Having problems with your Flat Panel Televisions ?

Just bought SAGEM PVR second hand but no instruction book. previous Toppfield PVR worked fine but SAGEM box says that the aerial connection isn't working...it is plugged into the right plug but checking cable, plug etc and it still won't work...Suggestions please?



Answers :

Repair Help & Product Troubleshooting for Flat Panel Televisions
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

Just bought SAGEM PVR second hand but no instruction book. previous Toppfield PVR worked fine but SAGEM box says that the aerial connection isn't working...it is plugged into the right plug but checking cable, plug etc and it still won't work...Suggestions please?


... Flat Panel Televisions

Viera TC-P50ST30 My TV is DOA. No power, sound, etc. No standby light. Confirmed house fuse, batteries, plus, etc. good. Tried unplugging for awhile. Makes a noise when I plug in to powerstrip or directly to wall. Someone said possible short. Pulled back cover. Checked ribbon between power supply and main board. Meter reads 5 when main not plugged into power. Drops to 2-3 when plugged to main. Is that where the short is? Isolated main by disconnecting all other connections to main. Should I ju


This may help... ... Panasonic Viera TH-50PZ85U Plasma TV

Sound jumps from speaker to speaker, then off, then both then crackles back to left, then right, both etc. checked each speaker but there are little circuit boards etc. Don't want to try to trace wires etc.


The speakers , because of their way of functioning, require a large amount of current. That current, if the wire connectors or the solderings are imperfect, can cause a lot of heating and deformation in the metal parts of the connectors, breaking the ... Panasonic PT-60LCX64 Television

Mitsubishi WS-65809. Yesterday, plugged into the wall in the first outlet, I powered off my modem and computer (trying to get Cox to fix my internet connection) that were attached to a power bar in the second outlet. TV was turned on. Once I got my internet connection working, realized that the TV was no longer turned on, and would not turn on. Made sure plug was seated right, but no dice. Checked the outlet to make sure it was working, and sure enough it was. Plugged the TV to another outlet, n


Hi mikalkintner,\015\012\015\012Is your tv haven't a led light in the front panel? I need to know to assist you further.\015\012\015\012Jdvillanueva ... Mitsubishi WS-65809 65" Rear Projection Television

Sansui SV-3715LCD, I switch off the unit at the wall socket, when I plugged it in the next day there was no power, not even the LED indicator light on the front of the LCD activates. I checked the plug power and it has AC supply voltage right up onto the internal Switch-mode power supply board. Any suggestions


Continue to check--every set has a standby power supply that powers the remote circuit to turn set on and it runs 7/24 if set is plugged in.Never a good idea to turn set of by taking the AC away--it can cause micro problems(micro processor). ... Flat Panel Televisions

OK, following your advice of March 9th I got a new lamp from Mitsubishi and replaced it tonigh in my Mitsubishi rear projection model WD-62725 TV. The old lamp was clearly broken. However I have installed the new one, replaced the front cover, etc., etc. and when I plug in the TV I hear a faint whirring sound on the far right (as I face the front), sounds like a cooling fan probably, but when I press Power either on my remote control or press the Power button on front of the TV, nothing happ


Hi,\015\012That sound may from the color wheel. Open the angine, open block front of lamp. \015\012\015\012\015\012\015\012open co ... Flat Panel Televisions

I have plugged in the Parrot by Martin Szekely and I I get is the opening menu with four colored blocks and the website address. When I go to the back the navigation keys do not work (I have pressed lightly held down etc.) and also the stand by button also does not work. It seems like I may have a dud as I have no way to access the menu. Any top tips? Also, does it connect to a MAC? I have parellels but wanted to check Nancy


This is a very simple digital frame that needs to connect to a pc or Mac (yes, it will work with one) via WiFi or Bluetooth. If you can't go into the menu to pair it then yes, you got a dud and you must replace it.\012\012\012But you should tr ... Flat Panel Televisions

My tv has suddenly gone dead checked plug etc no light or anything


Check the power supply regulator section for fault. If you are not handy, contact any experienced service technician. Handling power supply board and repairing it will be fatal to an unexperienced one. ... Flat Panel Televisions

