Having problems with your Flat Panel Televisions ?

I have a 13 inch Craig LCD TV. I turned off my tv, at first it would not go off when I pushed the power button. I pushed the button again and I no longer had sound, but I still had a picture. I pulled the plug on the tv to turn it off. Now sometime later I have pushed the power button to turn on the TV. I have a picture, but no sound. Can you help me?

Answers :

Your problem has been caused by the cables getting displaced when you were pulling out the power cord.\015\012The simple and easiest solution to your audio problem is to switch off the TV. Disconnect all the cables. Wait for sometime. Reconnect the cables. Switch on the TV.\015\012If the problem still persists, Go to Settings and check the audio settings. Set them ON position.\015\012
This sounds like a microprocessor controller ic failure, the ic is the brains of the set and controls every vital part of the tv. I assume you have gone into the menu to see if the sound was turned off and probably found that was not the case. There is two suggestions, unplug the set for 24 hours in hopes the processor will reset, the second thing you can try is remove the battery backup or capacitor near the microprocessor to make the ic reset at factory default.

Repair Help & Product Troubleshooting for Flat Panel Televisions
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

I have a 13 inch Craig LCD TV. I turned off my tv, at first it would not go off when I pushed the power button. I pushed the button again and I no longer had sound, but I still had a picture. I pulled the plug on the tv to turn it off. Now sometime later I have pushed the power button to turn on the TV. I have a picture, but no sound. Can you help me?

Your problem has been caused by the cables getting displaced when you were pulling out the power cord.\015\012The simple and easiest solution to your audio problem is to switch off the TV. Disconnect all the cables. Wait for sometime. Reconnect the c ... Flat Panel Televisions

I have a sharp aquos lc-c5277un. Both the power and OPC lights together blink twice. I tried unplugging it, holding down the volume up and channel down buttons while plugging it in. That left me with a solid power light on. I pushed the power button to turn it off and it turned off. Pushed it again to turn it on. It turned on and worked. 10 minutes or so later I heard a pop sound and the lights started blinking as before. This loop has played out three times. Is this the power board or

... Flat Panel Televisions

TV remote on my model TXL2791F won't turn TV on. When I press the power button on the TV itself the little timer light blinks and the TV makes a ticking sound for a few seconds. If I press the power button again the blinking light and ticking sound happen again for a few seconds. If I repeat pushing the power button on the TV again the blinking and ticking will then go on all day long unless I unplug the TV for 15 minutes or more. All during this time the screen is dark. Just before this ha

... Samsung TXL2791F 27" TV

TV wont turn on sometimes. push the on button, light turns from red to blue but no display or sound. If I disconnect the power cord for 15-20 min and plug it back in to the tv it will turn on and stay

... LG 42LG30 42 in. LCD HDTV

Panasonic projection tv model tx 43p950x, there is power loss while I turn on the remote and there is no power when I pushed the button on front of the TV. Before it happen I connect an audio cable on the back right above mark monitor, and the other end to my amplifier audio. Then I hooked up a magic sing in front on the TV. I turn the TV and the Amplifier, both is on, then I turn on the magic sing and it works and I could hear the sound in my Amplifier speaker and so in the TV. Now I turn both

... Panasonic Flat Panel Televisions

The red light for power comes on (proton 32 in lcd television..7/28/2006 model, model number y232ano631o3384). when i push the power button its turns green for about 3 seconds and turns back to red. there is no picture or sound at all.

If it's failing to turn on, the main power supply is probably at\012fault and without some technical background and a couple of test instruments,\012you will not be able to do the repair yourself. \012 ... Protron PLTV3250 32 in. LCD Television

Picture I was litening to music threw direct box,vacumming,different outlet then tv. turned it off,& used converter box buttons to change channel. got no pic no sound. pushed more buttons,turned it off, then on hit reset, pulled card out put it back,then turned around to get remote, and saw my 82 yr. old dad holding remote as far out as he could,as if he was trying to get around me! I asked him what button he pushed & he said none. now we have sound no pic. it turns on deep blue screen no menu

I assumes that there is a confused memory IC inside, due to improper data inputs. Try a hard reset to this set. Unplug it from AC mains wall socket, and re-plug it back after 10 minutes of so. This must make it a hard reset. If it do not help you ... Samsung 50 in. Plasma TV

What's your problem? Tv wont turn on the little red light next to the power button is blinking Turn it off two days ago to sleep and in the mornin tryed to turn it on and nothing i try pushing the

What is the model of your tv? ... Flat Panel Televisions

I have a Sony bravia KDL32 L5000. pressing power button will turn green light on, but no picture no sound. Cannot turn tv off by power button. Have to unplug tv to turn off. Can hear click when you plug in tv and when you turn on with power button.

Hello,You need to check the output voltages of the power supply to see which one goes off. It may be due to short circuits some where, if otherwisethe power supply board is dead,do you know basic electronics' and soldering? Most of ... Sony Flat Panel Televisions

Power problem The TV doesn't power on. Suddenly i was watching tv and suddenly the tv was turning off, then i tried turning on (with the power button), and the image appeared one second, and was turning off inmediatly Now, when I push the power button, the tv try to power on, an image appear, and right away, the tv turning off.

