Having problems with your Projection Televisions ?

I have a RCA P61939 61 in. Rear Projection Television. Would not power on one day. Day before it would not power off and when the remote buttons were pressed they showed different then what was pressed (pressed 2 it would show the menu, etc). Was finally able to power it off, now it won't power on. I checked the fuse and it is OK. Now I was able to power it on and there is only sound no picture. About 20 minutes later the sound just cut out. Now nothing.Is this something I could fix m



Answers :

With what you are describing I would start with the power supply. This is going to be a board, not a brick. If you can find the part online this is certainly something you could do yourself. Before you do anything back there make sure it is unplugged and discharged. Televisions can pack a wallop of stored up power. Keep in mind that this is a logical starting poing but true diagnostics would require a tech to come out or drop it off at a shop. My guesstimate for a repair would be around $300.00.

Repair Help & Product Troubleshooting for Projection Televisions
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

I have a RCA P61939 61 in. Rear Projection Television. Would not power on one day. Day before it would not power off and when the remote buttons were pressed they showed different then what was pressed (pressed 2 it would show the menu, etc). Was finally able to power it off, now it won't power on. I checked the fuse and it is OK. Now I was able to power it on and there is only sound no picture. About 20 minutes later the sound just cut out. Now nothing.Is this something I could fix m


With what you are describing I would start with the power supply. This is going to be a board, not a brick. If you can find the part online this is certainly something you could do yourself. Before you do anything back there make sure it is unplugg ... RCA P61939 61" Rear Projection Television

I have a Samsung LN40A550P3FXZA that is giving me problems. When I first started noticing problems I would turn the TV on and I would hear the power-up sound, the backlight would come on and then the red LED would flash a few times then the backlight would go off and it would repeat (power-up sound---backlight on---LED flash---backlight off). It would do this several times. Sometimes I would be able to get picture if I hit the source button on the side of the TV when the backlight first came


Try Samsung parts. They will almost always have the parts. As for the price. Its either 175$ for the board or a new tv. You have no other option ... Samsung LN40A550 LCD TV

This unit is practically brand new, has no dust nor dings nor damage on the unit anywhere, not even a scratch, but I haven't been able to get the unit to power on. Power cord is connected. The switch on the unit sounds like the others when pressed and everything looks and smells good inside and out! There are no cracks on the circuit boards, no broken wiring no broken or missing or out of place connectors. The fuse is also intact and appears good, but I haven't used a meter yet to check for


Hi jesseley,\015\012\015\012Do it has a led light when you plug the unit to the outlet, make sure that the outlet is live, what happen when you pressed the power on switch in the front panel?\015\012\015\012Jdvillanueva ... Flat Panel Televisions

I have a SOYO Atlas Series DYLTO32C. The power light goes on and I did have sound until I pressed the button on the remote that would change the input. The screen is black. The menu does not come up.The tv was purchased in August 2006


... Soyo DYLTO32C 32 in. LCD HDTV

My RCA 60'inch HDTV won't come on , it gives me 3 beeping sounds every time I press the power button , before this happened it would randomly cut off , then finally one day it just went out and it sou


The power supply has failed ... Flat Panel Televisions

TV remote on my model TXL2791F won't turn TV on. When I press the power button on the TV itself the little timer light blinks and the TV makes a ticking sound for a few seconds. If I press the power button again the blinking light and ticking sound happen again for a few seconds. If I repeat pushing the power button on the TV again the blinking and ticking will then go on all day long unless I unplug the TV for 15 minutes or more. All during this time the screen is dark. Just before this ha


... Samsung TXL2791F 27" TV

OK, following your advice of March 9th I got a new lamp from Mitsubishi and replaced it tonigh in my Mitsubishi rear projection model WD-62725 TV. The old lamp was clearly broken. However I have installed the new one, replaced the front cover, etc., etc. and when I plug in the TV I hear a faint whirring sound on the far right (as I face the front), sounds like a cooling fan probably, but when I press Power either on my remote control or press the Power button on front of the TV, nothing happ


