Having problems with your Projection Televisions ?

Looking for a replacement lamp also. one said to check bulbtogo but they dont have them and it seems like nobody else does either. wondered if anyone had any luck after posting that they couldnt find one. does anyone know what the voltage and wattage is for this lamp. i guess if all else fails i could try to remove the bulb itself and replace it with something close. that or im out a $9,000 TV...



Answers :

Mats Electronics Sales Lamps for $89.00- $139.00 1-800-628-1118
\012Lamp PN# 915PO16010
\012Look on EBay under Electronics TV/Parts type in Lamp number.

Repair Help & Product Troubleshooting for Projection Televisions
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

Looking for a replacement lamp also. one said to check bulbtogo but they dont have them and it seems like nobody else does either. wondered if anyone had any luck after posting that they couldnt find one. does anyone know what the voltage and wattage is for this lamp. i guess if all else fails i could try to remove the bulb itself and replace it with something close. that or im out a $9,000 TV...


Mats Electronics Sales Lamps for $89.00- $139.00 1-800-628-1118\012Lamp PN# 915PO16010\012Look on EBay under Electronics TV/Parts type in Lamp number. ... Mitsubishi WL-82913 82" Rear Projection HDTV

I have a HLT6187SAXXAA when I turn it on it does its little tune the n the fans come on for about 5 secs the reboots, it does this 3 times then it goes to all 3 lights blinking, my modle has no lamp but it has 3 leds, red , green and blue. I tested the voltages from the power board the powers the leds and all the voltages were fine but no leds. i tested a 3 leds with a 9 volt battery and they all power up so I replaced the led driver boarn with a new one and now it does the same thing what else


... Samsung HCM4215W 42" Rear Projection Television

Hl72a650 Hi I have a Samsung hl72a650. Replaced lamp a year ago. Tv suddenly one day started to shut itself off and back on again. I have tried everything else I have researched online. Took lamp out and back in several times. When the tv comes on the picture is very bright and clear then suddenly the picture begins to loose color and shuts off and back on several times untill all 3 lights start blinking. I also started the tv with mute 182 power and selected options clear lamp, reset user setti


Color wheel issues replace light engine ... Projection Televisions

Sony kdf60xbr950 Having the same problem with no picture. Green lights blinks first then the red lamp light. My first thought is the lamp. Then I had talked to a tech and he tried to tell me that its the balist or the power supply and likley not the bulb? Has anybody else been throught this and what was the outcome. This is the original bulb with only about 1000-1500 hours on it ? was working fine one day and the next this ?


The problem here with the lamp is it has an average 2,000 hour life--only way for a "tech" to know if it is the problem is to replace it.The ballast is the power supply for the lamp---lamp goes bad a lot more often than the ballast= sounds li ... Sony Grand WEGA KDF-60XS955 60" Rear Projection HDTV

Hi, I have a 60VS810 60inch LCD projection and the blue power light flashes but no picture comes on...i just got it for free so i dont know how it worked before..yesterday i did get a blury pic on the screen that kept moving so i couldnt read the menu bar but u can slightly see the menu options..only the blue power light flashes nothing else..what could this be..the lamp looks good and the bulb is fine..what else is there so i dont have to pay hundreds to fix it


Flashes of blue light are fault indications. From the number of flashes occurs at one time switch on, you can get an idea about the faulty section circuit board inside. If you wish to get details about these blinks, ... Hitachi 60VS810 60" Rear Projection HDTV-Ready Television

My lamp went out on my Panasonic pt52LCX66 TV, when I went to change the bulb, it had melted to the connectors...I managed to separate the lamp but it broke the connectors while doing so. Can anyone tell me where I can get new parts ( connectors) or how else I may be able to it? Thanks


You might of course see if Panasonic can help with this (I doubt it) or contact some local shops as wires etc are hard to impossible to order from the maker here.A junked set may also have what you need, either from a shop or even on EBAY. ... Projection Televisions

I have a Sharp Aquos # LC-45GD4U. When I connect to the outlet red light starts blinking and pauses. I already changed the power supply and there is still no change. In the power supply i measured pludg p 7901 pin 7 , and it measured 6 volts no where else is there voltage. Can anyone offer a solution to my problem


If you have that 6 or 5 volts, that is your stand by, so power supply should be ok. I would think the main board,, check out these guys http://www.shopjimmy.com/ , you can call up and talk with a tech also there. I wouldnt think that the invertor wou ... Sharp Aquos LC-45GD4U 45 in. LCD HDTV

Have a Mitsubishi WD-60738 replace lamp for the second time but this time it start out clear for about one min and then start to flicker then go off I hear a sqeeking noise from the back can anyone help ?


Your color wheel is defective and needs to be replaced. ... Mitsubishi Projection Televisions

Blink red Does anyone know where to get a new lamp door? Mine is melted and cannot find one anywhere.


... Sony Grand WEGA KDF55E2000 55" Projection HDTV

Toshiba 52hl167 TV makes popping noise. Cannot turn off unless you unplug it. Remote and side buttons do not work. It is stuck on one channel. You can see the channel number but no picture, screen is black. Has anyone else had this problem?


... Toshiba 52HL167 52 in. LCD HDTV

I have had ongoing lamp issues. I have purchased 2 new lamps, (Phillips) The new lamp won't light, but the old original lamp will light but is dim. Why would the old lamp light and new one won't. The old lamp takes about 15 green light flickers before coming on but does light. The new one, green light blinks till shuts off.


