Having problems with your Flat Panel Televisions ?

After on tv set in next two hour automatically picture go off then I have to get up and disconnect the power for the tv and wait for I minutes until off light come in tv then I turn on again than i


\015 It's a tv norscent 32" LCD Picture and sound go off every hour and half green light stay on but tv off , I have to get up and pulled of from the outlet untill ligh go off\015

Answers :

Repair Help & Product Troubleshooting for Flat Panel Televisions
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

When trying to turn it on the green light comes on the front, we hear a small zap sound, sounds like it is trying to come on and then the green light goes out... it will do this consecutively three times with one press of the power button. Then you have to wait 2-3 minutes before it will respond to the button press. We have done this for up to a half hour until the tv finally comes on. What is wrong?


Hello,This type of fault can be repair, it could be a short circuit on the panel power board, remove the back cover of the television in this you have to resolder the panel where you can find dry soldering, but if otherwise a common probl ... GE D52GW12 52" Rear Projection HDTV-Ready Television

The TV turns on and shows a picture that you can watch and within 10 minutes the TV loses its picture, however, the light is still green. If you turn the TV off you can get the picture to come back after you wait like 20 minutes or so but the TV will lose the picture again in 10 minutes or so. Any suggestions?


... Hitachi 42HDT52 42 in. Plasma HDTV

Every morning first start the picture does not come only the sound is Turn of then on it's ok but lately the tv will not even turn on Press on button either remote or tv the power light flickers for a couple of seconds then turns off again several attempts so Then I turn off power from wall gpo wait two minutes then try restart It does the same again but takes longer to turn off again until after More attempts it finally turns on but with no picture so turn off again then turn on and it's ok


The standby power supply has dried up capacitors, need to replace them, the tops have probably vented ... LG 60PY3D 60 in. Plasma HDTV

When you turn of the TV the POWER indicator flashes green for several minutes. The TV never comes on. After the several minutes of the POWER indicator flashing green, it stops, I hear a click and the light goes out. Within a few seconds, the LAMP indicator light starts flashing red continuously. I unplugged the TV and waited one hour to remove the lamp. I could not tell if the lamp was blown. I can see the filament, the glass is clear, but there is a 2 cm or less spot in the right upper c


Sounds like the lamp door is not secured in place. Try removing the lamp door and put in back in until it clicks. ... Panasonic PT-52LCX66 Projection Television

My Panasonic 61 inch projection tv will not stay on. I replaced the lamp, but that didn't resolve the problem. It will come on then picture and sound goes out. The green light stays on until I turn tv off. I wait for the red light to stop blinking, then turn it back on. It may stay on few minutes or few hours...HELP


... Panasonic PT-61LCX65 61" Rear Projection HDTV

After on tv set in next two hour automatically picture go off then I have to get up and disconnect the power for the tv and wait for I minutes until off light come in tv then I turn on again than i


... Norcent Technologies Flat Panel Televisions

JVC AV-36D502. Our TV has been on the fritz. Sometimes when we try to turn it on the power light just blinks. We have figured out if we wait a minute we can unplug the TV plug it back in and then the TV will function normally. Although it does take the picture a little longer to come up. Still looks fine though. Any ideas what may be causing this?


U have tools like a soldering iron,a roll of solders and know basic soldering work?Yes.Resolders the FBT-(the flyback transformer) the big black block of plastic with a red wire with a cap hook to the CRT-(tv tube).On the side wall of the FBT.Have a ... Standard (CRT) Televisions

When I turn the TV on a solid green light comes on for about a minute. I can also hear the tv is working just no picture. After about a minute the sound will go off and a solid red light comes on and stays on, the green light also went out at the same time the red comes on. Does this mean that it is possibly just the bulb?


... Mitsubishi WD-65733 65" HDTV

My television will not come on. The blue light comes on indicating that I pressed the power button to turn it on and then after several minutes of a blank screen it turns itself off and goes back to the red light.


