Having problems with your Projection Televisions ?

Mitshubishi WD-62327 TV will not turn on and no sound. TV made a interference sound and shut off. Tried to turn it in the morning still nothing. Replaced lamp/bulb still nothing. Red light is on (not blinking) Need help any suggestions?



Answers :

If you have a voltage meter there are some things you can check.
Unplug the unit and remove the back cover of the set. Then Plug the unit back in.
You will need to tape down the lamp safety switch in order to do these tests.
Here are all the failures that would give you a lamp error and what to check.
Cause 1. Unit powers on and works properly for a while then shuts off with a red lamp led(lamp error). Suspect bad lamp and replace.
Cause 2. Unit does not power up correctly and you have red lamp led(lamp error). Check the lamp enable line at connector J14 on the back of the light engine. If pin 6 does not switch to 5 volts after turn on, but your 12 and 5 volt supplies are good, then suspect a defective light engine.
Cuse 3. At power on the lamp turns on and off 3 times and then the unit shuts down with a red lamp led(lamp error). You have a defective light engine.
Cause 4. Unit does not turn on correctly and you have a red lamp led(lamp error). Check for 12 volts at connector J9 pin 4 on the light engine. If voltage is missing check for an open fuse F9A09 on the power supply board. If it is open, then you need to replace the fuse and you still have a defective light engine.
Cause 5. Lamp enable line at connector J14 pin 6 on the light engine does go to 5 volts at turn on, but does not drop back to 0 volts after 5 seconds, but your 12 and 5 volts supplies are good then you have a defective light engine.
Cuase 6. Check for 5 volts at connector J9 pins 1 and 2 on the light engine. If low or missing check Capacitors C9A37 and C9A38. Values are 3300MF/10V. Replace capacitors if defective.

This is all I have and I wish you luck.

Repair Help & Product Troubleshooting for Projection Televisions
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

Mitshubishi WD-62327 TV will not turn on and no sound. TV made a interference sound and shut off. Tried to turn it in the morning still nothing. Replaced lamp/bulb still nothing. Red light is on (not blinking) Need help any suggestions?


If you have a voltage meter there are some things you can check.Unplug the unit and remove the back cover of the set. Then Plug the unit back in.You will need to tape down the lamp safety switch in order to do these tests.Here are all the ... Mitsubishi WD-62327 62" Rear Projection HDTV-Ready Television

I picked up a Mitsubishi Model No. WD- 62527. The guy said all it needed was the lamp replaced, I replaced it and the tv still doesn't turn on. Their is a green light that blinks were it says timer for about a minute then the orange light under lamp turns on. About a second later the green light under timer blinks three times then turns off and then the only light on is the lamp orange light. It will continue to do this hole scenario over and over again...HELP!


... Projection Televisions

My Sony Trinitron TV 1999 (KV-32V42) made a strange popping sound and I lost both the sound & picture. When I turn it back on, the two red lights on the front of the TV(standby/Timer light & Stereo light) come on, but no picture or sound. The red standby/timer light has been blinking now for four hours. The instruction book doesn't mention the standby/timer light. I have tried unplugging it and turning it off and on several times, but nothing helps. Still no picture or sound!


The tv has a high voltage problem, and the probable cause is the flyback transformer has become defective, it's job is to generate the high voltage to energize the picture tube and along with the video circuits produces a pi ... Sony FD Trinitron WEGA KV-36FS120 36" TV

My Sony Trinitron TV 1999 (KV-32V42) made a strange popping sound and I lost both the sound & picture. When I turn it back on, the two red lights on the front of the TV(standby/Timer light & Stereo light) come on, but no picture or sound. The red standby/timer light has been blinking now for four hours. The instruction book doesn't mention the standby/timer light. I have tried unplugging it and turning it off and on several times, but nothing helps. Still no picture or sound!


