All service manuals for these are online and only available to authorized service centers.
At your own risk: with set on in cable band: 062597 status will take you directly to convergence tech menu--be careful what you do and if not sure do not go to the menu after and select save.
Suggested Questions/Answers :
It is recommended you read all this kind of situations
Manual need to know how to get rid of blue red and green lines/markings through out my picture some one messed with my tv knobs on inside... And now I cant get it back how it was and I dont have a manual
All service manuals for these are online and only available to authorized service centers.At your own risk: with set on in cable band: 062597 status will take you directly to convergence tech menu--be careful what you do and if not sure do n ...
Philips Projection Televisions
I disabled remote for soyo sytpt3227ab and get it to work? get on menu manually ,get to reset default and cant enter code(which i dont know) with out remote! cant get cable remote or universal remotes to work!?
Soyo SYTPT3227AB 32 in. LCD TV
I pressed the sown arrow on the remote and it switched to cable one and now i cant get the picture back. How do i get it back?
If I understand what you're saying correctly, I believe that you change the input on your television.There's a simple, yet strange way to get your picture back.Press the input button until you get your picture again. It's strange but it w ...
Sharp Aquos LC-52SE94U 52 in. LCD HDTV
Proscan tv i got the tv on a channel i cant get off of and also the remote dont work. i need the tv back on tv and instead its on hdm12 and cant get off it. i have tryed all the bottons on the side of the tv and no luck so now i have nothing
It sounds that the main system control section circuit have the fault. Contact any technician. ...
Proscan Flat Panel Televisions
Zvox 580 I had a problem with my zvox 580. i had to reset my att uverse by unplugging it and then plugging it back in to reset. when i put the plug back in ( this plug has the zvox, tv, dvd, and uverse box all on one, so all went off then all came back on except the zvox. i cant get the power back on to the zvox.
can you help me?
ZVOX ZBase 580
Big screen zenith pvy6067dt dont have any manual and tv and dvd will only work on pip small pic cant get the full screen to work and dont know how
Try to look up the instructions on the enternet ...
Zenith Projection Televisions
Cant get my ilo tv to turn on i dont have a remote and cant program one because the tv has to be on to program
Does the TV have a standby light on? If not replace the power supply. If it does then replace the main board. ...
iLO 3200 32 in. LCD Television
I have lost the manual and cant find one online anyone know where i could get one for free?
What is the brand name and model number of TV do you want manual? ...
Flat Panel Televisions
No Signal Watched a DVD, when we switched back to watch TV there was no picture and it said no signal. I tried another TV to make sure the problem was not the antenea or the cable. All checked out fine. It did this once before and we found all the stations were one point off, for example 10.1 was now 10.2. We manually restored all stations and all has been well until now. I have tried many things and I can not get a picture back. In diagnostics it says my signal strength is zero. Thank you, Greg
Have you checked on all inputs including the rear audio and video jacks? ...
Sony KDF-50E2000 50" HDTV
I have a sanyo dp46848 46 inch lcd flat screen. It started messing up by half the screen having a dark tint. I was told it was the main board. I ordered one and told them it was a 1AA4B10N21300 with N6EE on the tuner. once I receved the new board and installed it the tv would not even come on, I then noticed the number on the tuner was N6ME. This new board also has a place for a plug the old one dont. could this be why it will not turn on? And yes i can put the old board back in and it will come
Yes, you need the proper board. the n6me is a different out put than the N6EE ...
Sanyo DP46848 LCD TV
I have a Hitachi 51F510. When I power it up it clicks like it always has and the power indicator light in the front comes on but it has no picture or sound. The remote will power the unit on but after a few seconds it wont power the unit off. I opened the rear panel and only saw a green light on, dont know if there is suppose to be more than one light inside. Any help on where to start would be greatly appreciated. the internals are filthy, going to get a can of compressed air while I wait a rep
You need to follow power cord inside the set; should be a board on right side it goes to----this set uses up to 3 small black relays---one or more is bad---tap on each until power light goes out.if questions let me know. ...
Hitachi 51F500 51" Rear Projection HDTV-Ready Television
Tn61x81 My screen has a horizontal black arcing line across the top and bottom of he screen. The bottom is worse. It almost covers 1/2 the screen. I changed the convergence chips with no luck. I can tap on the side of the set and it works for about an hour, then it comes right back. Also, I have tried to get a service manual for this tv and cannot find one, any suggestions on how to fix this problem would be greatly appreciated.