1) test the outlet wall, plug a desk lamp and see if turn ON, if does the circuit is o.k and the contrary, reset the c.breaker2) test the power cord for defective and repair or replace3) test the main switch for short or open and replace4 ... Standard (CRT) Televisions

Toshiba model 30HF85 will not turn on when i plug it in it makes the sound it is coming on but then immediatly goes back off when I push the power button it doesnt come on at all

... Toshiba 30HF85 30" TV

I have a 22' viewsonic tv. i'm getting a "channel blocked" message with four boxes showing. tv is about 2-3 years old. prior to this the tv will power off then on with a blank white screen. you can still hear the program. the only way to solve this is to unplug the tv and replug again. then it will work. but this time I push the channel up and down button before the tv could turn itself off. this is when I got the channel block on all stations with no sound.

... ViewSonic N3751W 37 in. LCD Television

Samsung PN50A450P1DXZA won't turn on. Black screen backlit when power button pushed, menu won't come up; sound is fine, but no pic.

... Samsung Pn50a450 Pn50a450p1dxza 50" 720p Hd Plasma For Repair Or Parts

My toshiba 51H83 will not turn on. When uppluged and pluged back in it makes a clicking sound, but when I push the power button it doesn't come on.

... Toshiba 50H82 50" Rear Projection Television

My vizio vp50 has the green light on and i cannot shut it off. It has no picture or sound. I have unplugged it while pushing in the power button, which has not helped. In the past we had to turn the tv off and on maybe ten times to get the picture to stay on.

... Vizio VP50 10A 50 in. Plasma TV

Mitsubishi 73735 my tv will not turn on - when I push the power button, it sounds like its coming on and then it dies does and shut itself off

Tried with replacing first bulging electrolytic capacitors at the power supply board. you can find parts at www.digikey.com a panasonic brand of capacitors with low esr 105c FC or F ... Mitsubishi WD-73735 Television

Plasma My tv will not turn on. When I push the power button the indicator light turns green and then back to red. It was going on if you pushed the power button a few times, it would eventually stay on but it's not even doing that anymore. Any ideas?

I would check for swollen capacitors on your power supply. If this is the case let me know. Can be a very easy and cheap fix. If you don't feel up to it, then just change the power supply, but that is pricey. ... Zenith Z50P3 50 in. Plasma TV

We have a toshiba 72 dlp tv. We were in the living room in which tv is in we heard a pop. When we went to turn the tv on we heard sound but no picture and the yellow light on the front of the tv blinks 16 times then goes off when push the power button. The tv seems to cycle 16 blinks then goes off.

Good day!!!\015\012\015\012 \015\012 Your color wheel is clapped out. The\015\012 part is not directly replaceable - they seal it in the light engine and\ ... Flat Panel Televisions


... Hitachi 50V500 50 in. HD-Ready LCD Television

Sylvania 13tv/vcr, has this code on the tv screen (8c1-0.19) when turned on. The TV has a picture,but no sound. The power supply seems to be okay, because when it is turned on it will play for hours,but without sound. There is intermittent use when the power button is applied, if it does not work the TV must be unpluged and pluged from the outlet to turn it on and off. Do you what this code is, and why is affecting the TV?

The fact sound works for a moment when power button is held and that you have to unplug to turn off or on means not a circuit problem but that the set is likely in the tech mode or service adjust mode.I think the best way to resolve this is c ... Sylvania 6313CE 13 in. TV/VCR Combo

TV turns on but no picture no sound. Turn power button on but only the green power button located on lower right flashes on. For the last couple of months prior the picture would "skip" and I would have to turn it off then back on to get full picture. Less than 4 yrs old. Please help. Thank you.

If u are a electronics repairer,remove the power smps sectoion and replace the 820 or 1000 or 1500 MFd capacitor.it will be bluged.thank u ... Insignia IS-LCDTV32 32 in. Television

My optoma pdp50 plasma screen will not turn on. when you push the power button the led turns green and then you hear a click and the led on the power button turns back red

... Optoma SP50A 50 in. HDTV-Ready Plasma Television

Toshiba 26lv610u tv/dvd has no sound or picture The green power light comes on when power button is pushed

Replace the power supply board www.tvcircuitboards.com should be able to assist with replacement boards. ... Toshiba 26LV610U LCD TV

I bought this N2635W it wasnt turning on. (So I thought it was the power supply) I bought a new power supply, and still didnt turn on.( So I thought it is the main control board) I bought a usded controler board, then it just turned by itself and there was only a white screen. No sound no controls responding. ( So i thought it needs a new one). I bought a new controller board from viewsonic,. Now it responds to the power button, I can turn it on and off., but still theres only a white screen

The tv Tuner signal board is the cause and the problems.That the board,where the incomming broadcasting signal cable wire plug into it.Tries websites like Shopjimmy.com,Ebay.com to buy a refurbish tv Tuner signal board for the replacement. ... ViewSonic N2635w 26 in. LCD Television

My Panasonic 1080p TC-5-ps14 TV will not on when I turned power on. What I did was unplugged the power cable. Pushed on the power button for two minutes. Then plugged the power cable back anh turned on the TV. TV still won't turn on. What is the problem? Please, help!

... Panasonic TC50PS14 Plasma TV

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || fullblownbass.com || Terms of Use || Contact || Privacy Policy
Load time: 0.1515 seconds