Having problems with your Projection Televisions ?

My panasonic 1080i will not turn on. Hit the power button and the light starts flashing green but nothing happens. After about 20 seconds or so the light goes back to red and flashes. Nothing works on the remote now. I bought this from Sams club as a close out as it was the last one (floor model) and did not have the manual. Have not seen any solutions to this problem as of yet. Please Help! W have not TV and are paying for service now.



Answers :

Repair Help & Product Troubleshooting for Projection Televisions
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

My panasonic 1080i will not turn on. Hit the power button and the light starts flashing green but nothing happens. After about 20 seconds or so the light goes back to red and flashes. Nothing works on the remote now. I bought this from Sams club as a close out as it was the last one (floor model) and did not have the manual. Have not seen any solutions to this problem as of yet. Please Help! W have not TV and are paying for service now.


... Panasonic PT-50LC14 50" Rear Projection HDTV-Ready Television

The blue power light is on. When i use my remote either the one that came with the tv or mt satilite remote to power on the tv. The blue light stays on, and nothing happens. It appeares to be stuck in stand by mode. My model is a 237 -t12 hd ready


There's a good chance you have failing electrolytic capacitors either in the power section or the inverter section or both.Any caps in these sections that look bulged at the top, or bulged/leaking at the bottom need to be replaced.If you ... Olevia LT37HV 37 in. HD-Ready LCD Television

LLOYD'S TV MODEL lcd1932 red light is on front of TV indicating it has power but when you press the power (on/off) button nothing happens. Unit is only one year old.?


... Flat Panel Televisions

I have changed out the H.O.T. and the flyback on my R52WH74 model tv because it wouldnt come on and it would make a chirping noise I checked all the fuses and capacitors now with the new parts in the green power button light comes on for about 2 seconds and then goes off with a low pitch chirp it does this 3 times and then nothing i checked all fuses and capacitors again and found that 3 are not responding one is cp049, rp050 and cp050 could thiese be my problem or is it something else?


... RCA R52WH73 Projection Television

We were just watching tv and it just shut off. Now it won't turn back on. I already unplugged it and still nothing except for the green light will come on for a second then turn right back off. You can only use the power button on the tv not the one from the remote. This tv is a Sanyo 50" plasma tv model #dp50740


Now tv on,power LED light indication flashes?Yes.The power supply board is the problems and the causes.That the board,where the power a/c cord plug into it.Try website like Ebay.com to buy a refurbish power supply board for the replacement. ... Flat Panel Televisions

Hello, i have a samsung 42' plasma tv model #pn42c450b1d. the tv doesn't want to turn on. i plug it in and you hear a clicking noise se a red power light. also when you press the power button on the tv in the back u see a green light come on for a second on one of the circuit bords( the one under the power board) and simutanously you see a red light come on and and off at the same time on the circiut board with the av, hdmi, inputs. i looked and thier doesn't seem to be any bulging capaciters. a


Hi.As you know the TV is in protect mode because an internal fault has been detected. I think that you already tried leaving power cable disconnected for ten minutes. After connecting back restart the TV with no device attache ... Flat Panel Televisions

I have a samsung hlt5076sx xaa model and when I turn it on the screen is black and I have a blinking green light. Just one blinking light though-what does this mean??


I have a samsung hlt5076sx xaa model and when I turn it on the screen is black and I have a blinking green light. Just one blinking light though-what does this mean??\012 This trouble maybe power supply or inverter boards is defective.\012 first ... Samsung Flat Panel Televisions

I have a Sony KF 50 WE 610 projection screen TV. It has worked perfectly since I bought it six or seven years ago. This morning I turned it on and the sound came on for a second, but then the sound went off and nothing else happened for about one minute. At the one minute mark it turned off by itself and the red indicator light blinked 5 times in a row... paused... blinked 5 times in a row... paused... and then blinked 5 times in a row again. When I powered it up again, the indicator light blink


Hello\015\012Five consicutive blinks at a time and the stops and again blinks five; is its self diagonosis procedure. All modern Sony sets has this function included in its circuits. If the system control IC inside it detect any fatal fault ... Sony Grand WEGA KF50WE610 50" Rear Projection HDTV-Ready Television

Hitachi L32HO1UA hi we bought this tv. new watched it every night in bed for about 1 year then one night we went to bed, nothing no light no nothing, it was just out of guarantee, any ideas. please. we have tried replacing pcu/pcb still nothing.


... Hitachi Projection Televisions

Mitsubishi WD-73735 will not turn on and there are no lights on front. The power supply was replaced, and is brand new. I fix HDTVs, and have had very little problem resolving other issues with other TVs. This one is strange. Need help, please. When I plug it in, you can hear the PS get power, but nothing turns on. Tried the 'Menu' and 'Input' combination....nothing. Tried plugging it in, with the 'Menu' button pushed...nothing. I can hit the 'Reset' button on the


If you have no lights come on the front of TV, you definitely have a power supply issue. Don't know what previous servicer did, but I would be looking at ALL wires & connectors. ... Mitsubishi WD-73735 Television

I own a Olevia LCD tv- model number 242-S11. I have had the tv for several years with no problems. As I was watching a show today- it shut down. No picture, no sound, no blue standby light. I flipped the switch on the back of the tv off, unplugged it from the power source and waited several minutes. When I plugged it back in and flipped the switch, i seen the blue standby light flicker on and then back off. Still no picture, sound, lights, nothing. Repeated the switch/plug again, but disco