Hi,\012You old lamps were compromised due to long usages while the news lamps are defective. They may manufacturing defect. Please claim the new lamps to supplier then.\012\012Regards ,Jay ... Panasonic PT-56LCX66 Television

I have a HLT61765X/XAA. I was watching TV when it suddenly shut off. I tried turning it back on but the lamp faded on and then faded off with one green blinking on the far right (which is lamp, I believe) and one red blinking. I unscrewed the panel and removed the lamp, then put it back in. Now the lamp is lighting up but cannot make it all the way, but stays on. I then hear two buzzing noises every couple of seconds and eventually the lamp light fades away, with both green lights along with the


... Samsung HLT6176S Television

I have a sony KDS-R60XBR1. The lamp burned out so I ordered a new one. When I took the old one out, I noticed the area directly in front of the lamp, the first thing the lamp shines into, is a little dirty around the edges and needs to be cleaned prior to installing the new lamp. What should I use to clean this small 2"x2 1/2" area? It's not dust, it's like a thin layer of dirty film or buildup. I don't want to scratch it and ruin it's surface.


Use a eyeglass cloth or LCD screen cloth. Use NO solvants on it. Just dry cloth. ALSO goto the settings menu and put the tv in HIGH altitude mode. There tv's get too hot and the light engines go out. Green or blue tint. or dots. It also helps the lam ... Sony KDS-R60XBR1 60" Projection HDTV

Wd-65735 low lamp voltage issue.


Be aware the set uses two grounds, one hot and one a earth ground and if you are measuring from the wrong ground you get wrong readings.do the self check the set has to see if you have a error code. ... Mitsubishi WD-65735 Television

Just don't know with this one - Guess, shoddy ghosty 3D images,side way hour glass.


2004 or there abouts, Rear projection with the 3 picture tubes--16X9 HD ready.Most common issue is convergence--see photos--if that with the Original remote go into the main menu and call up convergence--should display about 9 points on the ... Projection Televisions

I own a 50PL9126D/37 50 in DLP TV I bought used and the picture is dark so I took it apart because I was told it could be dusty or could be the lamp. After I cleaned the inside screen VERY carefully with a microfiber cloth I reassembled the set and now the power button or blue doesn't come on nor does the remote work anymore. Plus the TV is still dark, which I figure must be the lamp. I can turn the TV on by plugging it in and hitting one of the side buttons (different one every time) and then u


Dlp tvs have dark pictures,first thing u must be alway change the tv projection lamp.Specially,if u bought used,because u don't know how long the projection lamp been inside that tv already.After u change the projection lamp,still have problems or he ... Philips 50PL9126D/37B 50" DLP TV

Hi, i got samsung dlp tv m# HL-P5063W.i changed lamp,ballest,collerwheel,and lamp door cover sensor. but tv still doesnt come on.once you plug in the power cord green lamp sign blinks 35 times then cutts off and one time stand by red light blinks,then green lamp starts blinking again. lamp never gets come on. please help.


Seemed like it is a problem with the power supply circuit. Check the circuit where the power chord is connected internally to the TV. You should see capacitors. Check for swollen or leaking ones that may need replacing. Check also for burnt compo ... Flat Panel Televisions

Hi there, my sony grand wega kdf60wf655 had stopped working and was flashing 5 red lights. I tested the voltage from the power board to the lamp ballast board and got a 272v dc. Just replaced the lamp ballast board and now get blinking lamp indicator. Tried a new spare lamp that i had in reserve and still flashing red lamp indicator every 1 second. Any ideas? thanksp i


... Sony Grand WEGA KDF-55XS955 55" Rear Projection HDTV

I have a InFocus lp70+ video projector with a bad lamp. When I replaced the lamp the new one worked but when I moved it to a different room the lamp would not come back on. The lamp has failed a continuity test. Could a problem in the projector be causing the lamps to burnout or is it worth trying another bulb.


Hi. It is possible that the projector to send the wrong voltage out to the bulb, and that is what is causing the bulbs to go out. But more than likely, when you moved the projector, it jarred things around in the bulb, causing it to fail. ... Flat Panel Televisions

I own a Philips DLP television model 50pl9126d/37 I just replaced the lamp on it less than 6 months ago and the red lamp failure light came on. I have opened the back and can see the lamp starting up for about 5 sec but then it quits. I have read a number of issues but was wondering if anyone who has had this similar problem figured out the solution. I have pulled out the lamp ballast but as far as I can see there is no sign of damage. When the ballast was in I removed the lamp and could see the


You might want to with a flashlight and or small mirror want to look where the lamp faces at the color wheel---it must be intact and not missing any segmentstypical color wheel: ... Philips 50PL9126D/37B 50" DLP TV

Hey i have a 42 inch phillips plasma tv that blinks a red light 7 times but i have two of these tv's and took out the power supply on the working one and put in the broken one and it still blinks red light 7 times i also put the power board from the broken one to the one that does work and it still worked. so my question is what else could it be?


There three common boards (Powers supply, Y-SUSTAIN, Z-SUSTAIN) that go out, since you have two TV to try out, you should check the Z and Y sustain boards.\012What is the model number?\012Try looking here for free service manuals:\0 ... Flat Panel Televisions

Sony kdsr60xbr1 standbuy blinks red 6 times. Pulled lamp out, it was broken. I heard lamp pop. Do I just need to replace lamp or is it something else as welll?


If your not sure, google name and make of tv and "red light blinks 6 times". That usually is a code for what is wrong.....My money is on the lamp....especially if it was working fine before. Hope that helps and gd luck to ya ... Sony KDS-R60XBR1 60" Projection HDTV

EMERSON MODEL LHD32K20US LED - ANYONE HAVE ONE??


... Emerson Flat Panel Televisions

Ballast one lamp F15T8 lamp wiring diagram


... Projection Televisions

Replaced the lamp in my Optoma Rd50 and the screen still reads that I need to replace lamp also T.v still having the same picture problem as before replacement lamp? what else could be wrong?


... Optoma RD50 Television

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || fullblownbass.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0669 seconds