Having problems with your Flat Panel Televisions ?

I have a Philips LCD TV 42PFL9803H my problem is tv not power up and waiting aproxsimitly 10 hours later turning on. first push to power button led blinks and extinguished What can I do this problem .best regards



Answers :

Repair Help & Product Troubleshooting for Flat Panel Televisions
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

I have a Philips LCD TV 42PFL9803H my problem is tv not power up and waiting aproxsimitly 10 hours later turning on. first push to power button led blinks and extinguished What can I do this problem .best regards


... Philips 32PFL5403D/27 32 in. LCD TV

Recently my benq mp620p projector stop working. When I connect the power cord the power button lights up green and the power led orange as usually. When I push the power button, it starts to blink in green, the filter wheel starts to spin and the lamp starts to warm up with some light comming out. Few seconds after, the fans start, the power led becomes solid green and the lamps goes of. I can't do anything else since that other than unplug the power cord. No response to any button. Any help?


I'm assuming that you have checked the bulb and it appears ok. Either the inverter/ ballast board has a fault or , much more likely, the control board is no longer capable of finishing the loading of the firmware. This is usually caused by the failur ... Flat Panel Televisions

My panasonic flat panel tv with model no. TH-L32c20x has a power problem.. i push the manual button on tv side,the red light is on..then second is the remote power,the green light come and blinking 20 times,then turn to red light blinking slowly, the power not goes in, i unplug and plug again,try the same way its not working..


... Panasonic Flat Panel Televisions

What's your problem? Tv wont turn on the little red light next to the power button is blinking Turn it off two days ago to sleep and in the mornin tryed to turn it on and nothing i try pushing the


What is the model of your tv? ... Flat Panel Televisions

Usevally after power off to the tv for about one hour, if i switched on the tv, the standby LED of the tv blinks about 5 to10 minutes and the same time tv will not on & the remote also does not function.after blinking of LED is stoped ,now i can ON the tv by remote (or) by tv buttons. tv will be working fine . again if i switched OFF the tv for about one hour, same problem will be repeated. resulting i have to wait about 10 minutes to switch on my TV which result incinvenient to me.


It most likely is a error code indicating something is not quite right in the power supply of the set----I would suspect it to be a puffed up filter cap and if so the wait will gradually get longer until the set will never turn back on. ... LG Standard (CRT) Televisions

I have a sony tv monitor model KDL-26U2000, when you press the power button the red power led blinks for sometimes, but no power. what should i do to solve this problem?


... Sony KDL-26U2000 26 in. LCD Television

I got problem on my LG TV CA-20S90T, when it power on or press the power button, led for indicator blinking and the power could not turn on.


REPLACE EHT AND HOUT IF UR B+ IS OK ... LG Standard (CRT) Televisions

I have a panasonic plasma tv model TC-P42s2,when push the power button to turn it on the red light on the front blinks a few times and then you hear the power shut off. whats the problem and how do I fix it?


I see so many here with no sound/nopicture issues:ISSUES: 1. IF sound main fuse/s are good.2. If no power or standby check main fuse, standby power supply and any signsof damage you can see---burnt parts etc.3. almost all thes ... Flat Panel Televisions

I have a a mitsubishi WS-5531 it will not turn on, when i push the power button i hear a click and then the green power LED turns on then it blinks for a few times then I hear another click as if the TV just turned off


... Mitsubishi WS-55313 55" Rear Projection HDTV-Ready Television

Hi, I have a sony DLP Mod.# 46E2000, the tv. gave me the autodiagnostic that the lamp is near to die, the tv.tun off after few minutes, so I replace the lamp, and the tv. woks fine for about 20 or 30 minutes, but same problem appears,I verfied to put correctly the lamp cover and yes,the lamp cover push the sensor in rigth way. The led power blinks 3 pause 3 times. what do you think is the problem?


Hi,The 3-blinks, means the lamp is not seated properly or the door cover \015\012has not been latched. There are sensors on the lamp door and the \015\012position of the lamp in the unit.Remove the power and let it \015\012co ... Flat Panel Televisions

Hi...I have a Sony WEGA KV-29M91 that is very difficult to turn on. When I try to power it on the stand by timer light blinks 6 times then stops the repeat for another 6 times. Aventunally the TV does come on after repeated pushs of the power button. What's problem? Can some please tell it this something that I can repair or do I need a service person...Thank you in advance...Amir


... Sony WEGA® KV-XR25M80 TV

I have a sharp aquos lc-c5277un. Both the power and OPC lights together blink twice. I tried unplugging it, holding down the volume up and channel down buttons while plugging it in. That left me with a solid power light on. I pushed the power button to turn it off and it turned off. Pushed it again to turn it on. It turned on and worked. 10 minutes or so later I heard a pop sound and the lights started blinking as before. This loop has played out three times. Is this the power board or


... Flat Panel Televisions

TH50PZ80U two blinking lights when attempting to power on, if power button is pushed and held for several seconds after initial turn on blink code turns to ten.


