Suggested Questions/Answers :
It is recommended you read all this kind of situations
I have A Hitachi 42In Plasma Tv model # 42HDT79 The blue light is blinking continuously and in the back of the set on 5 error code lights the third is lit green the 4th is lit orange screen is lit but no video or audio. Ithink it is probably the main board. I would just like to hear some iodeas or opinions. Also, none of the buttons on the side of the Tv work.The 2nd error code light will occasionally come on and when it comes on the blue power light will stop flashing but then it goes right b
Main board is possible but power supply board should first be tested. ...
Hitachi 42HDT79 42 in. Plasma Television
Lg nano plasma mini split. Green light blinks five times then pauses, repeats. Same for all three units. Can't find error codes. What does this mean? Thank you
My toshiba 50hpx95 has a steady blinking red light, it has no pauses or breaks to recite a code, just steady blinking. I had it in the shop and they said the power board needed replaced, so i replaced it and still get the same code. Is there a trap reset, or other mode of reset that i am not finding in the "service" manual, or was the problem misdiagnosed by my repairman. I cant even do a boot via service code thru the remote. is there a way to do a soft boot under low voltage so the chip can gi
This tv have a Tuner signal board it is also dead too,this problems happen sometimes,the power supply board dies,but sometimes the Tuner signal board take power surges from the power supply board itself than kiill the tv Tuner signal board too.Try we ...
Toshiba 50HPX95 50 in. Plasma HDTV
Mitsubishi WS-55809 tv has a 2-3 error code, what do I need to check. I previously had a 2-2 error code and replace the two pico fuses and the two convergences. When I put it back together it powered up and could see it was working on the screen and after about a minute or two, two lights lite up with the exception of the red and then set shut down and just has a clicking noise. Could you please tell me what to check next?
Mitsubishi WS-55809 55" Rear Projection Television
TH50PZ80U two blinking lights when attempting to power on, if power button is pushed and held for several seconds after initial turn on blink code turns to ten.
I see so many here with no sound/nopicture issues:ISSUES: 1. IF sound main fuse/s are good.2. If no power or standby check main fuse, standby power supply and any signsof damage you can see---burnt parts etc.3. almost all thes ...
Hi, my Panasonic Viera TH-42pv30 goes into standby by blinking with a 4 quick blinks and then a long solid blink.
Ive been investigating this issue on the internet and have come across the blink error code 4 blinks Power SOS P Board.
Ive disconnected all other devices connected to the plasma TV and changed power outlets however the problem is getting worse. The TV wont stay on for more than a minute now.
Do you know what the problem can be and an approximate cost to fix it?
The TV is no long
Panasonic TH-50PV30 50 in. Plasma Television
I have a mitsubishi 735 series dlp tv. Has red blinking status light. The error code was 4 blinks then two blinks. Do you know what is wrong with it?
That's the error indicating the lamp/ ballast fan has stopped working. You can get the Mitsubishi lamp / Ballast fan 299P321010 used in the V39 series DLP televisions. It comes with installation instructions and is available from www.tvrepairworld.co ...
Mitsubishi Projection Televisions
When I turn my tv on, it takes any where from 7 to 15 times before it will stay on. When it shuts itself off, the amber light blinks one long blink and six short blinks... don't know if that could be an error code or not...
Hi:\012This is an indication of faulty capacitors on the power sugpply, check the power supply for puffy top capacitors that look like they are about to burst on their tops, ...
RCA L32HD31 32 in. LCD HDTV
My JVC XV-N670 DVD player abruptly started giving the error "Check Regional Code" when some discs are inserted (which discs previously played). I can find no setting in the options to control or change the Region. (I recently had visitors staying at home and I'm wondering what they may have changed!)
Is there any way to reset the regional settings on this player?
You\012 could try these two but there not for you specific model. There the \012closest models to yours i could find codes for. I hope they work for you.\012 If they don't look on dvd365.net for another code closer to your \012model.\012 ...
JVC GDV-P420UG Television
I got a Sony Bravia KDL-40WL135. Blank screen. There's two LED lights: red standby and green power light.
When I turn on the TV, green led comes on, then after about 30 seconds red led blinks once, then green resumes. The green led stays solid. I think that's a SONY error code, I tried to look it up but can't find anything useful.
I have replaced the power supply, AU board, backlight inverter, logical board, and the second power supply board.
