Please check whether the inverter is working and giving voltage to the display board. If not, this might require attention of a qualified service technician.
Suggested Questions/Answers :
It is recommended you read all this kind of situations
Samsung PS-42Q96HD Hi
My Samsung PS-42Q96HD went dead one day no pic and no sound- so I opened up the back and on the psu I replaced 2 bulging capacitors.
Now the tv comes on with sound but with no picture. As far as I can tell there is power going through the X and Y boards and the logic board has 2 green led lights on.
Any ideas would be greatly appreciated.
Thanks in advance
Please check whether the inverter is working and giving voltage to the display board. If not, this might require attention of a qualified service technician. ...
Flat Panel Televisions
Samsung PN50B450B1DXZA will not power up. When I try to power it on, it makes a clicking sound and then nothing for 10-15 seconds and another clicking sound. The Red LED on the front flashes when it clicks but nothing ever appears on the screen. I removed the back of the TV and inspected Capacitors but do not see any that look to be bulging. When I try to power it on with the back off, I see a green light quickly flash on a logic board just below the power supply board. Are these clues helpful
Samsung HP-R4262 42 in. Plasma Television
Hitachi 55HDT52 tv has no picture or sound. I have replaced power supply board, x sustain board, both didital boards, logic board, and incoming power filter board. Snot chips look good. I have green flashing LED in front of tv.
Hitachi 55HDT52 Plasma Television
Samsung HLR5067wx/xaa - My says we had a power surge today and the tv turned off. After that, it will not turn on. Press the power button and the greens lights flash on the front for a few seconds then it shuts off. Never get any picture or sound. Any ideas? I don't want ot just go out and buy parts without a clear plan. A bulb sure, but I get no sound either.
It may be the blue switch on the inside remove the small plate covering the lamp and tape the buttton down its on the bottom rigth hand corner ...
Samsung HLR5067WX 50" Rear Projection HDTV
I got a Sony Bravia KDL-40WL135. Blank screen. There's two LED lights: red standby and green power light.
When I turn on the TV, green led comes on, then after about 30 seconds red led blinks once, then green resumes. The green led stays solid. I think that's a SONY error code, I tried to look it up but can't find anything useful.
I have replaced the power supply, AU board, backlight inverter, logical board, and the second power supply board.
Any suggestions? I haven't checked the t-con bo
Http://www.smpcshop.com/KDL-40WL135-KDL-46WL135-p-8895.html\015\012\015\012\015\012\015\012Above is a link for a service manual.\015\012 ...
Flat Panel Televisions
No picture or sound with a red flashing power light. Have replaced the convergence IC's but no change (do not have the chirpint sound). Removed main power board & green LED does not light up
On that model the conv IC is usually not the solution. I believe its the blown capacitor problem with is an easy fix. Check the site www.TvRepairKits.com for a repair kit. ...
Hitachi 53UWX10B 53" Rear Projection Television
Toshiba model 42hp66 Plasma flat screen
No picture or sound.
Pushing on button 2 clicks are heard
A slight hum is heard at the Z SUS board.
Green power light is on (power light is red when unit is off)
Slight clicking sound from Y SUS board. Now that I replaced the open Fuse.
(Fuse 4AH250VP Found open on Y SUS board as looking at rear the Fuse on the left).
Still no operation?
Do you still have the clicking noise? The tv turns on but no response issue is associated with the main A/V board 99% of the times if there is no clicking sound ...
Toshiba 42HP66 42 in. LCD Television
ILO p42bskh-us2 has standby power, powers on, but no sound or picture. there are two green leds on the mainboard. after about 1.5 seconds relay8001 on the mainboard visibly sparks, the relay(s?) click off, and led8001 turns from green to red. i've located the voltage values that should be tested for, but i'm not sure where to test as i can't locate ANY information on these sets. it has the samsung 42sd v3.1 common to norcent, tatung, and many other noname plasma panels. mainboard is samsung
Tatung P42BSKH Television
Samsung s5053, will not turn on.
clicking noise inside, screen comes on and goes off. No picture.
checked voltage on pin 10 get 5 volts connector cn804-1.
research on internet seems to point at main power board, but some think its standby power board.
