Having problems with your Flat Panel Televisions ?

PLASMA Model # TH - P50VT20A The red PWR light is flashing, It will not respond to the remote, the remote has NEW batteries and works BUT the TV power on swith on the side of the TV is in the ON position, if I turn the TV power switch off/ON the TV starts but only goes for about one minute!! I tried to reset the auto tuning, it starts tuning then when the first channell is selected, THE TV TURNS ITSELF OFF., with the RED power light flashing 11 times, pauses then repeats the flashing sequence a



Answers :

Repair Help & Product Troubleshooting for Flat Panel Televisions
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

PLASMA Model # TH - P50VT20A The red PWR light is flashing, It will not respond to the remote, the remote has NEW batteries and works BUT the TV power on swith on the side of the TV is in the ON position, if I turn the TV power switch off/ON the TV starts but only goes for about one minute!! I tried to reset the auto tuning, it starts tuning then when the first channell is selected, THE TV TURNS ITSELF OFF., with the RED power light flashing 11 times, pauses then repeats the flashing sequence a


... Panasonic Viera TH-50PZ800U Plasma TV

My panasonic 1080i will not turn on. Hit the power button and the light starts flashing green but nothing happens. After about 20 seconds or so the light goes back to red and flashes. Nothing works on the remote now. I bought this from Sams club as a close out as it was the last one (floor model) and did not have the manual. Have not seen any solutions to this problem as of yet. Please Help! W have not TV and are paying for service now.


... Panasonic PT-50LC14 50" Rear Projection HDTV-Ready Television

ViewSonic PJ503D Power light flashes orange, lamp light solid red. It starts powering up, the power light flashes yellow for a minute, then green for a minute, then flashes yellow again with the lamp light solid red, before powering down. The lamp has at least 50% of its life left. I pulled the lamp and made sure the filaments were intact. Any help would be much appreciated!


... Projection Televisions

I have a Viewsonic N3260w TV, the Power Indicator light is flashing red continually, but the remote wont start the tv, I have changed the batteries, turned the tv on and off, but the tv still wont start? What do I do?


The problem of your tv is in the power supply. In order to find the power supply of your tv ,you should follow the ac cord. But first you should unplug the unit and open the back cover of your tv there you will find the power supply, try to check the ... ViewSonic NextVision N3260W 32 in. HD-Ready LCD Television

I have 50 inches plasma Hitachi TV (ALiS 1080HD). As the TV was on, the screen stopped showing (no picture) and no sound could be listened as well, without any reason. The power light started flashing (on and off) so I turned the TV off from the power supply (as the remote control was not responding). Few seconds later when I turned the power supply back on for a moment I heard a sound (making me believe that the problem was fixed) but once again the power light started flashing with the same en


... Flat Panel Televisions

My TV was working and then all of the sudden the screen went blank and now there is a flashing red light that appears. I tried to turn everything off and back on (the universal solution to everything) but when i power it back on from the TV, it first shows the blue power light and then goes back to red flashing light


Hello\015\012\015\012There is something confusing the system control of your TV and it should me resetted. To reset it, just switch OFF your TV with its front panel power control switch, and after that, unplug the TV from the wall socket ... Philips 37PFL5332D 37 in. LCD Television

My loewe Concept L32 shows the red power light on and flickers when I try to turn on via the remote control.......ie the decoder is not starting up. any button I try with the remote the red light flickers but no response from the TV. I have just installed a Topfeild set top box to receive HD and that and the TV was working perfectly. I have tried disconnecting the Set top box and ussing the TV by itself also turned off the power at swich and tried again.all to no avail. Regards, Colin Sh


Http://elektrotanya.com/loewe_chassis_l2650_concept_l26_l32_basic_sm.pdf/download.html\015\012\015\012\015\012\ ... Loewe Concept L32 Platinum 32 in. LCD TV

The power on/off mechanism does not work (on box or remote) properly. Started with having to press button many times -- green light goes on 2 sec then goes back to red -- before the screen would come on. Now the green just flashes but screen never comes on.


U have all the tools and understanding basic electronic also can do soldering work?Take the tv aparts.Tv have power supply board problems issues.That the board where the power a/c cord plug into it.Check the power supply board carefully for dying com ... Coby TF-TV1913 LCD TV

Hi, my panasonic tv power light flashes green, then it turns to orange flashes 7times then stops and starts again=orange and repeats itself by flashing orange 7times over and over , Again This is the power button light, not to mistake it for the lamp light which I know when that goes bad it is red not the case here, I'm a pretty good do it yourselfer when it comes to electronics if it is a job I can tackle,what to do what to do? Thanks,Mike


... Panasonic PT-56LCX66 Television

WhaWe have a Panasonic Model TC-P42G25 TV. We were watch the evenings when all of a sudden the tv went out and the red power button was blinking. I thought I heard a snap but an not sure. I unplugged the tv for about 10 minutes plugged it in again, the light was out. When I used the remote to start it. The red light started blinking again. I also noticed that when i plugged it in I you could hear it what i would say energize the circuits. No response other than the blinking red light.


The blink code asked for by another expert would help--but if you heard a pop and the set is out commonly this is the POWER supply board in the set failing--not unusual.Individual parts are not sold for these sets and generally this will be a ... Panasonic TCP42G25 42 in. TV

Digihome TV TV randomly starts flashing the blue and red light in the middle of the night. The way to stop it was to turn the TV on and off, but up until recently, this solution hasn't worked. Whenever I now turn the TV on and then off, it continues flashing the blue and red light. The only way I can stop this now is to turn off the power socket, however this is annoying considering it always happens at around 3:00 in the morning. How can I stop it from flashing altogether? I need help desperate


... Flat Panel Televisions

We have an NEC LCD TV model number NLT-32HDB2. It has been working fine, and I turned it off with the remote last night as usual. This morning the red light below the screen was flashing, and the TV wouldn't start. I turned it off at the wall, waited about 30 seconds and turned it back on. Rather than the single red light, an orange light was flashing, and the TV wouldn't turn on.


