Suggested Questions/Answers :
It is recommended you read all this kind of situations
The Timer indicator on the front of the TV is continuously blinking green. I have made several attempts to fix this by pressing the System Reset button and held it for up to 30 seconds at a time. Each time I release the System Reset button, a few seconds later the Timer indicator starts flashing again. I have also totally disconnected the TV from power for up to 15 minutes but as soon as I connect it back to power the Timer light starts flashing again.
I cannot locate my owners manual for
Hi,Let me know model number of your Mitsubishi tv to provide you helpful info about problem and manual pdf file.Thanks. ...
Flat Panel Televisions
I have a mitsubishi dlp WD-65733 and it went out on me a week ago. when I power it up i get only the green light above the timer. when i hit the reset button in the front i hear a click in the back and the green timer light starts blinking for about 30 seconds the it powers off. I do not get any lights above the status or lamp. i have replaced the bulb before about 1 1/2 years ago. could this be the bulp again? when i replaced it before i had an orange lamp light but not this time.
Hi,It seems problem in power supply board that got few electrolytic capacitors leaky and causing problem. It does not look like lamp issue.Let me know are you handy with electronics stuff repair and can replace parts in circuit board? ...
Flat Panel Televisions
Power button flashes Orange every 5 seconds. I have to press the Power button 2,3 times in order for TV to start.
I'd be looking at voltage ratings for the three fans and the the blower fan located under the projector itself. Check the air filters there are two but hard to get to the one under the projector lense. Id say toss and replace they have alot of issues ...
Panasonic PT-50LC13 50" Rear Projection HDTV
When you turn of the TV the POWER indicator flashes green for several minutes. The TV never comes on. After the several minutes of the POWER indicator flashing green, it stops, I hear a click and the light goes out. Within a few seconds, the LAMP indicator light starts flashing red continuously. I unplugged the TV and waited one hour to remove the lamp. I could not tell if the lamp was blown. I can see the filament, the glass is clear, but there is a 2 cm or less spot in the right upper c
Sounds like the lamp door is not secured in place. Try removing the lamp door and put in back in until it clicks. ...
Panasonic PT-52LCX66 Projection Television
I have the WD-65731 DLP HDTV. The tv will not turn on. Initially, it will power up, and you can here the fan running. The green "timer" light will blink for several seconds. Finally the fan will turn off and the blinking timer light will go out. I have tried resetting the TV, as well as unplugging the power cord and all input cords. After waiting 60 seconds, I reconnected all cables and tried again to turn it on, but the result was the same. No other indicator lights are on during ths process
Have you replaced the lamp?? You usually have to replace the lamps around every two to three years. The manufacturer has designed it so you the customer could change it yourself without a technicion. Hope this helps. ...
Mitsubishi WD-65731 65" HDTV
Samsung HL-R5067W. Standby/Temp light and timer light flash after power button is pushed. Do hear a clicking when the button is pushed. Fans and lamp do not start. After lots of trys, I have gotten it to start with the fans and lamp working. The tv works fine for a while and then will not start up.
Timer and Temp light flashing together means that one or more cooling fans are not operating correctly. Over time dusct can accumulate near the fan motors there by preventing them from operating correctly. The first and most easiest thing to try is t ...
Samsung HLR5067WX 50" Rear Projection HDTV
My LC-37SH20U was working fine. Then, when I gor home from work and turned it on, I heard the usual volume and the "click" from inside, then the picture comes on. After only 4-6 seconds, the screen went black but the volume stayed for about 3 seconds. Then I hear a click again, and evrything goes off, but the power indicator keeps flashing green.
When I hit the power button both on the set or on the remote, nothing happens.
model are sharp LC-37SH20U
This is a fault solution which can be checked and corrected by you assuming that there is no component failure. There is a high possibility that the components over a period of heating and cooling, tend to bring on a problem of dry soldering ...
Sharp LC37SB24U 37 in. LCD TV
I have a mitsubishi projection tv model wt-46805. It started not responding to the remote control, and over a period of about a week, it got worse. You could only turn it off and on with the power button. Eventually, the volume went to max, and then the tv turned off. I can tell I have power to the tv, because when you press the reset button, the green light flashes. A friend of mine tells me that I will need a tuner unit. Are you able to tell me exactly which part I need and if you have i
Mitsubishi WT-46805 46" Rear Projection Television
I have a JVC-HD projection TV model 56G786 and all of a sudden it will not power on. When you try to turn it on the blue light on the power button goes on but after a few seconds it starts flashing and the TV will not start. What could it be? Did something burn out?
Hi,The JVC 56G786 users manual will not give you a clear or specific answer about confirming bulb failure with the LED lamp or power indicato ...
JVC HD-56G786 56" Rear Projection HDTV
With the out of warranty lcd tv Sharp recommended a service in town and they after about 5 minutes determined that I need to replace the inverter boards. They wanted over $500 so I deciced to replace them myself. Installed the boards and after plugging in the power the unit "clicked" then when I pushed the power button it clicked again then aftger about 8 seconds clicked the second time and nothing. The led started flashing steady on-off-on-off. When I first plugged in the led was on solid, now
You still have a power supply problem ...
Sharp LC-C4662U 46 in. TV
Vpw 425 viewsonic, have owned this Plasma, for several years, has always operated fine. Today it won't turn on. Main power switch is on. Standby switch is red. When I push the standby power button, it changes from red to green, I hear a click, then within 2-3 seconds the standby light turns back to red. I removed the back panel and tried to start again, after several tries there is a red indicator light (inside the panel) labeled "main power" that comes on and stays on.
