Suggested Questions/Answers :
It is recommended you read all this kind of situations
The television power light flashes green when turned on, then the power light becomes a solid red and the lamp light begins flashing red. I don't know if there is any signifigance to this but the "card" light is a solid red as well. The tv was working fine last night, please help.
Epson Livingstation LS57P2 57" Rear Projection HDTV
Lg 42lh30 Tv runs well for awhile 20 minutes to an hour, then a click sound comes out of just the right speaker. Then the TV freezes and none of the buttons work on the TV. Once I cycle the main power switch the tv will not turn back on, thought a red light shows that power is available. I did some minor troubleshooting and found when I disconnect the T-Con from the main board, I do not ever get the clicking sound, my buttons always remain functional, and the TV seems to run fine (I can hear the
As per your detailed description, the fault should be of its T'Con itself. Replace it. There is no adjustments to be done after T'Con replacement. If you wish to get more details about how to replace T'Con board to an LCD TV, check the site linked ...
Flat Panel Televisions
My JVC HD56G786 rear projection tv is not powering on anymore. I have recently replaced the bulb (as I've done once in the past) and it worked fine for about 4 weeks. This weekend it began powering off on its own after being on for a couple hours and the blue and red lights would flash rapidly simultaneously. Now it won't power on at all- it begins to power up and then immediately shuts down and the lights blink rapidly. The bulb appears fine, but the owners manual says that this issue arise
It may be a fan or a power supply issue, as you said.If there is a fan or other cooling device near the bulb, make sure it is operating. If it is not operating, replace it and see if it works. If it is a fan problem, you will notice becau ...
JVC HD-52G786 52" Rear Projection HDTV
I have a Pioneer PDP-R05G media receiver and PDP 435-PG plasma display. After power up the tv turns off after about 2 seconds, and the media receiver green power light flashes 8 times then pauses and cycles again while the Plasma display power light returns red (as if on standby). the unit has not been used for approximately 3 months but was working fine previously.
This is a classic "Hic-upping" switchmode power supply problem. The protection circuitry inside the SMPSU, has sensed a severe potential problem, and is attempting the shutting of the set, down to avoid a fire, explosion, or both. \015\012\015 ...
Pioneer PDP-4360HD 43 in. Plasma Television
Hi, I have Sony Bravia KLV-32S400A Couple of months ago suddenly get switch off after I switch on standby light(Red) gets blink. I unplug the power code and switch on the LCD after 3 hours it works fine. I happens occasionally. Couple of days ago I'm unable to power on the LCD. When I plug the power code I can here a sound like cutout gets on off (tick tick) nothing happens no indicating lights, no display and no sound. Please help me to solve this problem
Dear User,in your case there is a supply fault..capacitor of power board is weak .kindly change the capacitor ..the sign of capacitor faulty is that capacitor is blow up like oil is coming out form upper side..kindly do the need ful.dnt ...
Sony Flat Panel Televisions
My Toshiba Regza AV55 has stopped working completely. After turning it on at the mains there was no power to the tv, i've tried it in various power points and even changed the fuse but there is still not power, no red standby light, nothing.
It was working fine an hour before this and has had no other issues until now.
Toshiba Flat Panel Televisions
Sony KDS-55A2000. bought 1/07. replaced bulb 2/08. gave tv to parents 11/10. worked fine until last week. 1 on screen message, temperature warning (they checked all vents-everything clear and 1' away from wall) then lamp going out message came across. red light blinked 4x and powered off. I ordered new lamp assy came in mail today. parents installed. green light came on then red light blinked 4x-nothing. parents don't have extra income and my financial help is limited. any easy fix solutions????
You will need to check the fans are all switching on when you turn the tv on, it might be one of the fan sensors that has gone bad, the tv wont turn on if it detects that the fans or a single fan is not working. I have not worked on this particular s ...