The power is not working on the actual TV. We have checked all the cables & unplugged & re-plugged in everything! The little light isn't on for the power (lower right hand corner) Any suggestions? thanks!! Shirley


Yes bad power supply, if you take out you will probably see bad capacitors on the PS board. Replace and set will come on ... Protron PLTV3250 32 in. LCD Television

I have a mitsubishi WS 65711, we were watching a dvd and the tv shut itself off and wont turn back on now. When u press the power put it acts like it will turn on then a second or 2 later will shut itself right back off. The green light doesnt blink or anything. We tried unplugging it for a while then plugging it back in. We also tried resetting it but that didnt work either. Can u give us any possibilities as to what to check for, like a fuse. Or what u think it could be. Thanks for the help.


Hello,It's the problem of overheating in the power supply board of the TV.on the power supply board of the TV there are few capacitors and IC.any of this IC is got short or may be weak.so due to this when you start the TV the current pass ... Flat Panel Televisions

Sanyo dp50719 plasma tv, unplugged right before thunderstorm, later plugged back in after storm passed, front green light comes on for 16 seconds, then can hear relay click and turn off but immediate


Have you checked the inverter board? If it's good check what plugs into the inverter board. ... Flat Panel Televisions

Sanyo CE32L D81-B from plug in i only get blue stand bye light, when pressing a button light goes off, no picture or sound just dead, no blue screen etc..... had a peek with back off (quite capable) and no burn marks or loose plugs etc, just wondered where to start etc, no history of the set but no damage marks and unsure how old it is, its a set i have inherited with an empty house my friend moved into


If the problem is same with different input devices and you have ensured there are no loose contacts in power outlet, RC jack, cable and sockets, the TV needs servicing. ... Samsung Flat Panel Televisions

Okay, so i plugged my xbox in and then i plug it into the tv, but no picture pops up at all, it says check cable signal, but i don't know what cable, and i tried hooking it up in the 1 component(under the 2 cmponent because there's only 2) can u tell me what "check signal cable is" or help me out please?


What colour are the plugs on the lead you are using, if you have a component lead it will have a green a red and a blue plug if its composite you will have a red white and yellow plug ... Flat Panel Televisions

Hi. I have a problem with my 42 inch plasma tv,when tv is turned on green L.E.D appears on bottom right and tv works as normal.After 40 minutes to an hour tv makes click sound and screen goes blank the green L.E.D changes to red on the bottom right there is still power going to the tv hence the red L.E.D.Then when i plug it out and plug it back in red L.E.D appears but screen remains off it stays like this for 3 to 4 hours before tv comes back on and the same is repeated again after 40 minute


Hello,\012\012A common problem for these is bad capacitors in the power supply, Remove the back from your Tv and look at the power supply on the left hand side.\012\012You will see roughly around 9 x capacitors that are bulged / domed shaped on ... Projection Televisions

I replaced three cans. they were bulged on the top. i plugged the tv in and it did the same thing. i said it blinks 4 times fast but it is only three. blink code says 3=RESERVED. i pulled the the y-sustain plug off the power supply board and it does the same thing blinks 3 times fast. when it is powering up i hear a popping noise and then 2 green lites just to the right of where power cord plug is, they come back on then it pops again they go out, the 3 time it pops, lights go out, they stay out


Philips lists 3 models of your TV:1) 50PFP5332D/372) 50PFP5332D/37B3) 50PFP5332D/37EUser Manual for your TV (actually for the 50PFP5332D/37E): ... Philips 50PFP5332D 50 in. Plasma Television

When I plug in the HD cables into the side of my ViewSonic TV, I get great picture but no sound at all. Plus all the plugs are plugged in correctly and I have quadruple checked.


My guess is that your source device is not outputting audio over HDMI. Probably is not the TV.Try enabling the audio for HDMI in your source device on-screen menus.Also try one of the other HDMI inputs on the TV on the rear, HDMI one and ... ViewSonic VT2300LED 23 in LCD TV

It seems as if there is no power to the unit even though it is plugged in. I disconnected cord from unit and checked with a meter and read 120 volts so the plug is good. Still no power after replugging into unit.


