Having problems with your Projection Televisions ?

Mitsubishi tv model vs-60111 will not turn on. The power comes on then turns off a few seconds later. I tried holding the input and menu button on the front of the console. The power LED light blinks once pause the blinks twice. Do you know what is wrong with the tv.



Answers :

Repair Help & Product Troubleshooting for Projection Televisions
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

Mitsubishi tv model vs-60111 will not turn on. The power comes on then turns off a few seconds later. I tried holding the input and menu button on the front of the console. The power LED light blinks once pause the blinks twice. Do you know what is wrong with the tv.


... Mitsubishi VS-60111 60" Rear Projection Television

Recently my benq mp620p projector stop working. When I connect the power cord the power button lights up green and the power led orange as usually. When I push the power button, it starts to blink in green, the filter wheel starts to spin and the lamp starts to warm up with some light comming out. Few seconds after, the fans start, the power led becomes solid green and the lamps goes of. I can't do anything else since that other than unplug the power cord. No response to any button. Any help?


I'm assuming that you have checked the bulb and it appears ok. Either the inverter/ ballast board has a fault or , much more likely, the control board is no longer capable of finishing the loading of the firmware. This is usually caused by the failur ... Flat Panel Televisions

Television Tv stuck in standby front led blinking only.Once the front led is blinking will not stop blinking by switching off with remote or side contol on tv. The only way is by removal of mains plug. Power supply used is Vestel 17ips10-3. Will change power board if this fault is caused by faulty board. Can anybody in the know confirm that the fault as explained is likely to be caused by a fault in power supply board.


... Flat Panel Televisions

I have a Samsung SyncMaster 730mv 17' Monitor. It's been sitting for nearly a year. After charging it, the power button does not turn on the monitor. I've pressed the Menu button & the Power button to get a reponse of a blinking green light [3 blinks] yet it will not power on when the Power button is pressed. Any ideas on what is going on??? I am not computer Savvy' [The result I'm looking for is to utilize the monitor with my Asus laptop.] -Ty for reading'


... Samsung SyncMaster 730MW (Silver) 17 in. HDTV-Ready LCD Television

Have a lg 20ls7d 20 in.power problem .theres power to the tv.the red light in frontis in .i hit the power button on top green light comes on then blinks 5 times screen cums in or a second then goes off.so does the green light .but the power light in the front wont come back on unless i hit the power button on top again.like i was turning the unit off.any ideas?


... LG RE-20LA70 20 in. Analog TV LCD Television

This TV has a light bar on the front that is red when off and blue when on. When we attempt to power the TV on the light will momentarily light blue, then turn red and the TV won't power up. It varies how many times we have to hit the power button before it powers on and stays on. I suspect there is a bad "starter" or capacitor, but don't know how much needs to be replaced internally to repair this problem


... Audiovox FPE3706 37 in. HDTV LCD Television

Mitsubishi WD-73735 will not turn on and there are no lights on front. The power supply was replaced, and is brand new. I fix HDTVs, and have had very little problem resolving other issues with other TVs. This one is strange. Need help, please. When I plug it in, you can hear the PS get power, but nothing turns on. Tried the 'Menu' and 'Input' combination....nothing. Tried plugging it in, with the 'Menu' button pushed...nothing. I can hit the 'Reset' button on the


If you have no lights come on the front of TV, you definitely have a power supply issue. Don't know what previous servicer did, but I would be looking at ALL wires & connectors. ... Mitsubishi WD-73735 Television

I have a mitsubishi dlp WD-65733 and it went out on me a week ago. when I power it up i get only the green light above the timer. when i hit the reset button in the front i hear a click in the back and the green timer light starts blinking for about 30 seconds the it powers off. I do not get any lights above the status or lamp. i have replaced the bulb before about 1 1/2 years ago. could this be the bulp again? when i replaced it before i had an orange lamp light but not this time.


Hi,It seems problem in power supply board that got few electrolytic capacitors leaky and causing problem. It does not look like lamp issue.Let me know are you handy with electronics stuff repair and can replace parts in circuit board? ... Flat Panel Televisions

Pioneer pdp 434pu - can't turn on tv. 7 flashing red lights where power button is. 3 years ago it has 6 flashing red lights and it was a power supply issue, I found one and repalced it for under $200, now again, it maybe on it's last leg. Does anyone know what 7 blinking lights mean?


... Flat Panel Televisions

I have a Mitsubishi WS-55909 projection TV. There was a power outage and when the power came back on, the TV won.t turn back on again. There is this light (Timer) that keeps on blinking on the front panel of the TV. I tried unplugging the Unit and waited for about 15 to 20 minutes before turning it back on , still won't work. I tried using the original remote for the TV to try to turn the power on, still doesn't work. There is a reset button beside the timer light, and I tried to reset the unit


Unplug,replug the tv back like 24 hrs later.That the whole tv is resetting itself everythings.Tv now should be working again.If still have the same problems,than ur tv DM power supply board is have dying parts,must repair the tv DM power supply board ... Mitsubishi Projection Televisions

My JVC LT-47GZ78 will not turn on. When I press the remote power or the main power switch on the set button the blue LCD light on the front of the TV lights and then starts to blink, the TV does no come on. Also there is a cliccking noise coming from behind the set. I'm in a country with 220v power supply.


