Having problems with your Flat Panel Televisions ?

I have a 60 inch flat screen samsung tv and its stuck on the tv guide channel ( channel 99 )i tried reprogramming it and its not working i dont know what to do


\015 As of a couple days ago its stuck on the TV guide channel ( channel 99 ) the remote buttons aren't stuck I tried rebooting the cable box scanning channels and its not working\015

Answers :

Sounds like a bad mainboard

Repair Help & Product Troubleshooting for Flat Panel Televisions
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

I have a 60 inch flat screen samsung tv and its stuck on the tv guide channel ( channel 99 )i tried reprogramming it and its not working i dont know what to do


Sounds like a bad mainboard ... Flat Panel Televisions

I do not have cable or anything. I need to know what I need to get to get my local channels on my Vizio flat screen. I tried hooking up an antenna but I do a scan and get nothing. I dont know hat to do, Im tired of watching netflix.


... Vizio M220VA 22 in. LCD HDTV

How can i put input 1 back on flat screen tv. Because im trying to watch movies off my phone onto the tv. I dont know how to work it. Thank you..


See the diagram attached. God bless you ... Flat Panel Televisions

I programmed my sudden link remote to my tv and turns my tv on an off, controls the volume, but when I try to change the channel of my television with the remote, the red cable light on the remote lights up as if it thinks I'm trying to tell it to change the channel on the sudden link channels and not the channels of my tv....help? (I know this sounds lazy because normally people would just say get up and change the channel but our tv buttons don't work and I don't have the original remote)


... Flat Panel Televisions

My RCA flat screen was working just fine and than as I was watching TV the screen flickered off and the it started flashing unusable signal. I did a rescan of the channels a couple come back that I have never had before. The sound doesnt work on the few channels that I do get and the picture and sound doesnt work on the ones I use to get. I also tried to put a dvd in. The sound works but not the picture doesnt. What do I do


... RCA Flat Panel Televisions

I am trying to hook up a gamecube to a toshiba tv. I don't know the model number but it has 3 inputs in the back and one in the front. I have tried all of them and tried changing the input on the tv to one of them but it only stays on tv. I don't have channel 3 and I don't know how to add it. I have unplugged the cable cord also seeing if that would work and nothing. Please help.


... Toshiba Flat Panel Televisions

I am trying to hook-up a PS2 to the DWT1304. I have the video (yellow) and audio (white/red) plugged into the front. I have tried to access the game system on channel 2, 3 and 4 with nothing but fuzz/static on the screen. The PS2 has been hooked up to this TV previously and worked. I have tested the PS2 connection on another TV and it works fine. I just don't know what else to try with the DWT1304 TV


Have you tried the AV Channel ... Durabrand DWT1304 13" TV

BAUHN I purchased the above TV at Aldi,s Liverpool store in Sydney 10/04/2013. When I set up TV the Guide (EPG) was working fine. For some reason the Guide (EPG) has now stopped showing any programs and says No Event Information and the same message when display is selected on the remote for the program you are watching. The signal strength for all channels is showing 4 to 6 bars and the picture is fine, I have tried Auto Scan again and tuned in all Channels again but this made no difference. W


... Flat Panel Televisions

I have a Trutech 7'' lcd space-saving kitchen tv and dvd. The radio and dvd work fine but the tv doesn't work. When I turn it on I get a blue screen with the channel 2 in the top right corner. I have tried to reset the unit and autoprogram. I have lost my instructions to this and don't know if I am missing something. Although we have had this unit for several years, this is the first time we have tried hooking up the tv.


... TruTech PVS31170S1W 17 in. LCD Television

I recently moved and had my jvc big screen tv hooked up to direct tv through a hdmi cable i get picture but no sound I had this problem before when i had it hooked up the first time the direct tv guy messed with th tv settings and got it to work but i dont know how he did it and now ive moved and am having the sound issue again how can i get the sound to work on hdmi it works on everyother input channel


... JVC HD-52Z575 52" Rear Projection HDTV-Ready Television

I have a JVC AV-48P777 and I lost the remote I'm trying to program the channels but dont know how to select the start button


... JVC AV48P777 Television

H i have no remote for hannspree tv, tried scanning channels with buttons on the side of tv, dont know what i touched,but now its wont do anything just says scan channels. wont even turn off


Remove power for about 30 seconds and try again. ... Hannspree Flat Panel Televisions

My sister wanted to change our Toshiba TV to her favorite cartoon, Tom and Jerry. But after she entered the channel number, the TV went black and white. I've tried to get the TV working again but then I noticed that it was on TV 4, the thing is I don't know how to get it back to channel 3, PLEASE HELP!!