Any suggestions? I haven't checked the t-con bo
Http://www.smpcshop.com/KDL-40WL135-KDL-46WL135-p-8895.html\015\012\015\012\015\012\015\012Above is a link for a service manual.\015\012 ...
Flat Panel Televisions
I have a Panasonic TH50PZ77U plasma. (1) recently the unit would power off, without warning. (2) The power light blinked several times two nights ago, but finally came on. (3) Last night, no power light on the front of the unit, and it will not turn on. The unit is plugged into a surge protector and all other components plugged in are operating correctly.
I have read through several forums on similar Panasonic models, and a "power supply" failure seems to be way to common.
Its probably the main filter capacitor thats gone on the power supply, (sorry for mentioning power supply again but it is actually a power supply problem) If you are good at soldering then you can replace yourself, Google Panasonic capacitors and th ...
Panasonic TH-50PZ77U 50" Class Plasma HDTV
I have a Mitsubishi wd62327 the red status light blinks 3 times then pauses. No I can't get error code because it won't do anything else! Ideas? I think I may have a bad light engine. Fan? Hmmm
Mitsubishi Projection Televisions
My Panasonic Plasma (TH-42PZ80U) shuts off and say an error has been detected and recovered. The red power light blinks 10 times and will do this repetitively. It will eventually spewer up and then shut down again with error message.
Panasonic VIERA Flat Panel Televisions
Internal circuits My tv speaker cable is disconnected since I run my sound through a Panasonic SA-BT300 sound system. I have had this set up for a long time with no issues until a week ago. My tv gives me this error message, " internal circuits are turning the tv off. Could be a short in the speaker cable." then it turns off, and the blue LED light in the corner blinks five times, pauses, and blinks five times again. The tv is wall mounted, and there is plenty of space for heat dissipation. Any
Pioneer PDP-5020FD 50" 1080p KURO Flat Panel HDTV
I just got a Mitsubishi WS-A65 that has a issue, when I turn it on I dont get a picture, I do get some faint glow and some faint curved lines, I get error cod 1-2 which says no error and I have audio.
When I turn the set on the green light goes to solid with no blinking, I cant see any menus so I cant adjust anything.
Hi, if you have audio and any kind of a blank/darkened screen then you either have a bad video hookup cable, defective video input, or a bad backlight system-bulb or power supply to bulb is probably weak from symptom you described. Hope this was of s ...
Flat Panel Televisions
I have a panasonic TCP58V10 Plasma with a 1 blink error code that won't turn on. What is wrong? How do I fix it? How/where do I get a service manual? Where can I get parts? How hard is it to fix i
Panasonic TC-P58V10 Plasma TV
Pioneer Plasma Tv Throwing Code (11 green blinks on front lights) also on Screen Says (Thermal Alert Shut Down (11) )
Possible set is seeing a temperature too hot inside the set, can also be a fan in the unit if it has them it takes very little dust to slow their speed enough (dust on the fan blades). ...
Flat Panel Televisions
My Sharp Aquos LC-60LE847U lcd TV has some kind of controller issues. At times when we turn the set on using the remote, the indicator light will light but the TV never has sound or picture. It never "turns on". Then when you try to turn the power off, neither the remote nor the manual switch on the set does anything. If you fiddle with the power enough, the indicator light on the bottom bezel of the set will start flashing 3 blinks then one blink and keep repeating that. Unplugging the set
Sharp Aquos Flat Panel Televisions
Philips 50pfp5332d/37 won't power on...led light blinks 4 slow, 6 fast...i can not find error code 46 anywhere
Error 46Description Pacific 3Detected by VIPERDevice T6TF4HFGError/ Prot EThese info are for qualified service technicians. ...
Philips 50PFP5332D 50 in. Plasma Television
The Panasonic plasma model I have is th-50phd6. It links 7 times. How much to fix, you know labor, parts and time. I would like to see ido can repair it.
I bought the tv for the stand...do you know how hard it was to find a Ty-st05-k? Good lord... any ways found a deal for 100 I got a th-50phd6 and the stand. The gentleman that sold it to me gave me the 7 time red light blinking scenario. So if I were to fix it for minimal cost not only would this have been a deal but more of a steal.
The problem is most likely a bad SC board, if you can find the board online it will probably run you between $250 - $300 for the part. A repair facility will charge you between $400 - $500 total to fix the unit if that is all that is wrong with it. ...
Panasonic TH-42PWD6UY 42 in. HD-Ready Plasma Television