I see so many here with no sound/nopicture issues:ISSUES: 1. IF sound main fuse/s are good.2. If no power or standby check main fuse, standby power supply and any signsof damage you can see---burnt parts etc.3. almost all thes ... Projection Televisions

When I hit the power button on my Toshiba 36AFX61 tv, or when I hit the power button on the tv's remote control, the tv's power switch button LED comes on but I get no picture or sound. And, the power button LED starts to blink after about 4 or 5 seconds. Also, at the time power is applied to the TV, I can hear extra relay contacts clicking that normally cannot be heard when the tv powers up correctly.


... Toshiba 36AFX61 36" TV

TV remote on my model TXL2791F won't turn TV on. When I press the power button on the TV itself the little timer light blinks and the TV makes a ticking sound for a few seconds. If I press the power button again the blinking light and ticking sound happen again for a few seconds. If I repeat pushing the power button on the TV again the blinking and ticking will then go on all day long unless I unplug the TV for 15 minutes or more. All during this time the screen is dark. Just before this ha


... Samsung TXL2791F 27" TV

I have a Runco Pl-42 plasma Tv. when i push the power button, there is a black screen and the red led blinks. i think it needs a new main board! where can i buy one?


... Runco PlasmaWall PL-42 42 in. Television

Led blinking five times when pushing power button


Visit the site named 'Electro-help' for more\012details. Check this ... Samsung PPM42S3 42 in. Plasma Television

My tv (46in led) wont turn on. the power button blinks red on the tv rather than remaining the solid red when on standby. what is the problem? it is not a burn fuse or anything?


\012 \012 \012 \012 \012 Hello,first, ... Insignia Flat Panel Televisions

Samsung 6100 LED blinks red twice when i push the power on button but wont turn on


... Samsung New 46"" Class 45.9"" Diag. Led 6100 Series with Smart TV"

I have a sony TV model KV-28ls36u, the problem was, when power is turned-ON, the LED blinks 11 times, what would be the best solution for this and where can I get a service Manual. Please help. Thanks


Usually after 4 or 5 yrs EHT ( transformer that supplies voltage to tube ) becomes weak - then TV won't get ON.. means no picture no sound but LED blinks - in some TVs along with EHT 1 or 2 components like resistor, transistors, etc will also gets ... Sony FD Trinitron WEGA KV-32FS120 32" TV

50pfp5332d got this tv not working. found no power when conected and decided to remove back cover. found blown PCB fuse and replaced it,turn the tv on and the picture came on for 10 seconds and when out but tv was still on since the logic board led was on,also noticed led on PCB started blinking. pull power cord off and then plug back in turn power button on and got picture for 10 second PCB relay clicked picture died and led on PCB started blinking again. what do you think?bad PCB or ba


Hello\015\012The power regulator PCB has some fault it it. It does not outs proper regulated voltages needed to the other PCBs in your TV. Normally Plasma TV power regulator PCBs are very difficult to repair, and PCB as whole should be replac ... Philips 50PFP5332D 50 in. Plasma Television

I have LG LCD TV Model No: 22LF12R. The problem is the TV fell face down when it was still powered ON. Now when you switch it on the power LED comes on but there is nothing on the screen. When you press the remote control the LED responds or it blinks and when you power off on the remote it goes off and when you power on it comes on. The problem now is there is no display on the screen. There is no voltage in the display unit. Which components shoul I change. Hope u reply soon.


In my experience, there will be damage to the main pcboard, usually under the transformer.If you are lucky you can find all of the broken track and remake the track.Good luck. ... LG Flat Panel Televisions

I have a Samsung LN40A550P3FXZA that is giving me problems. When I first started noticing problems I would turn the TV on and I would hear the power-up sound, the backlight would come on and then the red LED would flash a few times then the backlight would go off and it would repeat (power-up sound---backlight on---LED flash---backlight off). It would do this several times. Sometimes I would be able to get picture if I hit the source button on the side of the TV when the backlight first came


Try Samsung parts. They will almost always have the parts. As for the price. Its either 175$ for the board or a new tv. You have no other option ... Samsung LN40A550 LCD TV

14 blinks So my 42" viera smart tv that I Purchased about a year and a half ago will not turn on. When the power button is pushed the red light comes on and nothing happens. If I hold the power button after that it blinks 14 times. What would you suggest?


Communication\012error DG Board with IC8001 (Pesks Lite 2) is the fault. To follow, you must have sound in electronics. If you have, check http://electronicshelponli ... Panasonic Flat Panel Televisions

My optoma pdp50 plasma screen will not turn on. when you push the power button the led turns green and then you hear a click and the led on the power button turns back red


... Optoma SP50A 50 in. HDTV-Ready Plasma Television

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || fullblownbass.com || Terms of Use || Contact || Privacy Policy
Load time: 0.2327 seconds