... Toshiba Standard (CRT) Televisions

I have an LG 26LZ5RV TV. I have connected it from the RF output of my Sky+ box (using a coaxial cable) to the "Ant In" socket at the back of the TV. The RF output on the Sky box is set to Channel 35 and the power is on. I know that the output is working, as I have tested it on an old portable TV with manual tuning. My problem is that I cannot get my LG TV to tune in to the signal, using either auto or manual tuning. I have used System "I" and tried setting the Channel to 35 then searching b


... LG Flat Panel Televisions

I have a Daewoo T.V. it has been working with a Dish remote something happened (I don't know what) and now the rmeote doesn't work the T.V. I am trying to figure out how to reprogram it . Can't even find daewoo any help???


Most remotes these days have a code search feature look onlnie for your remote model and code search how 2s ... Projection Televisions

Hyundai 32 Television was working fine until a few minutes ago. I tried to change the channel and since then it has started switching itself to and from standby. TV Switched on for about 3 seconds with channel 21 showing in the top left corner before switching itself back to standby again. the strange thing is that it will switch itself back on from standby. Anyone know what might be causing this?


That problem is usually cause of faulty capacitors on the power supply board..Just follow this instruction to fix your TV..1. Open the back cover of your TV.2. Look at the power supply board..Its normally connected to the power co ... Flat Panel Televisions

I connected my new Antenna to my Olevia 32" or 37" hdtv model 237-T11. i was searching for the channel to come up, but the tv was asking for password and i dont have any password. i tried all my best but it was locked because of password key( parentalpassword key) which i dont know. pls find me a solution as soon as possible.


... Flat Panel Televisions

How can i tune my tv in to recieve freeview channels?? tried everything with no luck. cant even get analogue channels? i know this isnt a problem with the aerial as other tvs work!!


In the US, you are not able to obtain free HD channels without a tuner and an antenna. Some HDTV's have built in tuners and depending on your location to the broadcasts, you may be able to obtain reception. It is possible that one of your TVs has a ... Flat Panel Televisions

LC32D44E An active antenna has been connected to the tv. I can fetch informations for the channels, but it only show a blank screen with "No Video". I know for a fact that it works, since I have another TV that works with the CI card and the antenna. Tried the with and without supply voltage, same problem.


... Sharp Aquos LC-32G4U 32 in. HD-Ready LCD Television

Was watching TV and trying to adjust the picture quality of my Model VS 6041 TV. The tv has an AT&T UVERSE set top box which has been working fine for 3 years. The TV Remote is looking for an antenna A or B rather then the set top box. Since I dont have a manual, I dont know what I did wrong. All I need is a manual


... Mitsubishi Flat Panel Televisions

I have a rank arena flat screen tv and for a long while now our remote control has been less than cooperative we bang it constantly to a temporary state of working :( we have tried two different brands of universal remotes neither of which connected :( need some help don't know what to try?


Most of the remotes at the top inside have either one or two led's that send the signal--quite likely the remote may have been dropped and one has come loose from the circuit board in the remote--have a shop take it apart---we fix a lot of these for ... Flat Panel Televisions

My Toshiba Tv Model 32AV502R won't scan any channels, it keeps displaying no signal. I tried it in two different places, so i know it's not an antenna problem. It used to work perfectly, I don


Check and replace its tuner. It is faulty. ... Toshiba 32AV502R LCD TV

I have a phililps flat screen tv but when i try to turn it on it has the green light for a second but then it goes to the red light blinking it was perfect yesterday i dont know what went wrong today can you please help me.


You more than likely need to repair your power supply - this is a well known issue for philips sets - pull the back panel off of the tv and check the power supply for busted/leaking or swollen capacitors replace them with the same uf/vdc you can even ... Philips 42PF9631D 42 in. Plasma Television

Hi I just got a tv from my friend and when I plug in that color was red mostly red and I try to fix to move the color control on the back but dosent work so now is so blue and I dont know how to put normal colors can any one can help me?


... Philips 55PW9363 55" Rear Projection HDTV-Ready Television

Im hoping someone will have the time to answer a question I have. I have a lg lh5000 that has stopped working. Screen doesnt switch on and standby light turns on and off intermittently. At the same time there is a hiss type sound that can be heard. No screen nor sound due to not switching on and tv stays this way no matter how many times I try. I dont want to damage the set so I not done anything to it for nearly 8 months. Does anyone know what is wrong with it and what the hiss sound is? P


It may have been a filter cap in the power supply going out---look inside for any caps that look like these--if found not a expensive repair. ... Flat Panel Televisions

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || fullblownbass.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1797 seconds