Having problems with your Flat Panel Televisions ?

LCD screen on a Sanyo DP46848 is lit up (backlight = OK) but picture very faint and is washed out - no control over brightness, contrast or color, removing the LVDS cable from the main board results i


\015 Input LVDS signals and power to T-Con board from a Sanyo DP52848 that had a broken screen but still displayed a picture (different T-Con board because screen was made by Sharp instead of AOU, cable from DP46 T-Con matched the Main board of the DP52 (same assembly except for an extra cable connection for inverter signal) verfying that the powers supply and Main board was good on the DP46. Bought a "supposedly" good T-Con board off Ebay that was wrapped in standard bubble pak when it arrived (standard clear not anti-static pink as it should have been) and no other anti-static protection used at all (even aluminum foil would be better than bubble-pak). Wasn't expecting a whole lot from the "bought" board, and sure enough, some screen condition but with "artifacts" randomly appearing intermittantly in various places on the screen. Suspect either T-Con or LVDS cable, hopefully not a bad screen...\015

Answers :

Repair Help & Product Troubleshooting for Flat Panel Televisions
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

LCD screen on a Sanyo DP46848 is lit up (backlight = OK) but picture very faint and is washed out - no control over brightness, contrast or color, removing the LVDS cable from the main board results i


... Flat Panel Televisions

Sanyo dp46848 has a washed out lcd screen... high brightness, very faint picture and OSD with moving warning about no signal present. Brightness, contrast and color controls have NO effect on the pict


... Sanyo DP46848 LCD TV

42inch olevia too bright colors distorted has new main board still same what can i do?


... Flat Panel Televisions

The tv model is Sharp Valeo - 181 channel / cable ready, the problem is i adjust wrong the Contrast, Brightness, Color of the tv, and now i cannot put back the exact or original no. Of the set up or no. Of the color,contrast,brightness of it,? Please help me


... Flat Panel Televisions

The convergence board has a +20V & -20V input. The +20V is OK, but the -20V measures about 4.5V when the cable is disconnected from the convergence board. I could not find any blown fuses but R858 & R859 on the Main Power Supply Board "appear" to have been overheated. I can not tell for sure though without removing the board and without a schematic to know what their resistance values should be. Although R858 & R859 are in the immediate area, I'm not sure if they are even in the -20V circuit. Ca


Replace R858 and R859...They also go bad frequently when the STK chips fail. \012\012For everyone else...\012\012All projection TV sets have two very common problems. One is convergence ( 3D/Warped video or d ... Akai PT5598HD 55" Rear Projection HDTV-Ready Television

Visio VO420E, The left side of screen has a 6 inch wide group of colored lines, I removed the cover and the lines are directly in front of the main circuit board area (not the power supply board). Do I need to replace the whole board or is there a component that is known to cause this? I would appreciate any help you could give me.


Lines like that are almost always a bad LCD Panel, but just to test...Bring up an onscreen display (setup menu, volume bar, etc.) that originates from the TV ITSELF, not your cable, satellite, etc. You need something that intersects the area ... Vizio VO420E 42 in. LCD TV

In my tv is 10 years old and by the 2007 we replaced with new board(Only the CRT is the old one). Last day I was switched on my tv only sound only came and no picture. I can able to see the menu setting in TV live volume increase and decrease, Chanel nos etc. When I remove the external cable connection the display comes like blue screen(looks like the CRT is ok). When I inserted the cable the blue screen goes off and became black color during that time the audio of the tv is good. Pls help to s


Hello\015\012Your TV is fitted with Toshiba kit I understands from your description. There is a sub-brightness contorl on board [a small preset resistor, which can be adjusted with a small screwdriver] fitted near to the LOT and towards its le ... Flat Panel Televisions

Hi. I have an LG 47LB9DF-UA LCD TV with a video problem. Originally, I had problem with horizontal lines, accompanied with a lag. After a short time the screen would then get multi-colored vertical lines. If I turned the tv off, then back on, the lines would be gone. If I left it on, the process would start over again. I opened the tv and found two connectors from the power supply board to the main board loose. After removing then reconnecting them several times, the problem cleared up. I l


... LG Flat Panel Televisions

Intermittant sparking type noise from the pcb where mains cable enters (power board?) resulting in an intermitant flickering of picture


You need new power supply board........... ... Flat Panel Televisions

TV powers on and the LAMP light blinks. There is no picture no sound. This problem arose randomly and out of the blue. Some sources as well as other answers here recommend to replace the lamp, but the lamp glows bright. As well, I removed the lamp from the housing and everything appears to be intact. The blink codes for this unit only indicate that the unit is powering on and will be ready in 15 seconds. Other sources I have read also suggest the digital main board is toast. Seems to be quite a


... Samsung HLR5667W 56" Rear Projection HDTV

The color on my Samsung LNT3242H LCD tv is very intense. The reds are really bright and so are the yellows and greens. I can't adjust them. Is this caused by a bad main board?