Hi,\012\012The\012Standby/Power light of the TV blinks when there is any internal malfunction in\012the TV. The self-diagnostic function of the TV will cause the STANDBY light to\012blink or flash when the television dete ... Sony FD Trinitron WEGA KV-32FS100 32" TV

I am facing a problem in my lcd tv sony model no. klv-32ex300, it is turning off in few minutes but red light is still on i am again open tv and it is again turn off in few minutes what can i suggest


... Sony KLV-32EX300

I have a WD 60735 replaced the bulb as the light was red but now my timer light flashes green when you turn the tv on than goes to solid green you can hear the sound, turn that up and down but the screen is all black and you can not change the inputs. The bulb light did come on red once. I have pushed the reset button but still no picture. Any suggestions


... Mitsubishi WD-62525 62" Rear Projection HDTV

TX-P42S11B Hi there my Panasonic TX-P42S11B has just turned it's self off! The red light was still on as though it was on stand by. I tried turning it back on using the remote, it makes a hissing noise at the back of the tele then turns off. I've unplugged it all for over 10 mins and tried again, this time using the button on the tele, the same thing happens. The only thing I can tell you that might help is the red light is on and doing 5 flashes, then stops, then 5 flashes again! I hope what I


... Panasonic Standard (CRT) Televisions

I have a samsung dlp model hls5086wx/xxa that recently stopped working. Lamp light came on so I assumed the lamp needed replaced. Replaced the lamp and still won't turn on and lamp light blinking. It also make a whining noise when turned on but I don't get a picture. Is it the color wheel or ballast? Any suggestions?


... Samsung Projection Televisions

I have a RCA l32hd35d version A I can turn it on and it comes on and the backlight goes back out. The rest of the tv works and it has a picture if you look at it close. Just no back light. I have replaced the inverter and the problem is still the same. The blon pin on the inverter has 3 volts on it even after the backlight goes out The 24 volts is still there too you can keep turning it on and off and the backlight will stay on. any help will be great...


If you have 24vdc feeding the inverter board, the next signal you need to find is the BL_ON SIGNAL which will turn on the inverter board, it should be 3.3vdc or 5vdc on that pin (pin 12 on CN1 of the inverter board), see picture here:\015\012 ... RCA L32HD35D 31.5 in. LCD HDTV

Works perfectly 1 day, next day will not turn on. Red light which will normally turn green when switched on, but now turns orange and tv will not turn on. Few hours later tv will go. Have tried unplugging tv, problem still occurs and is becoming more regular. Also have no remote for tv. help


Sounds like an RCA but there are plenty of the tvs that have the same problem it is the little solenoid that pulls in to turn the set on . If you know how you can replace with a optic coupler and that is that if not you can take front off and see ri ... Standard (CRT) Televisions

Our tv is just barely 2 yrs old, we were watching it one day and the entire tv turned off and will not turn back on. it usually has a standby light on even when its not turned on but even thats off. the outlet is a perfectly good one, we still use it. help....


The power supply maodule may have failed, troubleshoot it first, you can get it at WWW.SHOPJIMMY.COM\012\012If you are going to DIY and have proper tools, ele ... Vizio 42 in. LCD TV

HI, I have no picture of sound. When I turn the TV on I get a series of clicks then the light turns from red to green and flashes green 3 times. I checked the power board and found 9 bad caps and replaced them but still no picture and the TV does not come on. Please help.


3 blinks indicate a failure in the power source. \012\012\012You will need to test it, identify the failed output line (most likely it's the 3,3 v one) and replace the failed parts - most likely the rectifier.Use this manual for a more pr ... LG 50PC3D 50 in. Plasma Television

I am facing a problem in my lcd tv benq model no. vb3233, it is turning off in few minutes but red light is still on i am again open tv and it is again turn off in few minutes what can i suggest better option to solve my problem


... Toshiba Flat Panel Televisions

The TV turns on and shows a picture that you can watch and within 10 minutes the TV loses its picture, however, the light is still green. If you turn the TV off you can get the picture to come back after you wait like 20 minutes or so but the TV will lose the picture again in 10 minutes or so. Any suggestions?