Hello,If your TV won't turn on, then it means it having a power problem. it might have worked fine in the past, but that's electronics for you. Power surge, irregular power supply, excess power supply, etc can affect the unit thereby not ... Flat Panel Televisions

When you turn of the TV the POWER indicator flashes green for several minutes. The TV never comes on. After the several minutes of the POWER indicator flashing green, it stops, I hear a click and the light goes out. Within a few seconds, the LAMP indicator light starts flashing red continuously. I unplugged the TV and waited one hour to remove the lamp. I could not tell if the lamp was blown. I can see the filament, the glass is clear, but there is a 2 cm or less spot in the right upper c


Sounds like the lamp door is not secured in place. Try removing the lamp door and put in back in until it clicks. ... Panasonic PT-52LCX66 Projection Television

My Sharp Aquos LC-60LE847U lcd TV has some kind of controller issues. At times when we turn the set on using the remote, the indicator light will light but the TV never has sound or picture. It never "turns on". Then when you try to turn the power off, neither the remote nor the manual switch on the set does anything. If you fiddle with the power enough, the indicator light on the bottom bezel of the set will start flashing 3 blinks then one blink and keep repeating that. Unplugging the set


... Sharp Aquos Flat Panel Televisions

I have a TH50PX60U with the red light flashing 10 times. I went through the diagnostic flow chart to where it said replace the PA and DG boards. I replaced both and still have the 10 flashing lights. SInce that flow chart didn't seem to work I started checking the feeds from the power supply. I noticed on the PA10 that as soon as I plugged in the AC, the voltage read 15V. Then the voltage started dropping fast and went down to zero. Is this normal or should the voltage remain at a cons


... Panasonic TH-50PX60U 50 in. Plasma HDTV

I have a Samsung LN40A550P3FXZA that is giving me problems. When I first started noticing problems I would turn the TV on and I would hear the power-up sound, the backlight would come on and then the red LED would flash a few times then the backlight would go off and it would repeat (power-up sound---backlight on---LED flash---backlight off). It would do this several times. Sometimes I would be able to get picture if I hit the source button on the side of the TV when the backlight first came


Try Samsung parts. They will almost always have the parts. As for the price. Its either 175$ for the board or a new tv. You have no other option ... Samsung LN40A550 LCD TV

At first had 7 red flashing light but not somehow i got the green light to come on at power up but still do not have sound or pisture a cling sound goes off twice t power up and right after power up what is wrong with my tv? and is there a power supply on the power cord?


... Philips 50PF9731D/37 50 in. Plasma Television

Model:Philips 42PF9965 Plasma At switch on the green light comes on for a few seconds,then it goes off and the red light starts flshing.After several attempts the tv may come on live and stay on until you switch off.The two relays on the power supply board heard to be clicking on and off during the time the red light is flashing


You might have some swollen capacitors on your power supply board. They will be easy to spot out, because they will not have flat tops like the rest of the capacitors. Replace them with the same rating cap ... Philips 42FD9954 42 in. Plasma HDTV

My sharp aqueous LC42D83X tv won't stay on. It has a red power light and green OPC light flashing. I press the on/ff switch and t starts but turns itself off or back to red/green flashing lights? Can u help please?


... Sharp Aquos Flat Panel Televisions

When the power is turned on, the red indicator light flashes continually. It will not go to solid red. There was a clicking noise from the back of the set, which stopped shortly afterwards. I have pressed the on button on the remote, have turned it off at the wall and left for ten minutes and retried, still same result. It continues to flash red. Is there anything I can do or is it a service job ? Hope you can help. Jeremy


Sounds like your capacitors are bad. Samsung will replace them for free if you call them at 1 800 Samsung. ... Flat Panel Televisions

I have a 6 year old Magnavox 50 in DLP tv, model # 50ML8105D/17. When you power it on, the green light first comes on then after a minute, changes to two red lights, and the red light on the left sometimes flashes anywhere from 13-20 times. The picture never comes on, any idea on how to fix it or whether its worth trying? Thanks for your help


Sounds like a simple bulb replacment, I recomend DLP lamps .com, they use genuine phillips lamps and have a six month warrenty it is very easy to do and only takes about ten minutes, look at your manuel it has the step by step instructions and if you ... Philips Magnavox 50ML8105D 50" HDTV DLP TV

Turn power on light turns on picture comes on then no picture and the red lamp light and blue power light start flashing


... JVC HD-61Z585 61" Rear Projection HDTV-Ready Television

Telefunken tled-26fhdp will not switch on, red power light is flashing. What can I do to get the TV to switch on? I have tried pushing the power button on the TV itself as well as the remote.


... Flat Panel Televisions

I bought a panasonic pt-50lcx7k tv. i press power and it starts to warm up(green blinking lite and i can hear fn kick in ) but no picture and green light flashes for about 5 min then powers off and i get 2 blinking red lights. is it worth taking in for repair?


Theres a problem on the board of the tv set jsut go back to the service center for further check up of of the technician of the panasonic un plug the tv set for it can cause further damage ... Panasonic Flat Panel Televisions

I have a panasonic th-42px70ba tv with the red light flashing 10 times after power button pressed, it clicks 3 times and the fault code start reading on the standby light. I have replaced the main power board and fault still there, any sugestions or a way I can diagnose the fault.


... Flat Panel Televisions

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || fullblownbass.com || Terms of Use || Contact || Privacy Policy
Load time: 1.3781 seconds