Plasma and LCD TV sets are prone to having capacitors in the power supply section fail. This is the most likely cause for the probem you describe. When capacitors fail your will commonly see one or more of the following symptoms. ... Sharp Aquos LC-42D62U 42 in. LCD HDTV

I have a Panasonic HDTV 1080i. The Tv keeps turning itself off and the power light turns yellow and blinks. If I wait for 5 minutes and press the power button the TV turns back on and sometimes it stays on and sometimes it switches back off. The lamp light does not light up or blink just the power button. Any ideas?


Hi,I am sorry to hear regarding the trouble. However, there are few possibilities that could cause the same issue. If you have electronics repair experience, and wanted to diagnose / repair the set yourself, revert and i would be able to ... Panasonic PT-60LC14 60" Rear Projection HDTV

I have a Samsung DLP TV (model HLT5076S). When you turn it on there is no picture for several minutes (5-10 minutes) and then there is no sound once the picture comes on. You need to turn the TV back off & then restart it to get both picture and sound. Sometimes you need to do this several times before the TV turns on, you hear a click, and then you get picture & sound. It seems like it is waiting for something to warm up? The problem is not the bulb (fairly new) or with the electrical outl


This is because the CRT that is the cathode tube ray oscillator is taking time to warm up ... Samsung HL-T5076S 50 in. TV

I turn on the TV and it operates for a few minutes before the screen goes black and the red light starts flashing. I then have to wait a while to turn it on again. After it turns on again, it does the same thing after a couple of minutes as if it's getting hot and shutting down. (Sony Bravia KDF-50E3000)


Hi,Please count how many times red light blinks after 3 second long pause and let me know to find out possible cause of problem.How old is this tv? Thanks. ... Sony KDF-50E3000 Television

Okay, so last night my Hitachi 55vs69a starting shutting itself off. I could turn it back on after a few minutes and within an hour or less it would shut off again. This morning it will not turn on at all. The lamp and temp light were flashing but now the lamp light is the only light showing. It's not flashing, it just stays on. I just changed this bulb 2 months ago so it is new. I was told to reset the lamp timer but now since the t.v. will not come on, I cannot do that. The bulb has not bl


If you bought a cheap non Hitachi lamp that could be bad and look fine.I would remove the lamp and look at it and reinstall it making sure it is in properly----what was wrong with the old lamp? Did it still work at all? ... Projection Televisions

Sony tv kdl-46vl130, Turn the tv on, half of the picture is dark, leave the tv on for about 20 minutes, and the tv is perfect, and stays perfect no matter how long is watched, Turn the tv off, and come back and turn it on the picture is again dark, wait 20 minutes and the tv picture is perfect. please advise carl b. wright


... Sony Projection Televisions

I have a Mitsubishi WS-55909 projection TV. There was a power outage and when the power came back on, the TV won.t turn back on again. There is this light (Timer) that keeps on blinking on the front panel of the TV. I tried unplugging the Unit and waited for about 15 to 20 minutes before turning it back on , still won't work. I tried using the original remote for the TV to try to turn the power on, still doesn't work. There is a reset button beside the timer light, and I tried to reset the unit


Unplug,replug the tv back like 24 hrs later.That the whole tv is resetting itself everythings.Tv now should be working again.If still have the same problems,than ur tv DM power supply board is have dying parts,must repair the tv DM power supply board ... Mitsubishi Projection Televisions

I have a 50 Inch Toshiba DLP. The red light would come on and them blink and them turn itself off and start all over agian. It would finally come on after about 3 minutes of doing this. Now when I turn it on, it makes a loud child crying type noise and the picture wavers put never comes on. Any one know anything about this problem?


Sounds (no pun intended) if a high pitched or fan like sound it may be a color wheel failing. ... Toshiba 52HM95 52" HDTV Projection Television

I have a 22 inch AOC Envision LCD TV. When I first turn it on, only the top half of the screen displays picture while the bottom half is a gray/black color. If I wait about ten minutes or if I tap on the back of the TV, the picture is completely restored and I can watch everything just fine. However, it is pretty annoying to wait for the picture to come back. Since the picture does come back after a while and looks fine, I don't think I have a broken backlight or anything like that. Also, becaus


There is some loose solder terminals at the vertical scan output section at printed circuit board. If you are handy in electronic circuit boards, loacate the vertical output section, resolder all the suspected solder terminals there. This must sure ... Standard (CRT) Televisions

Our Sony picture came on one day & after a few minutes the screen went black, the sound was still there & the stand by light was blinking away. After waiting awhile we can still turn the t.v on, the picture will apear, but after about 3-4 minutes the screen goes black with the sound still going as well as the blinking of the stand by light. It this something that easily be fix, or time to get rid of the tube & on to the flat screen. I really hate to see it go cuz we really - really love this t.