Take the cover off the TV and remove the power board. It is not too hard to do.\015\012\015\012Then initial it with a marker and contact us to have it shipped for repair.\015\012\015\012if we can't fix it within two business d ... Sharp LC-37D43U Television

Television would not power on one day. no sign of any problem previous to this-it just wouldn't turn on . I started troubleshooting by confirming voltage present at the outlet it was plugged in to , then checked continuity across the power cord and from the power port on the unit to the first fuse(f1) and across the fuse itself. all checked out ok. what should i do from here? tv is a SOYO DYL032D LCD


Next is check the power supply section/board replace all bulging capacitors from the power supply.use the same value and rating of capacitor.Resolder also all the components from the power supply.re tighten all the connectors..you can also replace th ... Soyo DYLT032D 32 in. LCD Television

I have a Samsung LN52AAFXZA. I unplugged it for a moment so i could untangle some cords. When i plugged it back up, it wouldnt turn back on. I tried to plug it up elsewhere and to check the remote, but nothing is working. please help!!!


MAKE SURE THAT THE END OF THE AC CABLE THAT GOES IN TV IS WELL INSERTED ... Samsung LN52A650A LCD TV

I have a mitsubishi ws55411 hd medallion, it shuts off after turning on. The code blinks 2 then 3. I check fuses on right and center boards and they check out good.


Hi karlk59,\012\012This is an indication of out-of-regulation in the power supply section. The very\012common caused of this fault is the dried-up/leaky electrolyt ... Mitsubishi Projection Televisions

Fuzzy picture...direct cable says its in the tv itself...unplugged ,plugged back in removed coaxial and replaced checked all plug ins to no avail..


Hi,\012TV seems dusty inside, please clean optical lens, rear mirror and front \012screen of TV to get better picture, need to take off back of TV by removing lots of screws at back to clean\012 it inside.\012Thanks. ... Flat Panel Televisions

I have a WS-65611 that I have replaced the caps on the DM board. Before I did that, the power LED flashed non stop, Now it does the normal 70 seconds but when I attempt to turn it on, it shuts right back off. After attempting a power up I checked the error code I got a short protect error. I then removed the DM again and verified the caps were not shorted to the shield and checked the pico fuse and found everything to be good. Any ideas of where I should start looking??


Did you run the error code operational check? In not unplug the set and plug it back in. Press and hold the DEVICE and MENU buttons for 5 seconds and release. The LED should flash a certain number of times a short pause and another series of blinks. ... Mitsubishi WS-65611 65" Rear Projection Television

The TV doesn't power up anymore - i've checked the cord connection, made sure the power switch is in the "on" position, etc. basically ran through all the possible troubleshooting solutions. the little amber power indicator doesn't even light up anymore so it seems there no power registering into the unit at all (i've checked the outlet too). any suggestions?


... Maxent MX-26X3 Television

TV was working fine. Shut it off, all power went, no red light or any other sign of power. Will not turn back on, as if no power source. Unplugged for 1 hour, plugged back in again, nothing, uplugged over night, plugged it in, still nothing. Tried other outlets. Checked the safety fuse, it is good. This TV is not over used (2 adults), TV is 2 years old.


Hello,ok you have done almost everything you can do with a no power on Tv problem, if you have the tech background you could try using a volt meter to see if the TVs power supply is getting the power it needs or if there is a lose wire on the p ... Element Electronics FLX3711B 37 in. LCD TV

I have a Toshiba 42HP66 Plasma and I have no picture or sound. It worked great and than the next time I turned it on there was nothing. It would turn on and turn off right away. I had pulled the wires to the Y-sustain board and the green light stays on and I plug them back in the tv turns on and than off again right away. Is that saying the Y-sustain board is bad?


PULL OUT THE BACK COVER GET YOUR MULTIMETER AND SELECT CONTINUITY ON IT CHECK ALL 4 FUSES AT Z SUS AND Y SUS IM POSITIVE EITHER U NEED TO REPLACE Y SUS OR Z SUS ... Toshiba 42HP66 42 in. LCD Television

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || fullblownbass.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0966 seconds