I was going to replace the PSPF501A01A board. But don't want to spend $100.00 on wrong board.
Any advice will be helpful.
Ken, did you ever find out what was wrong with your set and have it repaired?I have the same "clicking" problem when first turn on the TV. First, it took about 30 secs clicking (came from the relay) then came on ok. The wait time gradua ...
Samsung HP-S5053 Television
No picture I have replace logic main board and y main board but it remain into standby when it does not show that the is remote interference and I plunge out the logic main board from the power supply it gives sound and I can change channel.
Samsung PS42B430 42 in. Plasma TV
Hitachi hdtv - replaced SDR upper board a year ago and tv was ok. Replaced the SDR- lower board and two swollen capacitors on the power supply board. Now the tv works with picture and sound, but I have a 4" band of green snow accross the upper section of the bottom of the screen, and green and blue lines on the upper section at the top of the screem. Tried a million times to reseat all the ribbon cables. Any ideas?
Hitachi P50H401 50 in. Plasma HDTV
I replaced three cans. they were bulged on the top. i plugged the tv in and it did the same thing. i said it blinks 4 times fast but it is only three. blink code says 3=RESERVED. i pulled the the y-sustain plug off the power supply board and it does the same thing blinks 3 times fast. when it is powering up i hear a popping noise and then 2 green lites just to the right of where power cord plug is, they come back on then it pops again they go out, the 3 time it pops, lights go out, they stay out
Philips lists 3 models of your TV:1) 50PFP5332D/372) 50PFP5332D/37B3) 50PFP5332D/37EUser Manual for your TV (actually for the 50PFP5332D/37E): ...
Philips 50PFP5332D 50 in. Plasma Television
Hello, i have a samsung 42' plasma tv model #pn42c450b1d. the tv doesn't want to turn on. i plug it in and you hear a clicking noise se a red power light. also when you press the power button on the tv in the back u see a green light come on for a second on one of the circuit bords( the one under the power board) and simutanously you see a red light come on and and off at the same time on the circiut board with the av, hdmi, inputs. i looked and thier doesn't seem to be any bulging capaciters. a
Hi.As you know the TV is in protect mode because an internal fault has been detected. I think that you already tried leaving power cable disconnected for ten minutes. After connecting back restart the TV with no device attache ...
Flat Panel Televisions
Fixya tv I have a Samsung LCD TV. Model Number LN40B530P7FXZA. In January this year my TV picture went out and only had sound. I replace the power supply board and all was well. Well the same thing happen again but this time one of the fuses on the board has blown. I replaced the fuse and as soon as I plugged in the power cord it blew. I did this twice. Should I get another board or is it something else? Thanks.
It sounds that there should be a dead short circuit in the power supply board's circuit. If you are not familiar with\012electronics, do not attempt to repair. \012Whether you suffer fatal electric\012shock. Instead, conta ...
Samsung Flat Panel Televisions
I have a Samsung LN40A530P1FXZA. It will not power up. I get 2blinks followed by short quick blink and then it repeats itself. I have replaced the power supply board and also the main board, and it still will not work. Does anyone have any idea as to what is going on with this tv? I wish I had an error code book for this tv, but I do not. The only thing I have not replaced is the TCon board. Need someone's help.
Try to download the manual on www.retrevo.com to see the error code for sure..Before you decided to replace t-con board please refer to the manual first,,but there is the possibility that t-con was faulty.Hope it helps..don't forget t ...
Samsung LN40A530 40 in. LCD TV
Samsung dlp hls4666wx TV. After a power surge, my TV shuts off after about 4 minutes. The stand by, TV, timer lights flash...manual says it's the bulb or fan. Only, I bought a new bulb, and noticed both fans are working. Still does it. It makes a small pop them hiss or buzz sound when it offers the bulb down. The power supply and ballast look ok (circuit boards). Perfect picture and sound before shutting down. I've heard there are 3 fans but only see two. Could it be another fan I don't see? Or
I have a Samsung LN40A550P3FXZA that is giving me problems. When I first started noticing problems I would turn the TV on and I would hear the power-up sound, the backlight would come on and then the red LED would flash a few times then the backlight would go off and it would repeat (power-up sound---backlight on---LED flash---backlight off). It would do this several times. Sometimes I would be able to get picture if I hit the source button on the side of the TV when the backlight first came
Try Samsung parts. They will almost always have the parts. As for the price. Its either 175$ for the board or a new tv. You have no other option ...
