT) Televisions

I have an LCD Television set Model number LNS3238DX and the picture quality seems to be grainy and poor. When the menu button is pushed, that picture of the menu screen comes in just fine. I noticed that one of the capcitors was bubbled up, so I replaced all of the capacitors on the power supply, but it didn't solve the problem. So I am now wondering if the STP03 is defective and maybe I should change that out because everything in the power supply seems to be running just fine. Please let me kn

If you had a bad cap in the power supply you probably have some more caps that are bad, but may look good, and also change the bridge rectifier, it probably is leaky, and that should take care of the noise problem, if that d ... Samsung Flat Panel Televisions

I have Vizio XVT3D474SV I bought a year ago, in the last week while watching TV, the screen start to flash, display becaome white with 3 black lines and after a while it becomes black (the all time the sound stay as normal). while looking inside I see the backlight flashing till the screen becomes dark (than I do not see any light inside). After turning off and ON the TV several times I get back normal pictures but the same phenomenon comes back in few minutes. I checked all 8 micro fuses I have

When the picture is dark, show a torch light on the screen from a safe distance. If you can see the picture, the backlight is the problem. Anyhow, it is better to show it to a qualified service technician. ... Vizio XVT3D474SV 47 in. 3D LCD TV

Distorted picture and sound in Samsung UN46D8000 Led tv. Sound is like whistle even when volume is set to 0 level. Picture on screen is having a horizontal flickering lines.

... Projection Televisions

When I turn on the set, the right half of the screen is distorted. It flickers, different colors move from center to far right of screen, double images that appear as negitives and sometimes that half of the screen is very dark. Sometimes it will clear up for a second or two then go back to the problem. When the problem first started, it only lasted for approx 10-15 minutes then the picture was great. Now it takes 1-2 hours for it to clear up. Once it clears, I get a great picture. The lef

Hi,Symptom shows problem with lcd panel (screen) however, t-con board that is part of lcd panel could be defective and cause of these symptoms.T-Con board is located at top center of cld panel at rear and would be covered with metal shiel ... Samsung LN46A550 LCD TV

My screen flickers off and on, some times going out but the audio from the tv is still playing. This happens for all video sources and diff hdmi ports and cables. It flickers more than going completely off but one time I noticed some picture on the screen in light but tv still looks off. Next time it happens ill shine a flash light at it. What do I need to fix it?

You have inverter board problem,,try to replace it and will fix the problem.. ... Samsung LN46B650 46/49.5 in. LCD HDTV

Our LG tv has started making a vibrating whistling noise when you first cut it on, you can hear it get faster and faster, then slowly goes away. Also, I've notices over the past few months the picture seems to be darker.. Help!?

It sounds that the horizontal output section circuit to your TV is to be checked. It is really a skilled work. Contact any service technician. ... Projection Televisions

Okay so I bought the Samsung LN46C750 3D LCD TV today .. and when I hooked everything up and turned it on ... it would stay on for maybe 5 minutes then turn off again. It will not stay on for more than 5 minutes .... right before it turns off there is a noticable refresh rate drop (visible flickering ) and the backlight goes 10 shades darker before it turns off .... but that's not it !! I can still hear the speakers !! the sound is still playing. If someone could please tell me what this is I w

Hi,\015\012Try check your setting up for picture stup first.\015\012I think that from eco solutions setup. Or reset all the picture option to default setup by clicking reset on menu picture option. ... Samsung LN46C750 46 in 3D LCD TV

TFTV815HD lcd tv Palsonic: backlight is on, sounds works OK, all functions via remote seem to work OK, just NO PICTURE (dark screen only) Any idea what this may be? the set is from 2009

If back light is on suspect main board, Palasonic? or Panasonic? ... Flat Panel Televisions

We have an Astar flatscreen and every once in a while the tv will just change the av setting and then the screen goes black. It will flicker a few times like its trying to turn on but usually takes between two to ten hours to get the picture back. Any ideas?

... Astar LTV-19BG TV

Just set-up a 40 inch LCD Auria TV yesterday and noticed a buzzing sound on the left (front) speaker. The picture looks great and hope I can fix this buzzing sound problem with your expert advise. I don't like the hassle of returning this unit. Thank you very much.

... Flat Panel Televisions

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || fullblownbass.com || Terms of Use || Contact || Privacy Policy
Load time: 1.6684 seconds