Having problems with your Flat Panel Televisions ?

Need schematic for Samsung PSPF651B01A BOARD yhay is in my Dell W4201C. Need to know what voltages to look for, and where. Will not start up (no Logo Screen when I turn it on). Other site suggest to change out power supply electrolytic capicators



Answers :

Repair Help & Product Troubleshooting for Flat Panel Televisions
You need a second opinion or clarification ? ask it in the comment box OR you can Ask Your Own Question

Tips for a great answer:

  • Please provide as much detail as possible as this will allow our members to better understand and respond to your Comment
  • If you need clarification, ask it in the comment box
  • It's 100% free, no registration required

Suggested Questions/Answers :

It is recommended you read all this kind of situations

Need schematic for Samsung PSPF651B01A BOARD yhay is in my Dell W4201C. Need to know what voltages to look for, and where. Will not start up (no Logo Screen when I turn it on). Other site suggest to change out power supply electrolytic capicators


... Dell W4201C 42 in. Plasma HDTV

Vertical line i own a toshiba tv when powering up only vertical line appearing on the screen, i try to rectify by doing some resoldering on the pcb and replacing the vertical ic ta8403k and several electrolytic capacitors but nothing change,the sound and channels are fine the dc supply for the ic is 25vdc and i think its normal,are their any solutions to rectify this problem on my tv set.i need suggestion thank you


Check the deflection yoke connection cable for any loose contact at its connection socket at main board side. Unplug the connector out from the socket, and re-plug it back for at least tow times. Check the solder terminals of all connections to hor ... Toshiba 32A43 32" TV

I have Sony Bravia KDL 32S3000, I had the power supply board changed. when got it back hooked up TV and turned on, I only have a bright white screen. What needs to be replaced or do i just another TV?


The fact that the screen illuminates properly and does not stay absolutely pitch black means that the backlights are working properly.\015\012\015\012A faulty LCD Controller Board (or TCon board for short) could possibly cause the symptom ... Sony BRAVIA KDL-40V2500 40 in. LCD HDTV

I bought this N2635W it wasnt turning on. (So I thought it was the power supply) I bought a new power supply, and still didnt turn on.( So I thought it is the main control board) I bought a usded controler board, then it just turned by itself and there was only a white screen. No sound no controls responding. ( So i thought it needs a new one). I bought a new controller board from viewsonic,. Now it responds to the power button, I can turn it on and off., but still theres only a white screen


The tv Tuner signal board is the cause and the problems.That the board,where the incomming broadcasting signal cable wire plug into it.Tries websites like Shopjimmy.com,Ebay.com to buy a refurbish tv Tuner signal board for the replacement. ... ViewSonic N2635w 26 in. LCD Television

I have a Sony Bravia KDL52W5100. When I turn on the tv sometimes everything is fine but other times there is no pic only rainbow stripes. I have to turn off and on the tv several times or unplug the tv to get a picture. I have tried rebooting the entire system it worked fine for couple of hours then the problem came back. Sometimes while I am watching a show the screen will gradually change into the rainbow stripe. Do I need to replace my screen and is it worth it?


Check all the flat cable connections from T'Con board to panel, for loose connections. Re-seat them all. ... Sony BRAVIA W-Series KDL-52W5100 52-Inch 1080p 120Hz LCD HDTV

M228WDP-BZ - Pure white screen. Power supply board checked. Voltages through connector to main circuit board OK. Changed main circuit board without any improvement. Need to know the voltges that should be found at the connectors from the power supply board to the screen?


... LG 42LC7D-UB Television

LG 42LK520 LCD TV screen takes 20 minutes to come in clear. During this 20 minutes, top 2 inches of screen works fine, but the rest of the goes black or picture freezes off and on during this time. I was informed the most common problem is bad capacitors on power supply. So I purchased a whole new power supply, and changed it myself! But unfortunately it didn't fix the problem.... Need help please


Is it cable tv ... LG Flat Panel Televisions

I Have a problem w/ my Sharp TV 20V-S200 they appear a video in only a seconds and it fade to blue screen the sounds is ok but the video is the only problem when i always turn on the power it always appear the video in only a seconds and it always turn into blue screen please tell me the parts that i need to change thanks in advance hope someone can tell me the problem


Dear Sir:This a problem with HSYN+VSYN, you must follow the signal, and then the RGC. see the diagramGod bless you ... Flat Panel Televisions

Have Protron PLTV-3250 TV and I was told the power supply board was bad. All indications concluded this was the problem. Replaced the power supply board (FSP194-3F01 power supply) and turned the TV on. It has power, but I have no picture. I can hear the sound from each channel, but that is it. I can change the different sources using the remote control and when I come back to TV, the picture (white fuzz or blue screen) will flash for a moment, then it goes black. If I select a source that


... Spectroniq PLTV3250 32 in. LCD TV

I just purchased my Mitsubishi WD52628 projection television used as it only needed the bulb replaced. I replaced the bulb, however now it will only run for a couple of minutes then the remote and all selection buttons will freeze up and it turns itself off. After turning itself off, the green timer light flashes rapidly. Once it has stopped flashing, I can turn it on again only the problem is the same. I have tried the reset button on the front, no change. Any suggestions?


Factory reset with remote, power up tv immediately enter "MENU 1,2,3" ... Flat Panel Televisions

After punching some of the buttons in the pip row (bottom of the remote control) a message that says "no signal" appeared on the screen and within a few seconds, the tv set turned off. After several seconds, I can again turn on the tv, but before I can attempt to change anything, the "no signal" message appears and the tv turns itself off. Any suggestions???????????