ViewSonic VPW425 42 in. Plasma HDTV
My vizio m550nv will have power (logo orange) but when i hit the power button logo turns white but no picture nor sound. then after a few seconds logo starts to flash
Vizio M550NV 55 in LCD HDTV
Recently my benq mp620p projector stop working. When I connect the power cord the power button lights up green and the power led orange as usually. When I push the power button, it starts to blink in green, the filter wheel starts to spin and the lamp starts to warm up with some light comming out. Few seconds after, the fans start, the power led becomes solid green and the lamps goes of. I can't do anything else since that other than unplug the power cord. No response to any button.
I'm assuming that you have checked the bulb and it appears ok. Either the inverter/ ballast board has a fault or , much more likely, the control board is no longer capable of finishing the loading of the firmware. This is usually caused by the failur ...
Flat Panel Televisions
My panasonic 1080i will not turn on. Hit the power button and the light starts flashing green but nothing happens. After about 20 seconds or so the light goes back to red and flashes. Nothing works on the remote now. I bought this from Sams club as a close out as it was the last one (floor model) and did not have the manual. Have not seen any solutions to this problem as of yet. Please Help! W have not TV and are paying for service now.
Panasonic PT-50LC14 50" Rear Projection HDTV-Ready Television
I have a Hitachi 42PD3200 Plasma TV that refuses to turn on this morning. It was shut down last night by timer and this morning will not come out of standby mode. The red standby indicator remains illuminated when the remote control power button is pressed and the TV does not respond. I have tried changing the remotes batteries as well as cycling the power to the TV in case it needed resetting. Any ideas on where to look would be appreciated thank you!
Hitachi 42PD3000 42 in. Plasma Television
I have a Mitsubishi WD-73737 and when I turn on the tv the power light flashes very fast for a minute then stays a steady green and the screen is a solid blue. There is no sound as well. I have tried the system reset and it didn't do anything.
I was given this tv, so I don't know how old it is. The tv will occasionally work but that is very random. The only item I have plugged in is an Xbox 360 with the component cables. The menu button does work so I know the screen still works.
Do you have the input turned on that you use the xbox for? Try different inputs as well. If you are getting the menu to come up, the blue screen is telling you that you don't have a signal being run through that particular input. ...
TV remote on my model TXL2791F won't turn TV on. When I press the power button on the TV itself the little timer light blinks and the TV makes a ticking sound for a few seconds. If I press the power button again the blinking light and ticking sound happen again for a few seconds. If I repeat pushing the power button on the TV again the blinking and ticking will then go on all day long unless I unplug the TV for 15 minutes or more. All during this time the screen is dark. Just before this ha
Samsung TXL2791F 27" TV
PLASMA Model # TH - P50VT20A The red PWR light is flashing, It will not respond to the remote, the remote has NEW batteries and works BUT the TV power on swith on the side of the TV is in the ON position, if I turn the TV power switch off/ON the TV starts but only goes for about one minute!! I tried to reset the auto tuning, it starts tuning then when the first channell is selected, THE TV TURNS ITSELF OFF., with the RED power light flashing 11 times, pauses then repeats the flashing sequence a
Panasonic Viera TH-50PZ800U Plasma TV
I have 50 inches plasma Hitachi TV (ALiS 1080HD). As the TV was on, the screen stopped showing (no picture) and no sound could be listened as well, without any reason. The power light started flashing (on and off) so I turned the TV off from the power supply (as the remote control was not responding). Few seconds later when I turned the power supply back on for a moment I heard a sound (making me believe that the problem was fixed) but once again the power light started flashing with the same en
Flat Panel Televisions
Sony Television BRAVIA KLV 37S400ArnThe television can not turn on Electrical power already checked & it's ok. The last event is AC power un-plug but the timer indicator is still amber color. The timer indicator is gone after the power button top of the TV is pushed (without AC power in).
Sony Flat Panel Televisions
When I hit the power button on my Toshiba 36AFX61 tv, or when I hit the power button on the tv's remote control, the tv's power switch button LED comes on but I get no picture or sound. And, the power button LED starts to blink after about 4 or 5 seconds. Also, at the time power is applied to the TV, I can hear extra relay contacts clicking that normally cannot be heard when the tv powers up correctly.
Toshiba 36AFX61 36" TV
Received this TV from a friend, was working when it left his house, I have place on tv stand, plugged it in, hit the power button, it came on for a breif second. Now the on-timer light is blinking, I can hear the (possible) tube kicking (a clicking sound) but can not get the tv on, nor can i get the tv to stop blinking the on-timer / power light. At times it is a fast blinking (once a second), other times it is blinking slower, (once every 3-5 seconds). I do not have the original remote, but hav
Did u ever find a solution? ...
JVC AV-32150 32" TV
got this tv not working.
found no power when conected and decided to remove back cover.
found blown PCB fuse and replaced it,turn the tv on and the picture came on for 10 seconds and when out but tv was still on since the logic board led was on,also noticed led on PCB started blinking.
pull power cord off and then plug back in turn power button on and got picture for 10 second PCB relay clicked picture died and led on PCB started blinking again.
what do you think?bad PCB or ba
Hello\015\012The power regulator PCB has some fault it it. It does not outs proper regulated voltages needed to the other PCBs in your TV. Normally Plasma TV power regulator PCBs are very difficult to repair, and PCB as whole should be replac ...
Philips 50PFP5332D 50 in. Plasma Television
Mitsubishi WD-65738 won't power on red light flashes4 times and then yellow flashes 8 times. I have held power button in front for 10 seconds,green light flashes for a second then it goes back to the red/yellow flash,please advise
Mitsubishi 3D DLP 73 Home Cinema TV WD-73640