... Hitachi 42HDT52 42 in. Plasma HDTV

Can't turn on proscan 42LED55SA. blue light is on at the bottom of tv but i can't turn on manually or with remote. have tried unplugging and re-plugging but does not help. any suggestions?


Your Power supply needs troubleshooting. ... Proscan Flat Panel Televisions

Hello. my samsung HL61650A 61'' DLP tv is about 2.5 years old, and tonight it just shut off. tried to turn back on, got 2 'buzzing' sounds from the back, but it wouldn't turn on. unplugged, undid back cover, put blue switch to 'down', still no luck. now, it won't really even try to power on, and standby & lamp LED lights blink. do you think it is solely the Lamp that needs replaced? help!?


... Samsung HL61A650C Television

My tv wont turn on i have a toshiba regza. when i do turn it on the red light in the front blinks every few secs over and over for as long as its plugged it. i tried a few things but still no solution. please help im bored!


The first thing to try is to unplug the TV, leave it unplugged for about 60 sec, the plug it back in. If the problem persists, this is most likely an issue that will need to be resolved by an electronic repair store/facility. ... Toshiba REGZA 42 in. Flat-Panel LCD HDTV

Sony KLV-L32M1 was working fine last night. Turned it off as normal by the front power switch, but went to turn it on this morning & nothing came on, no lights, nothing. Have checked the fuse which is fine, have unplugged it & left it & that's not helped, any suggestions??


... Sony KLV-32M1 32 in. HD-Ready LCD Television

I have a samsung syncmaster 320p and my screen would just flash and flash with the blue light you could change it to component and all that except it would still just flash. now it will not even turn on it does not have the power light even come on when we plug it in. if you could help me i would appreciate it thanks.


... Flat Panel Televisions

Samsung lnt4665fx xaa video prolbem apperas main board has been zapped visible burn marks on hdmi port 2 blue light under samsung still comes on and red light flashes and relay clicks but no audio or video replaced caps in power supply did not help should the main board be replaced? should the main board be replace any suggestions would be helpfull thanks


... Projection Televisions

I have a samsung hl-r4226w tv. the lamp went out so i purchased a phillips 000007225 lamp, installed it and still have no lamp lighting up. Question, did the guy sell me the incorrect lamp or do i have another problem. when i turn power on you hear the little tune then lamp light blinks. all help apopreciated


... Samsung HL-R4266W 42" HDTV-Ready Projection Television

When the power is turned on, the red indicator light flashes continually. It will not go to solid red. There was a clicking noise from the back of the set, which stopped shortly afterwards. I have pressed the on button on the remote, have turned it off at the wall and left for ten minutes and retried, still same result. It continues to flash red. Is there anything I can do or is it a service job ? Hope you can help. Jeremy


Sounds like your capacitors are bad. Samsung will replace them for free if you call them at 1 800 Samsung. ... Flat Panel Televisions

I have a Sony Bravia LCD tv an it won't turn on at all the standby light is not even there I've tried turning on an off and leaving unplugged for an hour still nothing.? Help,


You either have a problem with your power supply board or main board. I would start with having the power supply fuse checked as well as the power supply board! ... Sony BRAVIA KDL-40S2000 40 in. LCD HDTV

I have a Luxor Lux-40-914-TVB and i got it for christmas and was working fine but now when i go to turn it on, the red light just keeps flashing and doesn't stop. I've tried unplugging it but i still can't turn it on. Please help!


I see so many here with no sound/nopicture issues:ISSUES: 1. IF sound main fuse/s are good.2. If no power or standby check main fuse, standby power supply and any signsof damage you can see---burnt parts etc.3. almost all thes ... Flat Panel Televisions

No Power..... Hi, I have a LG rear projection 56DC1D tv and I turned it off with the remote and when i went to turn it back on I got nothing. The red light that shows there is power is not on, which indicates there is no power. I have changed the power coard and still nothing. What do you suggest?


Follow the cord inside there is a fuse directly in line with the cord. ... LG Projection Televisions

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || fullblownbass.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1623 seconds