Hi,\015\012That sound may from the color wheel. Open the angine, open block front of lamp. \015\012\015\012\015\012\015\012open co ... Flat Panel Televisions

Dead tv Hi, I have a 50" samsung plasma tv that seems completely dead. 3 years old, the other day we heard a pop sound (sort of like the sound a lightbulb makes when broken) and then the power went off and never came back on. When you press the power button absolutely nothing happens, no sounds, no power light, just dead nothing. the model # is PN50A650TLFZC and the version is KX03. do you have any trouble shooting tips please? thank you


... Samsung PN50A650 49.96 in. Plasma HDTV

While watching the T.V. I started experiencing a random of two to ten second very loud static, popping sounds then it would go to a green then a digit scene then a gray w/loud sounds the popping sounds the the picture will freeze. I will wait a few minutes and the picture would return. this last time it did the same thing but the T.V. went off and would not power on.


Your set has a problem with its power supply. If it is under warranty, have it replaced ASAP. If your warranty has expired, you can take the set to any good repair shop - ask for an estimate before having any work done to it. ... Element Electronics FLX3711B 37 in. LCD TV

TV power wont turn on. At first I would turn it on and I would get the light to come on but no picture, just sound. So I would turn it off then back on again and it would work fine. Now I am not getting any power what so ever.


This sound like the power supply board is failing. The electrolytic capacitors on the board may need to be replaced.\015\012IF YOU KNOW HOW TO WORK WITH ELECTRONICS REPAIR(soldering ) or have a friend with knowledge/skill you can fix it ... Polaroid FLM-2625 26 in. HD-Ready LCD Television

My OLEVIA LCD-HD TV (model 642-B11) has been acting funny for the last few days. I would press the remote button to power up the TV and and it wouldn't come on. So I would press it again a second


... Olevia Flat Panel Televisions

Toshiba 32C3500E Regza suffering for the old power issue BUT NOT the three yellow blinkis of the power LED - TV comes on after full power down - say 10 mins; starts ok, sound and picture ok, the the 'surge' noise, picture goes off, sound goes GREEN LED stays on - need a cold start again but less than 60 seconds same old prob. Know where I can get firmware as I would like to try this before calling bob-the-builder


... Flat Panel Televisions

I have a 22ins lcd tv/dvd combo when yhe power lead is attached the power light flashes very dimly there is no sound or picture. when i disconnect the inverter board both dvd and sound work and the power light is normal . obviously there is no picture at this stage as i,ve disconnected the inverter , would it be a correct assuption that the inverter is faulty ?


It is possible but a voltage check of the power supply will tell if it is bad or something downstream is pulling voltage down, power light going dim means something is really loading the supply down. ... Flat Panel Televisions

When pressing the power button it sounds like the tv will power up but nothing. No sound or picture. Red light on power button just flashes. It is a constant flash no pattern


... Projection Televisions

I have a 13 inch Craig LCD TV. I turned off my tv, at first it would not go off when I pushed the power button. I pushed the button again and I no longer had sound, but I still had a picture. I pulled the plug on the tv to turn it off. Now sometime later I have pushed the power button to turn on the TV. I have a picture, but no sound. Can you help me?


Your problem has been caused by the cables getting displaced when you were pulling out the power cord.\015\012The simple and easiest solution to your audio problem is to switch off the TV. Disconnect all the cables. Wait for sometime. Reconnect the c ... Flat Panel Televisions

My OLEVIA TV (model 642-B11) has been acting funny for the last few days. I would press the remote button to power up the TV and and it wouldn't come on. So I would press it again a second and som


... Olevia Flat Panel Televisions

Seiki 32" LCD HDTV - SC323FI - We lost power for a few hours when power came back tv volume would not stay on. Would stay on for few seconds then turn all the way down by itself and then not able to turn up. its almost like you are pushing volume up and someone is pushing volume down


... Seiki 32" LCD HDTV - SC323FI

So how do i fix my samsung 46 inch tv that shuts off by itself after i press power and only stays on fo about 15 seconds the makes the little clicking sound when u press power


... Flat Panel Televisions

Dead RCA TV model # P60752EB. My TV would make a click sound and the picture would flash like it was going out about once a week. It went off for good and now won't turn on at all. Someone suggested a power supply problem. I'm sitting here staring at the power supply board :( please help! I love this TV!