Toshiba TN61X81 61" Rear Projection Television
Hi there,, i have a fine 27in akai tv, i have owned it for some 4 years now, model number is LCT 2701AD, with the factory remote MODEL KC02-A2...but somehow i inadvertantly with the afore- mentioned remote, set the tv picture up so it rolls on the left and right sides, and it distorts/stretches figures on both sides as things get close to each side, i never got an operation manual with this tv..so i dont know how to bring the picture back to the normal way it was before i got stupid..thanks for
Akai LCT2701AD Television
I put the key lock on my digitrex tv/dvd model no. CDF2271. i cant get the tv lock off can you tell me how i have also lost my remote control i bought 2 universal ones but they dont have the code for my make tv please help thanks
Flat Panel Televisions
I have just purchased a new 26 inch TV, full HD version, from Curry's. It was purchased to use with my new BT Vision + box. O have tried to get my BT vision remote to work my TV but all the codes offered by BT don't work. The man at Currys says check the Logik website but can I find one, no.
The BT vision box says if you can't find the code refer to the manual, nothing there regarding 4 digit codes, hence my trip back to Currys. Whilst not life or death it would be nice to control the TV and
You mmight try looking at bt answer forum on same subjectvarious code options herehttp://community.bt.com/t5/BT-Vision/Codes-For-Logik-Tv/td-p/364531 ...
Flat Panel Televisions
my name is jean , one day i was looking at tv my tv made a click noise and turn it sel off and the next day when i tried turning it back on it would not come on and cant get it to turn on every since.
May need new caps on power supply board..............\015\012\015\012cheers ...
Digital Lifestyle FA1B32Z 32 in. LCD Television
My Zenith DVD/VCR Model No. XB 713 skips through the dvds when playing. It has very low usage. I use my disk cleaner multiple times when this happens, which helps somewhat. I use a CD Laser Lens Cleaner (Best Buy said that this was "the same" as a DVD cleaner). Does the reader mechanism need to be manually cleaned? Anything I can do personally to get its performance back? I have the same system in my work room and that one has never given my problems.
Flat Panel Televisions
My tv is an old rca tv, i have a dish network remote, one of the kids locked out the tv and i dont know how to get it back on, it wont tell me a anything all i can do is change the tv with the remote, nothing else what can i do??
If I read your post correctly it sounds like, the remote no longer works the volume or power for the TV set. If this is correct follow the steps below for a Power Scan. If this is not the issue or the steps don't work feel free to contact me and we w ...
RCA 32F531T 32" TV
Just changed my old tv for a samsung LE37R87BD put all the conections in the back correctly but i cant get my sky signal,all i have is a cable running from the back of my sky box to a red eye so i get the same channel as the tv down stairs it should be straight forward but i cant work it out. please help
Select the menu and picture then select the I/R socket number.That will select the infra red signal from your Sky box. A bit like selecting the AV input. ...
Samsung Flat Panel Televisions
THIS TV WILL JUST SHUT DOWN WHILE WATCHING, FIRST IT WAS JUST EVERY SO OFTEN AND I THOUGHT IT WAS CABLE. IT WOULD GO OFF THEN COME RIGHT BACK ON, BUT NOW ITS HARD TO GET IT TO COME BACK ALL I GET IS THE CHANNEL # ..IS IT TIME TO GET A NEW ONE,,ALSO WHEN i TURN IT ON IS DOES A LOT OF CLICKING...PLEASE ADVISE
Now tv turn on have the power LED light indication flashes and tv making clicking noises?The tv power supply board is mostly the causes,that the board,where the power a/c cord plug into it.Try website like Ebay.com to buy a refurbish power supply boa ...
Panasonic TH37PX60 37 in. Plasma Television
Sizzling,smoke,sparks ...horray. Tv starting making a sizzling sound. Turned it off then back on later to see if i could figure out area of tv the noise was coming from and make sure it wasnt just a speaker getting fuzzy. Bright flash came from top left of back of tv and smoke came out. Ive had the tv for 2 years, im 3 weeks over my warranty (of course right?) Now there is no sound or picture. Easy fix? Worth fixing or get a new one? Oh also took the back off to see if anything was noticably bur
Thats the Inverter board. Your model used several different types which are not interchangeable. You can get the correct Inverter Board for your model by contacting the guys over at ...
LG 32LD450 32 In. LCD HDTV