... Flat Panel Televisions

Vizio vo42lfdtv10a Turns on the vizio name light, goes from orang to white. In the back there is a blue light on left florescent driver board, It comes on for a few seconds and goes out. Florescent lamps never light and nothing on the screen. Has the 24 volt to lamp driver boards. Any hope for this one? Larry @ Centraltv


... Vizio VO42L 42 in. LCD TV

My JVC model. my JVC TV LT 42 EM 59 will not come on .I get no blinking blue light no power no nothing I get nothing I've tried to reset it in nothing


With no power it will not reset---if total dead unit you would have to first follow the power cord into the set to the line fuse it goes almost directly to---check the fuse first and examine the power supply board for damage or puffed up filter caps. ... Flat Panel Televisions

Have a mitsubishi 65 inch flat screen model 65735, I replaced the dlp chip because it went bad. I put it back together and now the screen stays dark blue with the timer light on green. I can still hear sound but my screen is so dark blue i can bearly tell its not a black screen. I rearranged the connectors and got different results, one time the lamp light was flashing orange, the other time when i turned the tv on it would turn right back off instantly with the lmap light orange and timer ligh


... Mitsubishi WD-65732 65" Projection HDTV

I got a model 27F485 from a bar that closed. Great picture but after a couple minute a black box appears at the bottom of the screen. Looks almost like a PIP but nothing in it. How do I get rid of


Look in the set menu under closed captions, there will likely be a setting there for "TEXT" IF FOUND SWITCH IT TO OFF.This is a feature a lot of sets had for books etc viewed but was never really used---the result a black box on the screen. ... Standard (CRT) Televisions

TV turned off by itself one day. I pressed reset, timer light blinked green for a minute, then I pressed power and it sounded like it wanted to boot up, but nothing happened and the status light turn


Two thoughts:First is this is a DLP set and the lamp may have failedSecond is it should have the self check which reads error codes---most of these sets that is the same:" After you turn on the set, and get the regular red bli ... Mitsubishi WD-Y65 65" HDTV

I have a Polaroid 2611-TLXB TV that was manufactured in September 2007 and recently, I turned it on one night and there was no screen at all. The blue power light was on though and I could turn it on and off with the remote but still no screen. I tried unplugging it and plugging it back in but nothing changed. I checked the back and there is a red blinking light.


... Polaroid 2611-TLXB TV

Dead tv Hi, I have a 50" samsung plasma tv that seems completely dead. 3 years old, the other day we heard a pop sound (sort of like the sound a lightbulb makes when broken) and then the power went off and never came back on. When you press the power button absolutely nothing happens, no sounds, no power light, just dead nothing. the model # is PN50A650TLFZC and the version is KX03. do you have any trouble shooting tips please? thank you


... Samsung PN50A650 49.96 in. Plasma HDTV

My RCA 42" model L42FHD37YX8 has no picture and no sound just a steady blue power light when plugged in, I tried unplugging it but still nothing just a steady blue light


... Flat Panel Televisions

Hi there. my teco tv is not working. the red standby light is on and when operated by remote or manual the green led light comes on and the TECO sign but nothing else works after and im left with a blank screen. Teco lcd tv Model: TA4296RV Serial no: MZ083C040165


... Flat Panel Televisions

My flat screen Mag, 42MF521D/37 turned off one night. Next day it won't turn back on ? Checked fuse but not the one with the white coating, nothing. With my TV spread around the floor HELP!


... Maxent Flat Panel Televisions

I am trying to hook up a gamecube to a toshiba tv. I don't know the model number but it has 3 inputs in the back and one in the front. I have tried all of them and tried changing the input on the tv to one of them but it only stays on tv. I don't have channel 3 and I don't know how to add it. I have unplugged the cable cord also seeing if that would work and nothing. Please help.


... Toshiba Flat Panel Televisions

I have a Panasonic 32 inch HDTV. TV worked great until one day tried to turn on and nothing. It acts like it has no electrical power. We have tried plugging into different outlets with no luck. The red light does not come up with pressing power. Tried remote as well, nothing. Any ideas?


One simple solution may be to replace the power cable or the power strip that the TV is plugged in to. If you cannot get any power to the TV even after this step, it is most likely a motherboard or some sort of circuitry issue. Make sure you are usin ... Panasonic Flat Panel Televisions

I have a 60ux55k rear projection TV, and like other posts, it just "died". The power light comes on, but no picture or sound. I unplugged it as suggested, but still nothing. All the LED's on the board light green, except one which is red. Without an actual schematic, I am guessing it might be the surge protection circuit and has remained "stuck". Is there a non-expensive solution? Is there a way to obtain a better manual than what was supplied when purchased? Are there any detailed schematics a


... Hitachi 60UX54B/55K 60" Rear Projection Television

40 inch ktv model ltw40eh1b. When plugged in the light the blue light will come on but when I hit the power button I hear a multi note tone and nothing else will happen. I can unplug it and can go through the process but same result. I have heard that it may be the media board and also have heard that it may be the power supply. Tthe thing is I cannot find a wiring diagram or also where I may be able to purchase these items. Any help would be greatly appreciated. Thanks


... Flat Panel Televisions

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || fullblownbass.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1353 seconds