Did you fix it? How?\012 I Have the same problem,,, ... Samsung LNT3242H Television

I have a Sony KDL-46S4100 LCD that was given to me that doesn't work. It powers on and the power LED is green and the backlight to the tv works and stays on as well but I get no picture or on screen display such as the menu. I can hear sound from the speakers when the input is set to the correct one. I purchased a replacement T-CON board but the problem persists. If I do the LVDS cable wiggle test I can see noise come up on the panel. It varies from vertical lines of different colors to whe


... Sony KDL-46S4100 46 in. LCD TV

I replaced the 7 capactors in the DM for a ws 55511 TV. Now I can't figure out where all the cables go on the main chasis board. One connector may have bent pins. Is there a color layout, or is th


... Mitsubishi WS-55511 55" Rear Projection Television

I have a Vizio TV VO320E model that I bought with a bad image problem. I have sound and it responds to the remote. The image is white with vertical lines that move across the screen. The T-con board is attached to the LCD panel, it is a small card measuring 1 "x 16", Two flat cable going to the LCD. I do not know if the problem comes from the main board or the T-con board (attached to the LCD)? There are several main board for sale on Ebay. Can you help me determine which one is failing.


Hi.based on my experience in repairing LCD TV's according to what you describe the problem must be on the T-con board however do first some re soldering on the t-con board and re tighten all the connectors on it.A loose cable connectors could result ... Flat Panel Televisions

I have smasung dlp 6756/xaa after replace SMPS main board, when i turn on the tv I got burning smell found middle of the tv section hehind screen wheel looks like electrical signal cable burned off, i already changed lamp, changed SMPS board and finally burned off cable. I am tired of this process, right after 1yrs late since i bought it starts problem. first symtom was light blinking, on and off, so i replace lamp, and changed SMPS board and more and more. some say digital board problem or so


... Samsung HLT6176S Television

Cable connection broke off while unscrewing the cable. I removed the back and found a green circuit board. I am not sure what the circuit board part number is. My guess is 8KT00501A0, but there are several numbers on the circuit board.


Carry that piece to the retailer, he might be able to identify. ... Dynex DX-L26-10A 26 in. HD-Ready LCD TV

The TV has a section of it that is dimmed out and darker in brightness. Is this the Main Board that needs replaced?


Check the CCFL lamps used in the backlight section. These camps can cause this type of fault, as they are very like the flourocent tube lights that we use to illuminate our room. As it goes older, the ends of them will get burned, and the intensity ... Vizio 55" M550NV Razor LED LCD HDTV, 1080p

I have a samsung dlp HLR6168W just replaced the color wheel and now the people faces are real bright and shiny adjusting brightness and contrast doesn't get rid of it.


... Samsung HL-R6168W 61" HDTV

I have a Sanyo 42 inch Mode Number: DP42647. I bought it 2.5 years ago, and suddenly, the video is out. The sound is ok, as well as the "power" green LED. By looking at other forums, it seems every Sanyo TV purchased in 2008-2009 has the same problem. Some owners report having their units taken to a technician, and their response is the "main" board failed. The main board in my TV is: N4VE MAN. I can remove it, and buy it online. Should I be worried about having more failed components?.


... Sanyo 42 in. LCD TV

I have a HP 4260N Plasma TV. About 4-5 years old. A week ago the remote would not turn the TV on, and there was no volume. I contacted my cable company and thinking it might be a remote problem they had me reset the TV and the Cable Box. So now, the remote and TV are working correctly from an on/off perspective, but the picture is horrible. Very faint, no color or limited color, and a bit fuzzy. Is this the dreaded bad YSUS Board problem??


... HP PL4260N 42 in. Plasma HDTV

I have a Vizio VP42 HDTV (inside says LG PDP42X3U400). One day I turned on the TV and heard a pop. I took off the back of the TV and inspected the main power supply board (P/N 6709900019A). Capictor C802 had totally blown up. The tv would not power on at all. I removed U801 and when plugging in the AC cord I heard two relays turn on and then back off after 1 to 2 seconds. I gave up troubleshooting that board and bought a new power supply board. When I installed this board and plug in the


If Va and Vs are missing even when the Y-sus board is disconnected from power board then the new board is defective - return it. On the original one the board is shut down (the relays are disconnected) because there is still a short on one of its out ... Flat Panel Televisions

On my plasma tv I have a bad lower Y buffer. When I remove the lower buffer board I get I picture at top of tv... should I also replace the upper buffer and the main board


Yes. In most cases, lower and upper together have to be replaced. Check this link for more details. ... Flat Panel Televisions

42LG30 LCD watching TV last night and the colors just went wacky. seems to be to much red, brighter shows ha e the most color distortion. I tried the expert color controls to fix it but it didn't work. we have had this TV for 4 yrs and the main board has been replaced twice due to malfunctioning buttons and IR sensor


The TV will need to be properly diagnosed to be sure of the problem. A defective power supply output, main board, LVDS cable connection, t-con board or t-con/LCD ribbon connection can cause video display issues. ... Flat Panel Televisions

Television Tv stuck in standby front led blinking only.Once the front led is blinking will not stop blinking by switching off with remote or side contol on tv. The only way is by removal of mains plug. Power supply used is Vestel 17ips10-3. Will change power board if this fault is caused by faulty board. Can anybody in the know confirm that the fault as explained is likely to be caused by a fault in power supply board.


... Flat Panel Televisions

Hi, My name is Cristina Muller, I livein Trinidad. I bought a Akai LCT3285TA three years ago and now suddenly since a week ago when I turn on the TV I see the hair in blue and some backgrounds in pink, I tried to move the brightness and contrast and hue. When the blue on the hair or around the people disappear the colors are no more bright as I have to put the brightness almost at 100% Do you know how to solve the problem ? thank you very much for your assistance


I'm assuming that you have tried to cure the tv by reseting it from the menu and it didn't helped.The symptoms you describe indicate that the image processor no longer decodes the colors correctly. Since it's glued on the motherboard it means t ... Akai LCT3285TA 32 in. LCD Television

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || fullblownbass.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1371 seconds