Samsung LN40A550 LCD TV
It started with the convergence going haywire, not fixed by restoring factory default or advanced adjusting of convergence. I turned the set off and unplugged it. The next morning it would not come on - only the green light flashing. Coincidentally (???) the cable box also would not even power on - had to be replaced. I researched and found the problem with the green light (DM board kit available with 7 capacitors and 2 fuses plus instructions). But, am I going to have to replace the convergenc
Projection TV sets have two very common problems. One is convergence ( 3D/Warped video) the other is CRT fluid ( Dull Video). Here are more details and solutions for both. Repair kits with instructions are also avail from ...
Mitsubishi WS-55511 55" Rear Projection Television
Have a Samsung Model LN32B360C5DUZA no power is going to LED TV. Have no stand by lights looked at power supply board could not see anything wrong with any board items.
Flat Panel Televisions
I have a Philips 32PF5521D and currentky have no sounds. I have a picture but when i go to turn the sound up on the remote nothing happens. The green power light is also flashing a green light. Is there anything i can do to fix it?
First look on power supply board for bad capacitors they will be vented or swollen on Top, If No bad Caps then try resoldering boards ,if this does not clear out the problem then replace the SSB board ,known as signal board . ...
Philips Flat Panel Televisions
I have a Samsung SyncMaster 730mv 17' Monitor. It's been sitting for nearly a year. After charging it, the power button does not turn on the monitor. I've pressed the Menu button & the Power button to get a reponse of a blinking green light [3 blinks] yet it will not power on when the Power button is pressed. Any ideas on what is going on??? I am not computer Savvy' [The result I'm looking for is to utilize the monitor with my Asus laptop.] -Ty for reading'
Samsung SyncMaster 730MW (Silver) 17 in. HDTV-Ready LCD Television
I have a Hitachi 51F510. When I power it up it clicks like it always has and the power indicator light in the front comes on but it has no picture or sound. The remote will power the unit on but after a few seconds it wont power the unit off. I opened the rear panel and only saw a green light on, dont know if there is suppose to be more than one light inside. Any help on where to start would be greatly appreciated. the internals are filthy, going to get a can of compressed air while I wait a rep
You need to follow power cord inside the set; should be a board on right side it goes to----this set uses up to 3 small black relays---one or more is bad---tap on each until power light goes out.if questions let me know. ...
Hitachi 51F500 51" Rear Projection HDTV-Ready Television
While watching the T.V. I started experiencing a random of two to ten second very loud static, popping sounds then it would go to a green then a digit scene then a gray w/loud sounds the popping sounds the the picture will freeze. I will wait a few minutes and the picture would return. this last time it did the same thing but the T.V. went off and would not power on.
Your set has a problem with its power supply. If it is under warranty, have it replaced ASAP. If your warranty has expired, you can take the set to any good repair shop - ask for an estimate before having any work done to it. ...
Element Electronics FLX3711B 37 in. LCD TV
Hi I have a Philips 42PF5521 and recently when switching on clicks to come on and after say 3 seconds goes straight back off again , on disconnecting the power cord the flashing green light goes off then when I connect the power it goes onto standby and comes on or it did it gradually took more attempts to get it on and now clicks but won't come on at all!! Is this fixable?? New power board or am I wasting my time? I, ll have a go if I think it's fixable!
Ad capps on power supply use hair drier on panel or aim it in bk of telly bet it comes on ...
Flat Panel Televisions
Hi ihave lcd samsung la32b350 power and inverter board are in one board my problem i hav one lamp broken the picture are com second than go how can i enabel the protector
Flat Panel Televisions