The blinking indicates that the protection system of the power board from the tv has detected a short on one of its outputs and has cut the power to it to prevent further damage - the clicking is made by the main power relay being disengaged, repeate ... JVC Flat Panel Televisions

Panasonic cinema vision, model pt-47x54j, power light stays on, with no blinking, when pressing on power button on tv with no picture, sound or menu, then shuts off after 30 seconds. If I use remote to turn it on, power light on remote flashes 3 times


... Panasonic Projection Televisions

The Timer indicator on the front of the TV is continuously blinking green. I have made several attempts to fix this by pressing the System Reset button and held it for up to 30 seconds at a time. Each time I release the System Reset button, a few seconds later the Timer indicator starts flashing again. I have also totally disconnected the TV from power for up to 15 minutes but as soon as I connect it back to power the Timer light starts flashing again. I cannot locate my owners manual for


Hi,Let me know model number of your Mitsubishi tv to provide you helpful info about problem and manual pdf file.Thanks. ... Flat Panel Televisions

When I turn my TV on it will turn off by itself in about a minute and the red power light on the front of the TV will blink. The remote control nor the power button on the front of the TV will turn it back on. I have to unplug the TV for a few seconds and plug it back in to make it come on. It usually takes two or more of these unplug and plug back in sessions to get it to stay on. Some times it takes up to fifteen before it will stay on. Please help.


This is what 's happening: you give the command to start the tv so the power source is initiated and starts to deliver power to the rest of the components of the tv; one of these components has aged and it requires much more current than normal to st ... Toshiba TN55V71 55" Rear Projection Television

Problem with Samsung HLS4676SX/XAA Television My samsung tv will not power up, timer light is blinking The timer light on the front of the tv is blinking and the tv powers on, there is sound and then


... Samsung HLS4676SX/XAA OEM TV Lamp

I have a Sony Wega KDF-E55A20 rear projection LCD TV. The screen stays black when pressing the Power On button. When the Power on button is pressed, a GREEN blinking light (5th light in a row of 5) comes on and blinks about 58 times, along with an intermittent "popping static" noise. It then goes to a STEADY RED accompanied by the 2nd light in the row of 5, BLINKING RED. It continues like this until I unplug the power cord. It will do the same thing if I plug it back in an press the Power On but


It sounds that the SCL ' SDA signal path has some short. You must have thorough knowledge in electronics to follow. Checking I2C bus signals is a skilled work. If you wish to get more details, ... Sony KDF-E55A20

TV remote on my model TXL2791F won't turn TV on. When I press the power button on the TV itself the little timer light blinks and the TV makes a ticking sound for a few seconds. If I press the power button again the blinking light and ticking sound happen again for a few seconds. If I repeat pushing the power button on the TV again the blinking and ticking will then go on all day long unless I unplug the TV for 15 minutes or more. All during this time the screen is dark. Just before this ha


... Samsung TXL2791F 27" TV

I have a sharp aquos lc-c5277un. Both the power and OPC lights together blink twice. I tried unplugging it, holding down the volume up and channel down buttons while plugging it in. That left me with a solid power light on. I pushed the power button to turn it off and it turned off. Pushed it again to turn it on. It turned on and worked. 10 minutes or so later I heard a pop sound and the lights started blinking as before. This loop has played out three times. Is this the power board or


... Flat Panel Televisions

Display Doesn't turn on anymore. When i connect it the blue led light on but nothing happens when press the power button, just start to blink the blue led and then stop. This happened after i notice some read dots and lines coming and going in the top half of the screen. Any idea of whats happening or a possible solution??? Its a samsung 42" plasmas with like 2.5 years.


... Samsung PS42P2S 42 in. Plasma Television

My sharp aquos lc46d85u power light is blinking, after reset methods turns on shortly then shuts off. Can hold power button and make led a solid red.


... Flat Panel Televisions

We have a toshiba tp55h60 and the power button on front does not come on. Only a blinking red light next to it. Any ideas how to get it to power back up? Thxs!


The most common reason for this is one of the two convergence chips, most likely are STK-392-110 is shorted.What I do in this case is get at the chips and unsolder all pins (each has 18) on both chips and try to power set up.If set sh ... Toshiba TP55H60 55" Rear Projection Television

I have a phillips flat screen tv and to repair man say that it needs the power supply board ! the tv does not turn on but when you hit the power button on the remote a red light blinks in front of the tv !


There's a good chance you have failing electrolytic capacitors either in the power section or the inverter section or both.Any caps in these sections that look bulged at the top, or bulged/leaking at the bottom need to be replaced.If you ... Philips 42FD9954 42 in. Plasma HDTV

Led light on my curtis lcd3215A blinks but no power when power button is pressed


I see so many here with no sound/nopicture issues:ISSUES: 1. IF sound main fuse/s are good.2. If no power or standby check main fuse, standby power supply and any signsof damage you can see---burnt parts etc.3. almost all thes ... Standard (CRT) Televisions

I just want to know what it means when the red light blinks on my power button. Does anyone know?


What kind of tv? ... Projection Televisions

I was given a Hitachi AVC monitor with no box. I want to know if the Monitor works befor I buy a new box. I plugged the monitor in and got a blinking yellow light. I then held down the power button for six seconds and then heard a click and the light changed to steady green but the screen did not seem to warm up. How can I tell if the monitor actually works before I invest in a box?


... Hitachi 32HDT20 32 in. Plasma Television

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || fullblownbass.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1703 seconds