Sony KDS55A2000 55" HDTV
Vizio e420vse It has worked fine for just short of a month with great picture and sound. Now I moved back to school, plugged it in, and it has worked well for almost a week. This morning when I powered on my tv I received audio but no video picture. Powered on and off multiple times, same thing. Now I just have a short blink of the white indicator light, no display, no sound. It appears to not power on at all. Any advice?
Its the led driver board in upper left corner. Replacement board hard to find ...
Vizio E420VSE 42" 1080p 60Hz LED LCD 2.4" ultra-slim HDTV
My 50PC3D will not start. Worked fine. I heard a pop and it shut down. When i push the power, the green light flashes and i can hear the relays kick, but after about 3 seconds, the green light turns to a steady red. All the caps look fine and the fuses are fine.
Replace the power supply via ebay type in your model in Ebay search bar ...
LG 50PC3D 50 in. Plasma Television
Pioneer monitor pdp 504cmx, 5 years old. working fine then lost picture and got red standby light that blinks, no picture. I have unplugged from power like the manual says but still nothing. When turning on, it goes from green light to red flashing in about 1 second.
Pioneer Flat Panel Televisions
TV was working fine. Shut it off, all power went, no red light or any other sign of power. Will not turn back on, as if no power source. Unplugged for 1 hour, plugged back in again, nothing, uplugged over night, plugged it in, still nothing. Tried other outlets. Checked the safety fuse, it is good. This TV is not over used (2 adults), TV is 2 years old.
Hello,ok you have done almost everything you can do with a no power on Tv problem, if you have the tech background you could try using a volt meter to see if the TVs power supply is getting the power it needs or if there is a lose wire on the p ...
Element Electronics FLX3711B 37 in. LCD TV
I have a Mitsubishi WD-73737 and when I turn on the tv the power light flashes very fast for a minute then stays a steady green and the screen is a solid blue. There is no sound as well. I have tried the system reset and it didn't do anything.
I was given this tv, so I don't know how old it is. The tv will occasionally work but that is very random. The only item I have plugged in is an Xbox 360 with the component cables. The menu button does work so I know the screen still works.
Do you have the input turned on that you use the xbox for? Try different inputs as well. If you are getting the menu to come up, the blue screen is telling you that you don't have a signal being run through that particular input. ...
Power light flashes orange, lamp light solid red.
It starts powering up, the power light flashes yellow for a minute, then green for a minute, then flashes yellow again with the lamp light solid red, before powering down.
The lamp has at least 50% of its life left. I pulled the lamp and made sure the filaments were intact.
Any help would be much appreciated!
I have a Panasonic 32 inch HDTV. TV worked great until one day tried to turn on and nothing. It acts like it has no electrical power. We have tried plugging into different outlets with no luck. The red light does not come up with pressing power. Tried remote as well, nothing. Any ideas?
One simple solution may be to replace the power cable or the power strip that the TV is plugged in to. If you cannot get any power to the TV even after this step, it is most likely a motherboard or some sort of circuitry issue. Make sure you are usin ...
Panasonic Flat Panel Televisions
Tcl Problems Sound working but screen not. Red (power?) light on left bottom not on. Was all working fine earlier today. When we tried to switch back on tonight sound came on but not screen.
It sounds that the main power regulator section circuit has damaged. Contact any service technician. If\012you are not familiar with electronics, do not attempt to repair. Whether you suffer fatal electrical shock!\012Instead, contact any ...
Flat Panel Televisions
My pioneer 504HDG-PDP doesn't turn on . The amp is showing a green light but the plasma panel standby light is flickering red . I have tried turning the tv and all components off . When I try to turn the screen on from the side button it switches off.
Any ideas ? The tv was working fine since this all of a sudden happened. I've checked all connections as well.
Pioneer Flat Panel Televisions
Ive had this tv for a couple of years now and its worked fine up until now, the red light comes on to show there is power but when i try to turn it on, the green light doesnt come on and it shows no sign of actually turning on.