The PS suggestion is likely on the money.\012You have a couple of choices-\012- Buy a new board from RCA\012- Buy a used or repaired board; one source is:\012 Jimmy's Parts ... RCA Projection Televisions

My sony big screne started shutting itself off and wouldnt come back on for several hours. Then it would power up and standby flash 7 times and after a few mins the picture would be gone but the sound stayed on then a few minutes later it completely goes off. When I push power on it blinks 11 times and does not come back on for sdeveral hours. What could be wrong?


On your tv you have cooling fans on the back side you will need to check to make sure that they are running. Lay your tv on the bed take off back cover (it's not hard) and used some air-in-the- can to remove dust from the back! If you need a fa ... Sony Standard (CRT) Televisions

Samsung HLR5067wx/xaa - My says we had a power surge today and the tv turned off. After that, it will not turn on. Press the power button and the greens lights flash on the front for a few seconds then it shuts off. Never get any picture or sound. Any ideas? I don't want ot just go out and buy parts without a clear plan. A bulb sure, but I get no sound either.


It may be the blue switch on the inside remove the small plate covering the lamp and tape the buttton down its on the bottom rigth hand corner ... Samsung HLR5067WX 50" Rear Projection HDTV

When trying to turn it on the green light comes on the front, we hear a small zap sound, sounds like it is trying to come on and then the green light goes out... it will do this consecutively three times with one press of the power button. Then you have to wait 2-3 minutes before it will respond to the button press. We have done this for up to a half hour until the tv finally comes on. What is wrong?


Hello,This type of fault can be repair, it could be a short circuit on the panel power board, remove the back cover of the television in this you have to resolder the panel where you can find dry soldering, but if otherwise a common probl ... GE D52GW12 52" Rear Projection HDTV-Ready Television

TV turns on but no picture no sound. Turn power button on but only the green power button located on lower right flashes on. For the last couple of months prior the picture would "skip" and I would have to turn it off then back on to get full picture. Less than 4 yrs old. Please help. Thank you.


If u are a electronics repairer,remove the power smps sectoion and replace the 820 or 1000 or 1500 MFd capacitor.it will be bluged.thank u ... Insignia IS-LCDTV32 32 in. Television

I have a Panasonic TC-L22X2 LCD TV, sony google tv, a u-verse tv box, and a small JVC compact stereo. I have the sound from the uverse tv box coming out of the JVC stereo using red and white audio cables, but I also want the sound from my google tv to come out of the JVC stereo. The only way I've been able to get sound from the sony is out of Panasonic TV internal speakers. These speakers are low power and so the sound isn't very good. Thanks for your help.


Feed the audio from the google tv to your panasonic tv then the audio from your tv to your amp ... Panasonic TCL22X2 22 in LCD TV

I have a Hitachi 51F510. When I power it up it clicks like it always has and the power indicator light in the front comes on but it has no picture or sound. The remote will power the unit on but after a few seconds it wont power the unit off. I opened the rear panel and only saw a green light on, dont know if there is suppose to be more than one light inside. Any help on where to start would be greatly appreciated. the internals are filthy, going to get a can of compressed air while I wait a rep


You need to follow power cord inside the set; should be a board on right side it goes to----this set uses up to 3 small black relays---one or more is bad---tap on each until power light goes out.if questions let me know. ... Hitachi 51F500 51" Rear Projection HDTV-Ready Television

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || fullblownbass.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1318 seconds