Tv now turn on,have a flashes of screen backlight,have picture only a few sec. and dies and have audio left only?This problems alway tv are having dead 1 or 2 long LCD inverter boards.These 1 or 2 long LCD inverter boards are dead.These 1 or 2 long LCD inverter boards job are to help the LCD screen panel have a backlight to produced a picture.Tries tv turn on and off a few time,if tv get a stable picture and work,than have a dying tv Tuner signal board,that the board where the incomming broadcasting signal cable plug into it the problems.Instead of those 1 or 2 long LCD inverter baords.Tries websites like Shopjimmy.com,Ebay.com to buy those refurbihes 1 or 2 long LCD inverter boards and also tv Tuner board.
Suggested Questions/Answers :
It is recommended you read all this kind of situations
When I turned on the tv this morning it only had audio no video. Their was no menu or screen saver when I pressed the menu or input buttons it looks as if the tv is off but I can hear the audio fine. What should I do next? Should I get a sledge hammer?
Tv now turn on,have a flashes of screen backlight,have picture only a few sec. and dies and have audio left only?This problems alway tv are having dead 1 or 2 long LCD inverter boards.These 1 or 2 long LCD inverter boards are dead.These 1 or 2 long L ...
Flat Panel Televisions
Video issue. Have solid green light and audio. Have black screen with small white dots evenly spaced across screen. But I hit menu and can see that screen fine. What's going on?
If model number is correct either in the optical light engine or possible E2P tiny board that has the eprom's on it.The set has a hard reset that can be tried if you research model number of set for "option menu" ...
Mitsubishi WD-57733 57" HDTV
I have a Toshiba model 36A42 TV. I do not have the original remote. It has been working fine with the universal cable tv remote, I can turn it on/off with that remote, I can hear sound, but can not change channels. The TV screen somehow got stuck on one of the menu screens. It is a blue screen and says System Information at the top. It lists some information: Model, region, s/w ver, sdk ver, etc. At the bottom of the screen, it says System Reset Done. At the bottom left it says checksum: 14
Toshiba 36A42 36" TV
Sharp aquos getting only audio and blue screen for video :(
i have done all troubleshooting steps and now just want to buy the board needed.
all caps are looking ok
tried the reset.
tv just turns itself on when i plug it in
dont have the remote so no clue if menu shows up.
backlight apears to be working and when i hook up xbox 360 i can hear it boot and see the screen get brighter (not much)
thanks for your help
HelloDigital video processing stage on the main board is faulty. The main board mey need repacement ...
Sharp LC32D62U 32 in. LCD HDTV
My toshiba model TV 42AV500U TINE IS NEW ONE YEAR NOW, HAVE PROBLEMS WITH THE AUDIO, NO ONE HEARS FROM THE MENU AND I SEE THAT EVERYTHING IS OK. NOT IN THE MUTE FUNCTION, PLEASE KNOW THAT I What i need to do urgently
Unplug,replug tv and cables or satalites boxes back like about an hour later for the tv to do a restting itself back to the factory setting.Those pay boxes,to reboot and upgraded it softwares.Than go into the tv menu go to tv Audio Setting to do rese ...
Toshiba 42AV500U 42 in. LCD HDTV
When i play dvd i hear background music really clearly and voices are hardly audible - this happens on channel 5.1. if i swap to channel 2. i hear the filmmaker commentary! dvd was working fine until granddad came to babysit one evening!!
using an lg dvd with lg home cinema speakers (lh-t550tb). Wierdly the pre movie trailers are all fine!
Sounds like the speakers are out of order and/or maybe 1 or 2 not connected. use a AA battery and "pop" each speaker wire. it's low voltage and amperage so it won't damage your speakers. but the pop will allow you to know exactly what speaker you hav ...
Flat Panel Televisions
I have an lg 32ld350. I plugged in headphones into it as to not annoy anyone with the tv and when i was done i unplugged them and now i have no sound unless i use headphones. Even with them unplugged it tells me that it's still connected when i try and reset the audio in the menu. All audio settings in the menu are grayed out and it won't let me do anything. Please help.
Turn off ur tv.Tries take the head phone steal jack plug it in and unplug it out do this like three or four times.Tries the tv menu audio resetting again.The audio should return.Don't used ur tv head phone again the input jack socket it have problems ...
LG 42PX5D 42 in. Plasma HDTV
My TV was working just fine yesterday. But now when I turn it on I can hear it but it is just a black screen. When I take it off on CH.4(my cable channel)it is no longer all black, the fuzzy screen appears like usual. And then I turn it back to CH.4 and again just a black screen, but I can hear the TV just fine, even when I turn the cable channels.
Sylvania 6419TA 19" TV
My sharp aquos LC-62C42U is part of a home theater system. Everything was fine this morning. I turned the system off and when I turned it back on several hours later, I have no audio. I checked my receiver by setting it to tuner mode and I instantly have audio, so my presumption is that the receiver is fine.
On the set itself connect a DVD directly to one of the rear inputs to see if audio that way.---if so set is likely good.Check hookup etc and in set menu look to see if speakers for some reason are OFF> or set to external. ...
Sharp AQUOS LC-62C42U 42" LCD TV
I have an LCD Television set Model number LNS3238DX and the picture quality seems to be grainy and poor. When the menu button is pushed, that picture of the menu screen comes in just fine. I noticed that one of the capcitors was bubbled up, so I replaced all of the capacitors on the power supply, but it didn't solve the problem. So I am now wondering if the STP03 is defective and maybe I should change that out because everything in the power supply seems to be running just fine. Please let me kn
If you had a bad cap in the power supply you probably have some more caps that are bad, but may look good, and also change the bridge rectifier, it probably is leaky, and that should take care of the noise problem, if that d ...