You'll need to do a master reset of the devicecheck link --> www.retrevo.com/support/Vizio-L32-TVs-manual/id/512dj084/t/2 ... Vizio L32 32 in. LCD HDTV

I have a WD 60735 replaced the bulb as the light was red but now my timer light flashes green when you turn the tv on than goes to solid green you can hear the sound, turn that up and down but the screen is all black and you can not change the inputs. The bulb light did come on red once. I have pushed the reset button but still no picture. Any suggestions


... Mitsubishi WD-62525 62" Rear Projection HDTV

When switched on the sound is OK, but on the screen are seen only coloured vertical lines not very bright. Found blown capacitor 2200uF/10v from power supply board +5.4v. Changed it ,but nothing. The inverter is OK. After disconecting CN503 and turning on the TV the screen is dark,the bach lights are on and no vertical lines are seen. This problem ocured when the TV was working and the picture was good.


... Samsung LE27S73 27 in. HDTV-Ready LCD TV

I changed the main board of my sony 46ex620 and now is turning on for 2 seconds and the red light blink 10 times, I need help. I think I need replace the power supply board someone help me please


... Sony Bravia Kdl-46ex620 Internet Tv Compatible Full Motion

No signal message on my 50pc1dra lg plasma with tv on screen. Need to know what to do to turn off. One suggestion was to turn off closed acptioning but its not highlighted for me to do so


... LG 50PC1DRA 50 in. Plasma Television

Hi we have an NEC HDTV Model: NLT-22HDDV4 We had a a blackout yesterday and since then when we turn on the TV we have sound and the menu functions work, however the screen is blank and pure white? Do you have any solution to our problem? Obviously we have checked all the power supplies, plugs, inlets and outlets from the TV but nothing has changed, screen is still white.


NEC "white" screen.Solution: Replace open circuit surface mounted fuse (1.25A) located on LCD panel.Remove cover on back of LCD displayheld by 3 screws.The fuse is located near the socket.Submited by T.Lyras Australia ... NEC Flat Panel Televisions

I got a Sony Bravia KDL-40WL135. Blank screen. There's two LED lights: red standby and green power light. When I turn on the TV, green led comes on, then after about 30 seconds red led blinks once, then green resumes. The green led stays solid. I think that's a SONY error code, I tried to look it up but can't find anything useful. I have replaced the power supply, AU board, backlight inverter, logical board, and the second power supply board. Any suggestions? I haven't checked the t-con bo


Http://www.smpcshop.com/KDL-40WL135-KDL-46WL135-p-8895.html\015\012\015\012\015\012\015\012Above is a link for a service manual.\015\012 ... Flat Panel Televisions

Change power supply,but screen turn on for 1 second then off


You have to enter its service menu option, and make all suggested adjustmens there, after power board replacement. Download its service manual. Not user manual. It will have all service adjustments. ... ViewSonic N3252w 32 in. LCD Television

47mf437b/37 repaired power supply with kit off e-bay now when tv comes on screen flickers for about 20 to 30 minutes and the clears up. If I change channels before it warms up the pictures good for about 3 seconds turn tv off and back on takes about 5 to 7 minutes to clear up


... Insignia 42" LCD Flat-Panel HDTV

I have a Samsung LNS3251DX/XAA and have an intermittant problem with screen going black but audio still on. I turn it off and back on and it works, sometimes a few hours or like today it goes out about every 1-10 minutes! Any suggestions? I tried changing pictiure settings in the menu but to no avail.


It sounds like some connections [flat cable connections] to panel to T'Con board is loose. Check it. ... Flat Panel Televisions

I HAVE A 55LD520 LG LCD TV. I TURN THE TV ON THE LIGHT GOES FROM RED TO GREEN TELLING ME THE TV IS ON BUT NOTHING ON SCREEN AND NO SOUND. I HIT THE MENUE BUTTON AND NOTHING. 8 MONTHS OUT OF WARRANTEE. TOOK THE POWER SUPPLY OUT AND NO VISUABLE DAMAGE ON BOARD. WOULD LIKE TO TRY AND CHANGE SOMETHING DO YOU THINK A NEW BOARD WOULD BE A GOOD TRY?


First of all, I'm so sorry you are in this situation. This is a story I'm hearing all too often. Did you have the set on a surge protector? What you are describing sounds like a main board failure but the set will need to be diagnosed to be sure. Pla ... LG 55LD520 55 in. HD Ready LCD TV

Samsung TV LN40B500P3f - No Picture ; just audio Hello, Our Samsung LN40B500P3f TV display is black; audio works fine. If I turn TV off and then back on the picture does display for a few seconds but then screen goes black and stays that way. Any suggestions as to what needs to be replaced?


... Flat Panel Televisions

Dp46480 46480 was hit by lightning. lost power, and replaced the power supply. it turns on now but the screen goes black after about 15 seconds. any suggestions or help on what i should try to replace next?


... Sanyo Flat Panel Televisions

I have a problem with my PDP42x40000 it is with the power supply card the following components are damaged STR-F6467 capacitor 47u 35v resistor 0.22 ohm and when i changed this component i couldn't have a picture on the screen only the power led is on with red color and when i press on to have a picture it turns to blue color and go to red again i just wan to know what can i do to solve this problem this LG PDP42X40000 is on a SANYO plasma TV


... Flat Panel Televisions

I have a phillips flat screen tv and to repair man say that it needs the power supply board ! the tv does not turn on but when you hit the power button on the remote a red light blinks in front of the tv !


There's a good chance you have failing electrolytic capacitors either in the power section or the inverter section or both.Any caps in these sections that look bulged at the top, or bulged/leaking at the bottom need to be replaced.If you ... Philips 42FD9954 42 in. Plasma HDTV

A detailed question is important to get you a relevant answers

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
all rights reserved to the respective owners || fullblownbass.com || Terms of Use || Contact || Privacy Policy
Load time: 0.2852 seconds