I see so many here with no sound/nopicture issues:ISSUES: 1. IF sound main fuse/s are good.2. If no power or standby check main fuse, standby power supply and any signsof damage you can see---burnt parts etc.3. almost all thes ...
Hitachi Flat Panel Televisions
Sony kdf60xbr950 Having the same problem with no picture. Green lights blinks first then the red lamp light. My first thought is the lamp. Then I had talked to a tech and he tried to tell me that its the balist or the power supply and likley not the bulb? Has anybody else been throught this and what was the outcome. This is the original bulb with only about 1000-1500 hours on it ? was working fine one day and the next this ?
The problem here with the lamp is it has an average 2,000 hour life--only way for a "tech" to know if it is the problem is to replace it.The ballast is the power supply for the lamp---lamp goes bad a lot more often than the ballast= sounds li ...
Sony Grand WEGA KDF-60XS955 60" Rear Projection HDTV
Hey i have a 42 inch phillips plasma tv that blinks a red light 7 times but i have two of these tv's and took out the power supply on the working one and put in the broken one and it still blinks red light 7 times i also put the power board from the broken one to the one that does work and it still worked. so my question is what else could it be?
There three common boards (Powers supply, Y-SUSTAIN, Z-SUSTAIN) that go out, since you have two TV to try out, you should check the Z and Y sustain boards.\012What is the model number?\012Try looking here for free service manuals:\0 ...
Flat Panel Televisions
Up until yesterday my tv worked fine. now when i press power button it only clicks once , it use to click twice, and red light stays on but i get no picture and no sound
This set is prone to only two real issues--one is the Hyper board which will not cause this issue.The other issue is convergence---only way to prove if it is your problem is to gain access to the two STK-392-110 (SHOULD USE THAT) AND unsolde ...
Toshiba 57H82 57" Rear Projection Television
Vpw 425 viewsonic, have owned this Plasma, for several years, has always operated fine. Today it won't turn on. Main power switch is on. Standby switch is red. When I push the standby power button, it changes from red to green, I hear a click, then within 2-3 seconds the standby light turns back to red. I removed the back panel and tried to start again, after several tries there is a red indicator light (inside the panel) labeled "main power" that comes on and stays on.
ViewSonic VPW425 42 in. Plasma HDTV
I have a westinghouse tw-50501-c032a hdtv, it was working fine. unpluged it for twoo weeks. now when pluging it back in, i get a red/bluse power light. it use to be red and turn blue when you turned thr unit on.
Flat Panel Televisions
I Have A .AWA MHDV2411-03 When I Turn On The Mains Power Switch On The Tv - To On . The Red Stanby Led Lights Up As Normal Then I'll Press The Power Button On The Remote The Standby Led Lights Changes From Red To Green As Normal And The Tv Works Fine.When I Switch The Tv Off From The Remote Or The Mains Switch The Tv Switches Off As Normal. Now When I Go To Turn It Back On Again The Green Led Is On All The Time And The Tv Wont Work . When I Leave The Tv Switched Off And Disconected For Sev
Standard (CRT) Televisions
Philips tv model 32pfl5322D/37 when i try to turn it on i get a red light that flashes 6 times.If I keep pushing the power button off and on it will eventually come on. Once its on everything works fine
Philips Flat Panel Televisions
I have a 52HMX84 DLP projection Television. The LED indication is...
Green blinks at 0.3 second intervals - red light solid.
Manual indicates the lamp is not working correctly so I ordered a new one and replaced it. The exact same result.
In the past, the bulbs popped and it was obvious the bulb was used up but in this case both the current bulb and new one look fine. What could it be and is it worth fixing?
Hello,I think this time, your TV is having a power problem.The issue you describe is consistent with a power supply board issue. This is the board where the AC goes to. This problem may have occurred as a result of irregular p ...
Toshiba Projection Televisions