Samsung Flat Panel Televisions
TV 2 oldies but goodies..............first problem with the Panasonic...it shuts off a couple of minutes after U turn it on, then comes back on by itself. Does this a few times and then continues to play fine. Very anoying.
Second problem is audio with the Toshiba. Thru the cable into the turner...snap..crackle..pop. Using the video 1 & 2 inputs, the audio is fine. Im thinking on this one the cable hook up on the tuner broke loose. And finaly the picture has the slightest tilt from left to righ
The slugs have nothing to do with tilt; unless a tilt setting in main menu bonded yoke has no adjustments for this issue. ...
Standard (CRT) Televisions
Samsung TV LN40B500P3f - No Picture ; just audio Hello, Our Samsung LN40B500P3f TV audio display is black; audio works fine. If I turn TV off and then back on the picture does display for a few secon
The set will need to be properly diagnosed to narrow down the problem. You could be looking at a bad inverter, bad CCFL lamp, fault in power supply or main board. ...
Samsung Flat Panel Televisions
I have an 11 year old Toshiba DVD player. The last 2 times I rented a disk I had problems. Everything seems to be fine through the previews. When the movie starts to play, the screen goes green. The audio is fine. The video is there, but everything is green. I try the DVD in another player and it worked fine. I tried it in my laptop and it worked fine. Has anyone had a sinillar problem as this? Is there a solution to this issue? Please let me know
This is usually an issue with the component cables running to the TV. Remove the cables and retry with different component cables. If this doesn't fix the issue, its a problem with the DVD player itself.As far as DVD players go, you've do ...
Flat Panel Televisions
i have a lcd toshiba regza LV733N, and i get no audio when connected to pc on hdmi connection. but i do get audio on the same hdmi cable when is connected to my ps3. on a lcd panasonic, both the video and audio connection works fine.
i use win 7 x64, and the sound icons mutes when connected to regza.
You must use HDMI 1 port when conected to a PC (to have a picture). Also set the audio in to HDMI not to PC. Look at SOUND/ADVANCED AUDIO. You can use separate analog cable also... Please just read the F manual ...
Flat Panel Televisions
My 50PC3D will not start. Worked fine. I heard a pop and it shut down. When i push the power, the green light flashes and i can hear the relays kick, but after about 3 seconds, the green light turns to a steady red. All the caps look fine and the fuses are fine.
Replace the power supply via ebay type in your model in Ebay search bar ...
LG 50PC3D 50 in. Plasma Television
What's your problem?I have Samsung CS-29Z57MQ (29in CRT Slim TV) and due to curverd corners I tried to set using service menu (info - menu - mute - power). While setting I accidently pressed INFO button again and it auto changed some G2-Adjustment values. I switched off the TV. From after that TV is not turning on, its on standby mode and when I press power button or service menu button I only can hear the click but again no picture comes and it goes to standby again.
Samsung Standard (CRT) Televisions
I hooked up the new digital box Comcast sent, but it has no audio. I disconnected the box and tried it by itself and it still has no audio. I went through the menu manually as the remote for the TV does not work and I can't see anything relating to the audio. Any ideas?
I suspect you mean by disconnecting the box and running it by itself you mean you tried to run audio from your TV by itself? Somehow you need to go through the menu on your TV setup to see if the audio output isn't either turned off or muted. THere ...
RCA F27676BC TV
I have 2 Flat screen Phillips TVs a 47" and a 20" for my camper. I bought a set of rocket fish wireless speakers for use in my camper.
I can not receive audio from the tvs to the speakers. The speaker sender does link up with the remote units but does not receive audio. I tried the wireless on a older TV with a cable converter and they work fine. I tried both tvs using the instructions TV owners manual but still no audio. I used all methods Coaxial,RCA. earphone etc. What am I missing? Are the
The sender plugs into the TVs audio out jack and you may need to select on a on-screen menu for the TV, audio out for the external speaker, in other words, the tv speakers are activated but maybe not the external audio jack for the sender unit. Many ...
Philips Flat Panel Televisions
Panasonic viera TC-L37 U22 paired with AppleTv. HDMI connection. picture is fine but t he audio gets garbled. by unplugging HDMI and replugging seems to reset for proper function. This happens randoml
Flat Panel Televisions
All of the sudden we are having audio distortion on our Dell W3201C LCD TV. Picture is fine, but the audio is all messed up!! It is 5 years old. What can be causing this problem. Would any TV repair place be able to repair a Dell TV?
What type of connection are you using for video/audio? HDMI? Have you tried using a standard composite connection for audio?Thank you,Lee ...
Dell W3201C 32 in. LCD Television
I have a Samsung DLP HLR5667 and it blew a lamp 4 months ago, I replaced the lamp and it worked fine for about 2 months and started shutting off after only running for about 90 seconds. I reset the lamp hours and it worked fine for another 2 months. Now it is shutting off after 90 seconds of running, first the picture then the audio. All three lights then begin to blink. Troubleshooting I have performed is
1. I have cleaned the interior of the television.
2. Jumpered the lamp door switch.
You need to replace your color wheel. This is a very sensitive part and you need to take care when replacing. If you feel comfortable I can walk you through it. If not, I would take it to a authorized service center. ...
Samsung Projection Televisions
I am trying to connect my proscan 40lc45s to my macbook pro 13". I have a mini display on my macbook that connects to a male/male hdmi that connects to the tv. My video is fine but there is no audio. How do I get audio?
Hi,\015\012\015\012In order to use the speakers in this TV for audio from the Macbook, you will need to use a different type of connection. There are 2 reasons for this:\015\012\015\0121. The Mini DisplayPort does not o ...
Proscan 40LC45S 40 in. LCD TV