Often it is cold solder in c-board. have you tried to re-solder it..in few years of using your t.v it is normally electronics parts heats-up..then it will loose it contact from the base board or the PCB.if you have a basic electronics knowledge ... Sony FD Trinitron WEGA KV-32FS120 32" TV

Panasonic PT-52LCX66 , changed lamp. power light comes on, but no video or audio shows up. can't turn off without holding power button for 6-7 seconds. won't come on after that. need to wait a long while before it can be turned back on.


Main board is screwed my friend ... Panasonic PT-52LCX66 Projection Television

TV starts to make a loud frying noise. Have to turn it off, wait a few minutes and then turn it back on. When it comes on, it says something about having "instore display settings". This note goes away if you hit the mute button on the remote. This scenario happens every 30 - 45 minutes when the Philips flat screen tv in on.


Hi rmwhite,\015\012\015\012This intermittent symptoms sounds to me that the fault came from the audio circuitry section. This is quite technical if you're not handy with electronics. The sets needs to check the audio circuit board, I/O board fo ... Flat Panel Televisions

When I turn my TV on it will turn off by itself in about a minute and the red power light on the front of the TV will blink. The remote control nor the power button on the front of the TV will turn it back on. I have to unplug the TV for a few seconds and plug it back in to make it come on. It usually takes two or more of these unplug and plug back in sessions to get it to stay on. Some times it takes up to fifteen before it will stay on. Please help.


This is what 's happening: you give the command to start the tv so the power source is initiated and starts to deliver power to the rest of the components of the tv; one of these components has aged and it requires much more current than normal to st ... Toshiba TN55V71 55" Rear Projection Television

Sony 55in grand wega. tv will turn off, when you try to turn back on and it is not ready, 5 blinking lights. once it is off for a short bit of time it will turn back on, but repeat this process again within a few minutes. The longer the tv is off, the longer it will remain on. this happend 20 days ago, had a repairman come in and said the lamp was bad. replaced it and here we go again.


Hello mbl64 and welcome to FixYa. I see your WEGA is giving you issues with blinking. The blinking is actually a self diagnosis mode which would inform a technician of your televisions general problem. The five blinks you are seeing indicates a AKB c ... Sony Grand WEGA KDF-55XS955 55" Rear Projection HDTV

My Philips 26PFL5302D/37 will being working great then it will go black. For a few minutes it allows you to go to the menu but it will not allow you to turn the channel. Then it eventually just be black, blue power light is still on, and nothing will happen. I trying turning the tv off and unplugging it but I get the same power on but nothing on the screen. I wait half an hour or so and it turns on and works again. What do I do to fix this???


Hi,what makes the TV malfunctioning this way is because the TV is overheating....Overheating might be from capacitors or IC inside the TV set...To fix it, you will need to check the capacitors or IC if the dry joint soldering of th ... Flat Panel Televisions

TV: Aquos SHARP LC-42BT10U When you plug the unit in, the power light comes on. After a few seconds, you then hear a click. Next, the power and the OCR lights blink simultaneously twice and then the OCR light blinks 3 times. When I put the TV in service mode, The screen gives me a small multi colored band from left to right that will fade after a few minutes. If I turn off the TV and put it back into service mode again, the color band moves to a different place. I am trying to fi


... Sharp LC-42D72U Television

My olevia model is 232-T12, when I turn it on it's just black, no picture. It was coming on for few minutes then would turn off. The light on power button is blue when off and I can hear it turn on, just no pic or sound


... Olevia LT32HVM 32 in. LCD Television

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || fullblownbass.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1348 seconds